Search results for "Microfluidic"

Current trends in affinity-based monoliths in microextraction approaches: A review

2019

Abstract This article reviews the research contributions along the past five years concerning to monolithic materials for the development of affinity-based sorbents in the field of microextraction techniques. The first part of this paper includes an introduction regarding monolithic affinity media and information of different binding agents (such as immunoglobulin-binding proteins, enzymes, lectins, antibodies, aptamers, dyes and immobilized metal ions and nanoparticles, among others) that can act as affinity ligands. Then, the preparation of monoliths and ligand immobilization strategies as well as the different available formats (syringes, pipette tips, spin columns, capillaries, disks an…

ELECTROCHEMICAL CONVERSION OF DICHLOROACETIC ACID TO CHLOROACETIC ACID IN A MICROFLUIDIC STACK AND IN A SERIES OF MICROFLUIDIC REACTORS

2015

The electrochemical conversion of dichloroacetic acid to chloracetic acid was performed in three different micro devices: a simple micro fluidic cell; a microfluidic stack equipped with various electrode chambers in series and three micro fluidic cells in series. The electrochemical synthesis of chloracetic acid was performed successfully with high yields and selectivity under a single-pass mode without supporting electrolyte at low cell voltages. An increase of the productivity and of the final concentration of the target product was achieved by using a stack with two or three electrode chambers in series. The utilization of three micro reactors in series open interesting new perspectives,…

Sample preparation methods for the determination of pesticides in foods using CE-UV/MS.

2010

Much progress has been made in pesticide analysis over the past decade, during this time hyphenated techniques involving highly efficient separation with sensitive detection have become the techniques of choice. Among these, methods based on separation with mass spectrometric detection have resulted in greater likelihood of identification and are acknowledged to be extremely useful and authoritative methods for the determination of pesticide residues but the inherent advantages of the use of CE as a separation technique are well-known and can be summarized as high separation efficiency, low analysis time, high resolution power, and low consumption of samples and reagents. Although UV is the…

M6_Microfluidics_for_CNT

2018

The hydrodynamic trap holds an incoming droplet until the arrival of following droplet. The previous droplet leaves the trap in very rapid manner.

M13_Microfluidics_for_CNT

2018

Compared to pure water, the CNT dispersion has much lower interfacial tension at the dispersion – glass interface due to the presence of SDBS surfactant. Since the behavior of microfluidic system in the confined regime is driven by liquid – solid interfacial tension, the droplet formation and droplet propagation are unstable and unpredictable.

Magnetic particle mixing with magnetic micro-convection for microfluidics

2015

International audience; In this paper we discuss the magnetic micro-convection phenomenon as a tool for mixing enhancement in microfluidics systems in cases when one of the mis-cible fluids is a magnetic particle colloid. A system of a water-based magnetic fluid and water is investigated experimentally under homogeneous magnetic field in a Hele-Shaw cell. Subsequent image analysis both qualitatively and quan-titatively reveals the high enhancement of mixing efficiency provided by this method. The mixing efficiency dependence on the magnetic field and the phys-ical limits is discussed. A suitable model for a continuous-flow microfluidics setup for mixing with magnetic micro-convection is als…

Cylindrical optical microcavities: Basic properties and sensor applications

2011

Abstract A detailed theoretical analysis of the basic properties of whispering-gallery modes (WGM) of thin capillaries is presented. The sensitivity of the resonances, as well as the Q factor is analyzed as a function of the structural parameters of the capillary and the refractive index inside the capillary. A practical application where thin capillaries are used for the measurement of glucose concentration in water is presented as a chemical sensor demonstrator. A best sensitivity of 1.24 nm/% of glucose concentration in water is reported, which corresponds to more than 850 nm/RIU. Additionally, different experimental approaches are discussed to improve the sensitivity and the detection l…

Microfluidic Synthesis of Highly Shape-Anisotropic Particles from Liquid Crystalline Elastomers with Defined Director Field Configurations

2011

In this article, we present the synthesis of highly shape-anisotropic, micrometer-sized particles from liquid crystalline elastomers, which have the ability to reversibly change their shape in response to a certain external stimulus. For their preparation, we utilized a microfluidic setup. We succeeded in preparing sets of particles with differing degrees of shape anisotropy in their ground state including highly anisotropic fiber-like objects. All samples produced movement during the phase transition from the nematic to the isotropic phase of the liquid crystal. Depending on the direction of this shape change, we classified the samples in two groups. One type showed a contraction, while th…

ELECTROSYNTHESIS IN MICROFLUIDIC CELLS: PRELIMINARY INVESTIGATIONS

2013

ELECTROCHEMICAL MICROREACTORS FOR THE ABATEMENT OF ORGANIC POLLUTANTS IN WATER SOLUTION

2015

Electrochemical methods can offer new sustainable routes for the abatement of organic pollutants resistant to biological processes. These methods use a clean reagent, the electron, and very mild operative conditions (ambient temperature and atmospheric pressure) with limited operative costs. However, electrochemical processes present some important disadvantages when performed in conventional reactors. In particular, to achieve reasonable cell voltages when the medium has not an adequate conductivity, one needs adding to the system a supporting electrolyte. This is certainly a main obstacle for a wide application of electrochemical tools. Indeed, adding chemicals is often a problematic issu…