Search results for "Moisture"

showing 10 items of 290 documents

Impacts of soil moisture content on simulated mesoscale circulations during the summer over eastern Spain

2015

Abstract The Regional Atmospheric Modeling System (RAMS) version 6.0 has been used to investigate the impact and influence of initial soil moisture distributions on mesoscale circulations. To do this, two different events have been selected from the 2011 summer season: one at the beginning of the season (June) and the other one at the end of the season (August). For each of these mesoscale frameworks a total of five distinct simulations were performed varying the initial soil moisture content: a control run and four additional sensitivity tests. The control run, corresponding to a low soil moisture content, is the one used within the real-time weather forecasting system implemented in the V…

HydrologyAtmospheric ScienceLatent heatRegional Atmospheric Modeling SystemMesoscale meteorologyEnvironmental scienceRelative humidityMoisture advectionSensible heatWater contentWind speedAtmospheric Research
researchProduct

Evaluation of the maximum evapotranspiration over the La Mancha region, Spain, using NO A A AVHRR data

1992

Abstract Actual evapotranspiration is an important parameter in crop yield models, soil moisture determination and crop stress detection. As actual evapotranspiration is not routinely available, maximum evapotranspiration (ETJ is normally used in agronomic models to calculate watering needs over irrigated areas. For this reason an empirical method has been developed to obtain ETra from albedo and temperature data suplied by the Advanced Very High Resolution Radiometer (AVHRR) sensor on board NOAA satellites. This model has been applied to the La Mancha region, Spain, where barley, vine and maize are the main crops, and ETM was obtained with an acceptable error of ± 1-4 mm of water per day.

HydrologyCropMoistureAdvanced very-high-resolution radiometerCrop yieldEvapotranspirationGeneral Earth and Planetary SciencesEnvironmental scienceRadiometryAlbedoWater contentInternational Journal of Remote Sensing
researchProduct

Derivation of flood frequency curves in poorly gauged Mediterranean catchments using a simple stochastic hydrological rainfall-runoff model

2007

In this paper a Monte Carlo procedure for deriving frequency distributions of peak flows using a semi-distributed stochastic rainfall-runoff model is presented. The rainfall-runoff model here used is very simple one, with a limited number of parameters and practically does not require any calibration, resulting in a robust tool for those catchments which are partially or poorly gauged. The procedure is based on three modules: a stochastic rainfall generator module, a hydrologic loss module and a flood routing module. In the rainfall generator module the rainfall storm, i.e. the maximum rainfall depth for a fixed duration, is assumed to follow the two components extreme value (TCEV) distribu…

HydrologyFlood mythStochastic modellingfllod frequency curves rainfall-runoff modelMonte Carlo methodSettore ICAR/02 - Costruzioni Idrauliche E Marittime E IdrologiaAntecedent moistureSoil scienceRunoff modelEnvironmental scienceFrequency distributionExtreme value theorySurface runoffWater Science and Technology
researchProduct

Modeling of Water Distribution under Center Pivot Irrigation Technique

2021

AbstractAiming to quantify the impacts of the center pivot irrigation technique on soil moisture dynamics and to improve irrigation crop water needs, a mathematical model was developed to estimate ...

HydrologyIrrigationBallistic modelbusiness.industrySprinklerDistribution (economics)04 agricultural and veterinary sciencesAgricultural and Biological Sciences (miscellaneous)Center pivot irrigationCenter pivot040103 agronomy & agriculture0401 agriculture forestry and fisheriesEnvironmental scienceWater distribution patternSoil moisturebusinessWater contentWater Science and TechnologyCivil and Structural Engineering
researchProduct

Detecting crop water status in mature olive orchards using vegetation spectral measurements.

2014

Full spectral measurements (350–2500 nm) at tree canopy and leaf levels and the corresponding leaf water potentials (LWP) were acquired in an olive grove of Sicily, at different hours of the day, during summer season 2011. The main objective of the work was to assess, on the basis of the experimental data-set, two different approaches to detect crop water status in terms of LWP. Specifically, using existing families of Vegetation Indices (VIs) and applying Partial Least Squares Regression (PLSR) were optimised and tested. The results indicated that a satisfactory estimation of LWP at tree canopy and leaf levels can be obtained using vegetation indices based on the near infrared–shortwave in…

HydrologyLeaf Water PotentialTree canopySpectral indexMean squared errorMoistureSoil ScienceCrop Water StatuVegetationCropSpectroradiometerControl and Systems EngineeringPartial least squares regressionSettore AGR/08 - Idraulica Agraria E Sistemazioni Idraulico-ForestaliLeaf water potential; Olive tree; Field SpectroscopyAgronomy and Crop ScienceOlive treeSpectroscopyField SpectroscopyFood ScienceRemote sensingMathematics
researchProduct

Exploiting the topographic information in a PDM-based conceptual hydrological model

2014

In this work, a conceptual lumped model was developed to simulate runoff and analyze hydrological processes with the goal of incorporating the morphological information into a probability-distributed model (PDM). PDMs usually describe the process of runoff generation as the result of soil saturation excess caused by precipitation with soil storage capacity represented by a spatially distributed quantity and described by a probability distribution. The proposed model, called topography-based probability distributed model (TOPDM), based on a simple water balance whose components are basin soil moisture storage, precipitation, drainage to groundwater, evapotranspiration, and Dunnian and Horton…

HydrologyPhysical modelLumped model2300Distributed element modelHydrological modellingSettore ICAR/02 - Costruzioni Idrauliche E Marittime E IdrologiaSoil scienceRunoff curve numberRunoff modelProbability-distributed model (PDM)Water balanceWetness indexEvapotranspirationEnvironmental scienceEnvironmental ChemistrySoil moistureSurface runoffGeneral Environmental ScienceWater Science and TechnologyCivil and Structural Engineering
researchProduct

A conceptual dynamic vegetation-soil model for arid and semiarid zones

2007

Plant ecosystems in arid and semiarid zones show high complexity from the point of view of water resources, since they depend on water availability to carry out their vital processes. In these climates, water stress is the main factor controlling vegetation development. The available water in the system results from a water balance where the soil, vegetation and the atmosphere are the key issues; but it is the vegetation which modulates (to a great extent) the total balance of water and the mechanisms of the feedback between soil and atmosphere, being the knowledge about soil moisture quite relevant for assessing available water and, as a consequence, for growth and plants maintenance and t…

Hydrologylcsh:GE1-350Moisturelcsh:T[SDU.OCEAN] Sciences of the Universe [physics]/Ocean Atmospherelcsh:Geography. Anthropology. RecreationVegetationAridlcsh:Technologylcsh:TD1-1066[SDU.ENVI] Sciences of the Universe [physics]/Continental interfaces environmentWater balancelcsh:GEvapotranspirationSoil water[SDU.STU] Sciences of the Universe [physics]/Earth SciencesEnvironmental sciencelcsh:Environmental technology. Sanitary engineeringWater contentlcsh:Environmental sciencesTranspiration
researchProduct

Optimization of image parameters using a hyperspectral library application to soil identification and moisture estimation

2009

The growing number of sensors raises questions about the image parameters required for the application, soil identification and moisture estimation. Hyperspectral images are also known to contain highly redundant information. Hence not all the spectral bands are needed for the satisfactory classification of the soil types. Hence, the work was aimed at obtaining these optimal spectral bands for identifying the soil types and to use these spectral bands to estimate the moisture content of the soils using the method proposed by Whiting et.al.

Identification (information)MoistureSoil waterEnvironmental scienceHyperspectral imagingFeature selectionSoil classificationSpectral bandsWater contentPhysics::GeophysicsRemote sensing2009 IEEE International Geoscience and Remote Sensing Symposium
researchProduct

An assessment of the differences between spatial resolution and grid size for the SMAP enhanced soil moisture product over homogeneous sites

2018

Abstract Satellite-based passive microwave remote sensing typically involves a scanning antenna that makes measurements at irregularly spaced locations. These locations can change on a day to day basis. Soil moisture products derived from satellite-based passive microwave remote sensing are usually resampled to a fixed Earth grid that facilitates their use in applications. In many cases the grid size is finer than the actual spatial resolution of the observation, and often this difference is not well understood by the user. Here, this issue was examined for the Soil Moisture Active Passive (SMAP) enhanced version of the passive-based soil moisture product, which has a grid size of 9-km and …

In situSpatial resolution010504 meteorology & atmospheric sciencesResolution (electron density)0211 other engineering and technologiesSoil ScienceGeology02 engineering and technologySMAPGrid01 natural sciencesIn situITC-ISI-JOURNAL-ARTICLE2023 OA procedureEnvironmental scienceSatelliteSoil moistureComputers in Earth SciencesAntenna (radio)Water contentImage resolutionScaling021101 geological & geomatics engineering0105 earth and related environmental sciencesRemote sensingRemote sensing of environment
researchProduct

Comparative Assessment of Mould Growth Risk in Lightweight Insulating Assemblies Via Analysis of Hygrothermal Data and In Situ Evaluation

2019

In order to assess the sustainability of buildings with different types of insulating assemblies in the Latvian climate, a long-term test building monitoring experiment has been underway since 2013. There are a total of five test buildings on site with roughly six years’ worth of accumulated temperature and humidity readings in the key parts of assemblies. This study is meant to quantify the mould presence in building walls, floor and ceiling by performing laboratory tests, assessing the number of colony-forming units, and comparing the results with mould risk predictions due to the isopleth model developed by Sedlbauer, using both the hygrothermal data derived from the sensors within build…

In situlcsh:GE1-350Materials scienceMoisturewuficomparisonslcsh:TD1-1066moisturemould riskComposite materiallcsh:Environmental technology. Sanitary engineeringbuilding constructionsEcology Evolution Behavior and Systematicslcsh:Environmental sciencesGeneral Environmental ScienceJournal of Ecological Engineering
researchProduct