Search results for "Mass fraction"

Characterization of the light-absorbing properties, chromophore composition and sources of brown carbon aerosol in Xi'an, northwestern China

2020

The impact of brown carbon aerosol (BrC) on the Earth's radiative forcing balance has been widely recognized but remains uncertain, mainly because the relationships among BrC sources, chromophores and optical properties of aerosol are poorly understood. In this work, the light absorption properties and chromophore composition of BrC were investigated for samples collected in Xi'an, northwestern China, from 2015 to 2016. Both absorption Ångström exponent (AAE) and mass absorption efficiency (MAE) show distinct seasonal differences, which could be attributed to the differences in sources and chromophore composition of BrC. Three groups of light-absorbing organics were found to be important Br…

Organic solvent vapor effects on phase transition of α and β tegafur upon grinding with solvent additives.

2012

Abstract Solvent effects on α tegafur (5-fluoro-1-(tetrahydro-2-furyl)uracil) phase transition to β tegafur during grinding with solvent additive, as well as phase transition in samples exposed to 95% relative solvent vapor pressure has been studied in this research. Samples containing 0.5% and 0.1% of β tegafur in α and β tegafur mixture, as well as samples of pure α tegafur were ground with different solvent additives, and conversion degrees depending on the solvent were determined using PXRD method. Samples with α and β tegafur weight fraction of 1:1 were exposed to 95% relative solvent vapor pressure, and phase transition rates were determined. Solubility of α tegafur, solvent sorption …

NO formation tendency characterization for solid fuels in fluidized beds

2013

Abstract Usually the standard fuel analysis is not enough to allow for accurate NO emission predictions in large scale fluidized bed combustion. This paper presents NO formation tendency characterization results from novel laboratory measurements in a small-scale fluidized bed combustor. With the special two-stage oxidation method it is possible to eliminate the observed problems of unstable test conditions during rapid pyrolysis of high-volatile fuels in batch combustion. Experimental results of the conversion of fuel nitrogen to NO are presented for wide range of fuels, ranging from coal-type fuels to peat, biomasses and wastes. A NO formation tendency database is formed based on the resu…

Behaviour of modified and unmodified polybutadienes in the semidilute regime

1997

Abstract The association behaviour of polybutadiene modified with 4-phenyl-l,2,4-triazoline-3,5-dione was studied in semidilute solution through static (SLS) and dynamic light scattering (DLS). The results were compared with the unmodified polybutadiene, whose behavior in semidilute solution was also studied as function of the molecular weight. At higher concentrations a small-angle excess scattering in SLS and a slow mode motion in DLS were observed both for modified and unmodified polybutadienes suggesting the presence of large clusters. Increasing the polymer concentration, the mass fraction of the slow motion increases up to values near 1, indicating a proximity to the gel point. For po…

Analysis of the intensities of the longitudinal acoustic vibrations inn-alkanes and polyethylene

1980

Simple theoretical considerations indicate, that the integral intensity of the „longitudinal acoustic modes” (LAM) in the Raman spectrum ofn-alkanes should be independent of the chain length. The experiment in fact confirms this expectation. Using this property it becomes possible for polyethylene samples, to derive from the measured LAM-intensity the mass fraction of all-turns sequences contributing to this band. For solution crystallized samples this fraction coincides with the crystallinity, whereas in melt crystallized samples it generally turns out as smaller. The observed difference is likely to be due to the occurrence of local conformational defects (kinks, chain torsions) which int…

H-Point Standard Addition Method Applied to Voltammetry of Microparticles. Quantitation of Dyes in Pictorial Samples

2007

A solid-state electrochemical application of the H-point standard addition method (HPSAM) for quantifying two electroactive compounds, A, B, that produce strongly overlapped voltammetric peaks is described. It is based on peak current measurement in square-wave voltammograms recorded for solid samples containing a reference compound R, upon additions of a A- (or B-) containing standard compound. The method allows to the determination of the mass fraction of A and B by applying the H-point standard addition method to solid state voltammetry. The quotients between the currents measured at two selected potentials and the peak current of R vary linearly with the mass ratio of the added standard…

1984

By means of data from critical demixing and vapour pressure measurements and by inverse gas chromatography, including the results of published light scattering measurments, a consistent picture is obtained for the entire dependence of the Flory-Huggins parameter χ on the weight fraction w2 of the polymer and on the temperature T for the system tert-butyl acetate/polystyrene. Within the entire T-range (ca. 0°C – 140°C), χ increases stronger than exponentially with w2, the rise being the larger the larger χH (the enthalpy contribution to χ) becomes in the limit of infinite dilution. At sufficiently high temperatures (≳ 50°C), χH changes its sign from negative to positive as w2 is raised. This…