Search results for "MICI"
showing 10 items of 1671 documents
Modelling Turbulent Inter-Phase Drag in Mechanically Stirred Solid-Liquid Suspensions
2012
Power Consumption in Uncovered Unbaffled Stirred Tanks: Influence of the Viscosity and Flow Regime
2013
Notwithstanding the increasing industrial interest toward unbaffled tanks, available experimental information on their behavior is still scant, even for basic quantities such as the mechanical power drawn. In this work, the influence of the Reynolds and Froude numbers on the power consumption characteristics is presented for unbaffled stirred tanks operating both in nonaerated conditions (subcritical regime) and in aerated conditions (supercritical regime), i.e., when the free surface vortex has reached the impeller and the gas phase is ingested and dispersed inside the reactor. Experimental results obtained at various liquid viscosities show that power numbers obtained in subcritical condi…
Dynamic response of equivalent orthotropic plate model for stiffened plate: numerical-experimental assessment
2017
Abstract Over the last two decades, homogenization-based modeling techniques have attracted considerable attention. In fact, through these methods, structures such as corrugated or stiffened plates, commonly referred to as structurally orthotropic plates, can be approximately studied as equivalent flat plates with orthotropic behavior. Specifically, these homogenization techniques allow for the direct determination of the equivalent flexural and torsional rigidities which appear in the governing equation for the deflection of the equivalent orthotropic plate. It is worth noting that, the determined equivalent material properties retain the dependence on the geometric parameters of the origi…
CFD Simulation of Particle Suspension Height in Stirred Vessels
2004
Computational fluid dynamics (CFD) simulation capabilities for stirred solid–liquid dense systems are explored. These systems may give rise to the formation of a thick and well defined clear liquid layer in the upper part of the vessel, whose extension progressively reduces with increasing impeller speed. Experimental measurements of the suspension height (the height of the particle laden layer) were carried out at various agitation speeds for a variety of solid–liquid systems in a fully baffled transparent tank. A clear layer of liquid was actually observed in all runs, with the suspension height almost linearly dependent on agitation speed. CFD simulations of the above described systems w…
Current distribution along electrodialysis stacks and its influence on the current-voltage curve: behaviour from near-zero current to limiting plateau
2023
The current maldistribution along the flow path of electrodialysis (ED) units is a well-known phenomenon. However, it has been poorly quantified via experimental tests so far. This work aimed at measuring the current distribution in an ED stack with 40 cm path length, provided with four-segment electrodes. The current-voltage curve (CVC) of each segment was recorded under several operating conditions of inlet concentrations and feed velocity. In the CVC of the first segment, the current increased approaching a saturation, while in that of the remaining segments it passed through a maximum and then settled at near-zero values when high voltage values were applied. The current fraction on the…
Application of computational fluid dynamics technique in membrane distillation processes
2022
This Chapter illustrates the application of CFD to spacer-filled channels for membrane distillation. The topics discussed cover finite volume grids and grid independence, the unit-cell treatment of spatially periodic net spacers, and the dependence of flow and thermal fields and overall performance parameters (pressure drop and mean heat transfer coefficients) upon geometry and operating conditions (Reynolds number, flow attack angle, pitch-to-height ratio, spacer thermal conductivity, thermal boundary conditions, and one-side vs. two-side heat transfer).