Search results for "MECHANICS"
showing 10 items of 9361 documents
Influence of the irradiation parameters on the molecular modifications of an isotactic polypropylene gamma-irradiated under vacuum
2000
Isotactic polypropylene was irradiated under vacuum in a complete set of experimental conditions. The influence of the irradiation parameters, total absorbed dose, D, and dose rate, I, was analysed in order to verify the theoretical predictions of a simple kinetic model, already presented (Sarcinelli L, Valenza A, Spadaro G. Polymer 1997;38:2307), based on the rates of the main reactions occurring during irradiation, i.e. β-scission, addition to double bonds and termination. The concentration of free radicals and double bonds formed during irradiation is detected together with a comparison to their dependence on the irradiation parameters. A quantitative determination of the “inversion curv…
Solid state NMR - A tool for studying molecular motion in polymers
1986
After an introduction describing the development of 1H, 2H, and 13C solid state NMR two sections on 13C and 2H NMR, respectively, outline the physical background as related with molecular motion. Some representative examples demonstrate the potential of recent NMR techniques in polymer dynamics studies.
New Thermoshrinkable Materials of Radiation Modified Polypropylene-Elastomer Composites with Cross-Linking Agents
2014
In this work, electron beam modified heterogeneous composites of isotactic polypropylene (PP) with chlorinated polyethylene (CPE) have been investigated. The PP/CPE blend composites with an excess of elastomer (30/70 wt%) have been modified with trimethylolpropane triacrylate (TMPTA) and bisphenol-A-dimethacrylate (BPDMA) cross-linking agents and have been irradiated with accelerated electrons up to ionizing radiation doses from 25 to 150 kGy. The internal stresses characterizing the thermoshrinkage properties (TMP) thermorelaxation stresses formed in thermal heating and the residual stresses resulting in the process of full setting and cooling of materials have been investigated for radiat…
Anisotropic Stick-slip friction of highly oriented thin films of poly(tetrafluoroethylene) at the molecular level
1996
Lateral force microscopy (LFM) studies of poly(tetrafluoroethylene) (PTFE) films with molecular resolution are reported. Thin PTFE layers with a high degree of orientation were obtained by pressing and sliding a block of polymer on a clean, heated muscovite mica substrate. LFM nanographs obtained on these films by scanning at directions between ca. 40 and 90° with respect to the film orientation direction, i.e. with respect to the direction of the polymer chains, showed a “stick-slip” type frictional motion of the LFM probe tip at the molecular level. The friction force observed at constant load decreased with decreasing scan angles. Chain-chain packing distances obtained by LFM and contact…
Comparison of Water Adsorption Properties of Cellulose and Cellulose Nanocrystals Studied by Near-Infrared Spectroscopy and Gravimetry
2017
The adsorption properties of water molecules on cellulose and cellulose nanocrystals (CNCs), isolated from defatted rice bran (DRB) by 55% sulfuric acid hydrolysis under sonication were investigated. The powdered samples of cellulose and CNCs were analysed by using near infrared spectroscopy (NIR) and gravimetry at 38% and 55% humidities. Small amounts of samples were dried under vacuum at 120°C and the NIR spectra of the dry samples and their spectra during the adsorption water molecules were measured by using an NIR spectrometer equipped with a transflectance accessory and a DTGS detector. The quantitative adsorption of water molecules by the samples was determined by gravimetry. Second a…
Anomalous Structure and Scaling of Ring Polymer Brushes
2011
A comparative simulation study of polymer brushes formed by grafting at a planar surface either flexible linear polymers (chain length $N_L$) or (non-catenated) ring polymers (chain length $N_R=2 N_L$) is presented. Two distinct off-lattice models are studied, one by Monte Carlo methods, the other by Molecular Dynamics, using a fast implementation on graphics processing units (GPUs). It is shown that the monomer density profiles $\rho(z)$ in the $z$-direction perpendicular to the surface for rings and linear chains are practically identical, $\rho_R(2 N_L, z)=\rho_L(N_L, z)$. The same applies to the pressure, exerted on a piston at hight z, as well. While the gyration radii components of ri…
Translocation dynamics of a short polymer driven by an oscillating force
2013
Under the terms of the Creative Commons Attribution 3.0 Unported License.
Mechanical Properties of Single Molecules and Polymer Aggregates
2013
This chapter deals with the mechanical properties of single polymer chains, aggregates, and supramolecular complexes. The topics discussed cover a broad range from fundamental statistical mechanics of the equilibrium elastic properties of single polymer chains to details of the behavior of binding pockets in biomolecular assemblies as observed by force spectroscopy. The first section treats the equilibrium mechanical properties of single polymer chains in various environments, investigated via extensive simulations employing coarse-grained models that have proven extremely successful in many branches of polymer physics, namely the bond-fluctuation model and the self-avoiding walk model. Apa…
Microscopic verification of dynamic scaling in dilute polymer solutions: A molecular-dynamics simulation
1991
The dynamics of a single polymer chain immersed in a large number of solvent particles is studied by molecular dynamics. This is the first simulation where chain length (30, 40, and 60 monomers) and statistical accuracy are sufficient to test the predictions of the Zimm model as a result of the particle-particle interactions: The short-time diffusion constant is in good agreement with the Kirkwood prediction, and the monomer motions exhibit the expected dynamic scaling. The long-range hydrodynamic interaction requires a data analysis that explicitly includes the periodic images via Ewald sums.
Bending of flexible magnetic rods.
2004
The flexible inextensible magnetic rod model is applied for the study of bending and buckling deformations of the paramagnetic particle chains linked by polymer molecules. It is shown that the existing experimental results can be reasonably well described by this model which takes into account the normal magnetic forces arising at chain bending deformation. By matching the experimentally observed shapes with our numerical simulation results different physical properties of the linked paramagnetic particle chains are determined.