Search results for "Microstructure"

Influence of long-term ageing in solution containing chloride ions on the passivity and the corrosion resistance of duplex stainless steels

2011

Abstract The influence of long-term ageing in NaCl on the passivity and the electrochemical behavior of UNS S32304 is studied. The passive film thickness, the Cr/Fe ratio and the chloride content were significantly increased after ageing. The chloride distribution depends on residual stresses, sample microstructure and surface preparation. Local electrochemical measurements revealed that pitting potentials are between 250–550 mV vs. SCE after electropolishing. The higher the chloride content, the lower the local pitting potential. It was also shown that the presence of chloride was balanced by the enrichment in chromium after ageing. Then no pitting potential could be measured.

Influence of plastic deformation on the microstructure and corrosion behaviour of Ti–10Mo–4Zr and Ti–6Al–4V alloys in the Ringer’s solution at 37°C

2015

Abstract The influence of plastic deformation on the microstructure and passivity of Ti–6Al–4V and Ti–10Mo–4Zr is studied. The content of titanium-based compounds in the passive film formed on the alloys increases under straining. In the region where necking occurs, the β-phase content drops in Ti–6Al–4V. The grain orientation spread increases with increasing strain. The quality index of EBSD maps is affected on Ti–10Mo–4Zr (dislocation structures along preferential orientations). The corrosion behaviour is investigated in the Ringer’s solution (37 °C). Results obtained in the anodic and cathodic domains are discussed considering changes described previously.

Crystalline Microstructure of Corundum Fillers Determined from Powder X-Ray Diffraction Patterns

2016

Li2OSiO2Al2O3MeIIO Glass-Ceramic Systems for Tile Glaze Applications

1991

In order to verify the possibility of using glass-ceramic materials as tile coatings, the devitrification processes of three industrial formulations belonging to the Li2O─Al2O3─SiO2 glass-ceramic system were investigated by differential thermal analysis, X-ray diffractometry, scanning electron microscopy, and IR spectroscopy. Compositional variations were made by addition of large amounts of MgO or CaO or PbO (ZnO) oxides as well as through smaller additions of other oxides. In these systems the surface crystallization contributes appreciably to the bulk crystallization mechanism. All the systems investigated show a high tendency toward crystallization even at very high heating rates, devel…

Microstructural Evolution in Fast-Heated Cordierite-Based Glass-Ceramic Glazes for Ceramic Tile

2004

The crystallization mechanism of α-cordierite from a B 2 O 3 -and TiO 2 -containing glass submitted to fast heating in the cordierite primary phase field of the CaO-MgO-Al 2 O 3 -SiO 2 quaternary system was investigated. Addition of B 2 O 3 to a SiO 2 -rich glass suppressed the formation of μ-cordierite. This suppression facilitated densification by viscous flow before crystallization. Powder X-ray diffractometry, field-emission electron scanning microscopy, and energy-dispersive X-ray analysis revealed that α-cordierite nucleated directly from glass on the boundaries of original particles and was probably favored by TiO 2 , which acted as a nucleant. The growth kinetics of α-cordierite cry…

Effect of MgO/CaO ratio on the microstructure of cordierite-based glass-ceramic glazes for floor tiles

2005

Abstract The effect of the MgO/CaO ratio on the microstructure and microhardness of cordierite-based glass-ceramic glazes was studied. For this purpose glasses, with compositions in the cordierite primary phase field of the CaO–MgO–Al 2 O 3 –SiO 2 quaternary system and, with different MgO/CaO ratios, were prepared by melting. Glass powder pellets pressed under low pressure were fast heated at several temperatures simulating industrial floor-tile processing, and characterized by X-ray powder diffraction (XRD), field emission scanning electron microscopy (FESEM) and energy dispersive X-ray emission spectroscopy (EDX). The studied glasses crystallized α-cordierite as the only crystalline phase…

A grain-scale model for high-cycle fatigue degradation in polycrystalline materials

2018

Abstract A grain-scale three-dimensional model for the analysis of fatigue intergranular degradation in polycrystalline materials is presented. The material microstructure is explicitly represented through Voronoi tessellations, of either convex or non-convex domains, and the mechanics of individual grains is modelled using a boundary integral formulation. The intergranular interfaces degrade under the action of cyclic loads and their behaviour is represented employing a cohesive zone model embodying a local irreversible damage parameter that evolves according to high-cycle continuum damage laws. The model is based on the use of a damage decomposition into static and cyclic contributions, a…

Study of the Hydrogen Embrittlement Sensitivity of an X4CrNiMo 16.5.1 Stainless Steel and the Associated Electron Beam Weld

2015

X4CrNiMo 16.5.1 steel (commercial name APX4) is a low carbon martensitic stainless steel known for its remarkable mechanical characteristics and its good resistance to corrosion. The use of APX4 in the manufacture of high pressure gas vessels requires a thorough understanding of its resistance to Hydrogen Embrittlement (HE) as the gas can contain traces of hydrogen, and martensitic steels, and their welds, are generally very sensitive to HE. This paper deals with the first part of this study, involving the characterization of the microstructure and the mechanical properties of each zone of the electron beam weld (melted zone and four different heat affected zones), and the investigation of …

Compaction of tungsten oxide films by ion-beam irradiation

1993

Abstract Evaporated amorphous tungsten oxide films with low densities, deposited on different substrates, have been irradiated with various types of ions of different energies up to 30 MeV, and with fluences up to 10 18 cm −2 . Compaction of the films up to nearly the bulk density was observed. No changes of the stoichiometry as determined by various ion-beam analysis techniques were detectable. Raman measurements showed that ion-beam-modified films are also amorphous, but have a different microstructure from as-deposited films. The irradiated films have a higher refractive index than the as-deposited films. A low threshold for the compaction effect of a few times 10 12 ions cm −2 was found…

Investigation of the swelling behavior of cationic exchange resins saturated with Na+ ions in a C3S paste

2015

Ion exchange resins (IERs) are widely used by the nuclear industry to decontaminate radioactive effluents. Spent products are usually encapsulated in cementitious materials. However, the solidified waste form can exhibit strong expansion, possibly leading to cracking, if the appropriate binder is not used. In this work, the interactions between cationic resins in the Na+ form and tricalcium silicate are investigated during the early stages of hydration in order to gain a better understanding of the expansion process. It is shown that the IERs exhibit a transient swelling of small magnitude due to the decrease in the osmotic pressure of the external solution. This expansion, which occurs jus…