Search results for "MICROSTRUCTURE"
showing 10 items of 707 documents
Sleep phenotypes of intellectual disability: a polysomnographic evaluation in subjects with Down syndrome and Fragile X syndrome
2008
Abstract Objective To analyze sleep architecture and NREM sleep alterations by means of the Cyclic Alternating Pattern (CAP) in children with Down syndrome (DS) and Fragile-X syndrome (fraX), the two most common causes of inherited mental retardation, in order to find out eventual alterations of their sleep microstructure related to their mental retardation phenotypes. Methods Fourteen patients affected by fraX (mean age 13.1 years) and 9 affected by Down syndrome (mean age 13.8 years) and 26 age-matched normal controls were included. All subjects underwent overnight polysomnography in the sleep laboratory, after one adaptation night and their sleep architecture and CAP were visually scored…
The influence of the nature of the surface oxide on the adhesive fracture energy of aluminium-bonded joints as measured by T-peel tests
2008
Abstract Modification of aluminium alloy substrates microstructure and morphology by depositing new oxide layers on top of the metal surface has been investigated, with the aim of improving adhesion. The effect of treating the metal with boiling water or immersing it in a cerate bath has been studied by means of electron microscopy, contact angle measurements and peeling tests. The formation of pseudoboehmite layers or cerium conversion coatings both led to an increase in joint's adhesive fracture energy and more durable adhesive bonds with respect to joints obtained with “mechanically grinded only” substrates. Differences in the performance of the bonded joints has been discussed in terms …
Waveguiding properties of a photonic crystal fiber with a solid core surrounded by four large air holes
2009
The polarization-dependent guiding properties of a hexagonal-lattice photonic crystal fiber with a solid-core surrounded by four large air holes are investigated. The appearance of a polarization dependent cutoff frequency, together with several parameters as the birefringence, the modal effective area, the group velocity dispersion and the polarization dependent loss are analyzed. A collection of fibers with different structural parameters were fabricated and characterized. An effective anti-guide structure from at least 450 nm to 1750 nm, a polarizing fiber with a polarization dependent loss of 16 dB/m at 1550 nm, and an endlessly singlemode polarization-maintaining fiber with group biref…
Management of OH absorption in tellurite optical fibers and related supercontinuum generation
2013
Abstract We report the fabrication and the characterization of low OH content and low loss tellurite optical fibers. The influence of different methods of glass fabrication on fiber losses has been investigated. The use of the purest commercial raw materials can reduce the losses below 0.1 dB/m at 1.55 μm. Incorporation of fluoride ions into the tellurite glass matrix makes the optical fibers transparent up to 4 μm. A suspended core microstructured fiber has been fabricated and pumped by nanojoule-level femtosecond pulses, thus resulting in more than 2000-nm bandwidth supercontinuum after a few centimeters of propagation.
Visible Light Generation and its Influence on Supercontinuum in Chalcogenide As2S3 Microstructured Optical Fiber
2011
We demonstrate visible light generation in chalcogenide As2S3 microstructured optical fiber. The generated visible light causes irreversible damage to the fiber core because of the high absorption coefficient of chalcogenide glasses in the visible band. The SCs (supercontinua) are measured in both untapered and tapered As2S3 fibers, no wider SC is obtained in the tapered one. The SC growth is prevented by the visible light generation since the damage to the fiber core decreases the fiber transmission substantially. This effect can be avoided by designing the fiber to enable the pump source to work in single-mode operation.
Fundamental-mode cutoff in liquid-filled Y-shaped microstructured fibers with Ge-doped core
2008
We report on the cutoff characteristics of a Ge-doped Y-shaped microstructured fiber in which the holes are filled with a liquid of refractive index higher than silica but lower than the Ge-doped core. It is found that the cutoff wavelength was very sensitive to temperature variations as a result of the refractive index changes of the liquid. The basic properties of such a fiber permit the fabrication of wideband tunable short-pass filters, as well as temperature sensors with high sensitivity. A temperature sensitivity of 25 nm/degrees C is reported.
Multioctave midinfrared supercontinuum generation in suspended-core chalcogenide fibers
2014
An As2S3 fiber-based supercontinuum source that covers 3500 nm, extending from near visible to the midinfrared, is successfully reported by using a 200-fs-pulsed pump with nJ-level energy at 2.5 μm. The main features of our fiber-based source are two-fold. On the one hand, a low-loss As2S3 microstructured optical fiber has been fabricated, with typical attenuation below 2 dB/m in the 1-4 μm wavelength range. On the other hand, a 20-mm-long microstructured fiber sample is sufficient to enable a spectral broadening, spreading from 0.6 to 4.1 μm in a 40 dB dynamic range.
Two-core transversally chirped microstructured optical fiber refractive index sensor
2014
We present a sensing architecture consisting of a two-core chirped microstructured optical fiber (MOF) for refractive index sensing of fluids. We show that by introducing a chirp in the hole size, the MOF can be a structure with decoupled cores, forming a Mach-Zehnder interferometer in which the analyte directly modulates the device transmittance by its differential influence on the effective refractive index of each core mode. We show that by filling all fiber holes with analyte, the sensing structure achieves high sensitivity (transmittance changes of 300 per RIU at 1.42) and has the potential for use over a wide range of analyte refractive index.
Microstructured chalcogenide optical fibers from As2S3 glass: towards new IR broadband sources
2010
Made available in DSpace on 2013-08-28T14:12:29Z (GMT). No. of bitstreams: 1 WOS000285749500124.pdf: 1017839 bytes, checksum: f517fd8ef33fd56d66b9ccda9dc4d0f3 (MD5) Made available in DSpace on 2013-09-30T19:22:53Z (GMT). No. of bitstreams: 2 WOS000285749500124.pdf: 1017839 bytes, checksum: f517fd8ef33fd56d66b9ccda9dc4d0f3 (MD5) WOS000285749500124.pdf.txt: 33157 bytes, checksum: 1ca2ac713bf6024674249abf58520bcb (MD5) Previous issue date: 2010-12-06 Submitted by Vitor Silverio Rodrigues (vitorsrodrigues@reitoria.unesp.br) on 2014-05-20T15:34:00Z No. of bitstreams: 2 WOS000285749500124.pdf: 1017839 bytes, checksum: f517fd8ef33fd56d66b9ccda9dc4d0f3 (MD5) WOS000285749500124.pdf.txt: 33157 bytes,…
Strong infrared spectral broadening in low-loss As-S chalcogenide suspended core microstructured optical fibers
2010
Made available in DSpace on 2013-08-28T14:10:10Z (GMT). No. of bitstreams: 1 WOS000275454100017.pdf: 273411 bytes, checksum: da2aeaea61ab57013d39ecf2456466e3 (MD5) Made available in DSpace on 2013-09-30T19:22:36Z (GMT). No. of bitstreams: 2 WOS000275454100017.pdf: 273411 bytes, checksum: da2aeaea61ab57013d39ecf2456466e3 (MD5) WOS000275454100017.pdf.txt: 34647 bytes, checksum: b4efba760b21442eba43e7096f213b3e (MD5) Previous issue date: 2010-03-01 Submitted by Vitor Silverio Rodrigues (vitorsrodrigues@reitoria.unesp.br) on 2014-05-20T15:33:52Z No. of bitstreams: 2 WOS000275454100017.pdf: 273411 bytes, checksum: da2aeaea61ab57013d39ecf2456466e3 (MD5) WOS000275454100017.pdf.txt: 34647 bytes, ch…