Search results for "MICELLIZATION"
showing 10 items of 16 documents
Thermodynamic properties of N-octyl- and N-dodecylnicotinamide chlorides in water
1990
Densities, heat capacities and enthalpies of dilution at 25°C and osmotic coefficients at 37°C were measured for N-octyl- and N-dodecylnicotinamide chlorides in water over an extended concentration region. Partial molar volumes, heat capacities, relative enthalpies and nonideal free energies and entropies at 25°C were derived as a function of the surfactant concentration. For both surfactants, plots of volumes, enthalpies and free energies vs. concentration are regular whereas those of heat capacities and entropies present anomalies at about 0.8 and 0.1m for the octyl and dodecyl compounds, respectively. Changes in the slope of a plot of osmotic coefficients times molality vs. molality were…
Thermodynamic properties and conductivities of some dodecylsurfactants in water
1988
Densities, heat capacities, enthalpies of dilution, osmotic coefficients and conductivities are reported for dodecylamine hydrochloride, dodecyldimethylammonium and dodecyltrimethylammonium chloride in water over a wide range of concentration. The last two properties were also measured for dodecyltrimethylammonium bromide. From the thermodynamic data partial molar volumes, heat capacities and relative enthalpies and nonideal free energies and entropies were derived as a function of the surfactant concentration. The cmc's and degree of counterion dissociation were also calculated from the transport properties. It is shown that the trends of volumes, enthalpies, free energies and entropies ar…
Thermodynamic Behavior of Non-Ionic Tri-block Copolymers in Water at Three Temperatures
2006
Apparent molar volumes (V Φ) of aqueous solutions of some copolymers, based on ethylene oxide (EO) and propylene oxide (PO) units, were determined as functions of concentration at three temperatures. Viscosity measurements were also carried out on some of these systems. The effects studied include how the molecular architecture and the molecular weight affect the aggregation of the copolymer, keeping constant the EO/PO ratio. Modeling of the volumetric data yielded the partial molar volume of the copolymer in the standard (V°) and the aggregated (V M) states, as well as the equilibrium constant for micellization and the aggregation number. Analysis of the viscosity data supported the insigh…
Effect of Stiffness on the Micellization Behavior of Model H4T4 Surfactant Chains
2006
The micellization behavior of a series of model surfactants, all with four head and tail groups (H4T4) but with different degrees of chain stiffness, was studied using grand canonical Monte Carlo simulations on a cubic lattice. The critical micelle concentration, micellar size, and thermodynamics of micellization were examined. In all cases investigated, the critical micelle concentration was found to increase with increasing temperature as observed for nonionic surfactants in apolar or slightly polar solvents. At a fixed reduced temperature and increasing chain stiffness, in agreement with previous observations, it was found that the critical micelle concentration decreased and the average…
H and 19F NMR Investigation on Mixed Hydrocarbon−Fluorocarbon Micelles
2003
1H and 1 9 F NMR measurements on aqueous solutions of sodium perfluorooctanoate (SPFO) and sodium dodecanoate (SD) mixtures are reported. The surfactant concentration ranged from ∼0.3 to 10 times the critical micelle concentration (cmc ≅ 0.03 mol L - 1 ). The cmc of the SD/SPFO/water mixed system obtained from NMR data was in good agreement with that previously obtained by conductivity measurements. Below the cmc, the experimental chemical shift (δ) was independent of the total concentration for both surfactants. Above the cmc, however, the 6 values for 1 9 F varied linearly with concentration, whereas the values for the hydrogenated surfactant deviated from linearity. These observations in…
Rate-retarding effects of mixed anionic/non-ionic micelles on the alkaline hydrolysis of the chloropentamminocobalt(III) complex - Role of the anioni…
2006
Rate data for the alkaline hydrolysis of the chloropentaamminecobalt(III) cation in the presence of mixed micelles composed of (i) anionic sodium decylsulphate (SDeS) and non-ionic dodecylpenta(oxyethylene glycol) monoether (C12E5) surfactants and (ii) anionic sodium perfluorooctanoate (SPFO) and non-ionic C12E5 surfactants has been obtained at T 298K and constant electrolyte concentration 0.08 mol dm−3 ([NaOH] = 0.01 mol dm−3, [NaClO4] = 0.07 mol dm−3) over a wide range of total surfactant concentration (Ct) and anionic mole fraction (χ). The critical micelle concentrations (c.m.c.s) of the mixed micelles have been determined over the entire χ range by means of surface tension measurements…
Micellization in Model Surfactant Systems
1999
Formation of micelles in model lattice surfactant systems was studied by a novel methodology based on grand-canonical Monte Carlo simulations. The methodology involves combining free-energy information from a series of simulations in small systems by histogram reweighting. The solution osmotic pressure as a function of overall volume fraction of surfactant shows a sharp break at the critical micelle concentration (cmc) at sufficiently low temperatures. Studies in larger systems at appropriate values of the surfactant chemical potential are used to investigate the size distribution of micellar aggregates. The methodology allows for a clear distiction between micellization and macroscopic pha…
Influence of the addition of modifiers on solute-micelle interaction in hybrid micellar liquid chromatography
1998
In reversed-phase micellar liquid chromatography (MLC) organic modifiers are usually added to the mobile phase to modify the eluent strength and to increase the efficiency of the chromatographic peaks. The effect of the modifiers methanol, ethanol, 1-propanol, 1-butanol, 1-pentanol, acetonitrile and tetrahydrofuran on the critical micelle concentration (cmc) of the anionic surfactant sodium dodecylsulphate (SDS) has been studied to enable understanding of the interactions between solute, micelles and bulk liquid in such hybrid eluents. Methanol, acetonitrile and tetrahydrofuran increased thecmc, whereas the other alcohols reduced its value. For butanol and pentanol, which partition into the…
The solubilisation behaviour of some dichloroalkanes in aqueous solutions of PEO-PPO-PEO triblock copolymers: a dynamic light scattering, fluorescenc…
2006
The aggregation behaviour of PEO-PPO-PEO triblock copolymers in water and in water + chlorinated additive mixtures was studied by means of fluorescence spectroscopy, dynamic light scattering (DLS), and small-angle neutron scattering (SANS). The copolymers were chosen such as to investigate the effects of molecular architecture (L35 and 10R5) and molecular weight by keeping constant the hydrophilic/hydrophobic balance (F88 and F108). 1,2-Dichloroethane was used as a prototype of water basins contaminants. The hydrodynamic radius of the block copolymer aggregates (R(h,M)) and the intensity ratio of pyrene of the first and the third vibrational band (I(1)/I(3)) were determined as a function of…
Thermodynamics of transfer of polar additives from the aqueous to the dodecylsurfactant micellar phases
1990
The enthalpies of transfer from water to aqueous surfactant solutions, ΔH(W→W+S), of polar additives have been determined as a function of the surfactant concentration at fixed additive concentration. The surfactants used are sodium dodecylsulfate (NaDS), dodecyltrimethylammonium bromide and dodecyldimethylamine oxide (DDAO). The additives used are iso-butanol t-butanol, butoxyethanol, phenol, benzene, tributylphosphine oxide (TBPO), octyldimethylphosphine oxide (ODPO), octydimethylamine oxide (ODAO), DDAO and NaDS. A maximum was observed in the plots of ΔH(W→W+S) vs. fsms curves for ODPO and ODAO in NaDS while a small minimum was observed for TBPO. The experimental data are rationalized on…