Search results for "Multipath routing"
showing 10 items of 24 documents
Cost-Efficient On-Chip Routing Implementations for CMP and MPSoC Systems
2011
[EN] The high-performance computing domain is enriching with the inclusion of networks-on-chip (NoCs) as a key component of many-core (CMPs or MPSoCs) architectures. NoCs face the communication scalability challenge while meeting tight power, area, and latency constraints. Designers must address new challenges that were not present before. Defective components, the enhancement of application-level parallelism, or power-aware techniques may break topology regularity, thus, efficient routing becomes a challenge. This paper presents universal logic-based distributed routing (uLBDR), an efficient logic-based mechanism that adapts to any irregular topology derived from 2-D meshes, instead of usi…
Power-constrained sensor selection and routing for cooperative detection in cognitive radios
2012
Given a spectrum-sensing network, a set of active nodes jointly aggregate sensed data at a preset frequency-band and simultaneously route this information to an arbitrarily chosen querying node through a power-constrained multi-hop path. Locally, each sensor node is assumed to be an energy-based detector. This work focuses on deriving algorithms that jointly optimize sensor selection and cooperative detection from which a power-efficient route to the querying node can be established, and then, a tree routing structure spanning the chosen nodes is constructed under a power budget constraint. Sensor information is sequentially aggregated along this optimized routing structure up to the queryi…
Distributed routing and channel allocation in multi-channel multi-hop ad hoc networks
2013
In this paper, we propose a novel routing protocol which is integrated with channel assignment for multi-channel multi-hop wireless ad hoc networks. In such a network, each node is equipped with three transceivers. One is always tuned on a control channel which is responsible for control and broadcast messages, and the other two perform as transmitter and receiver respectively for traffic flows on different data channels. The routing protocol works in an on-demand manner, and the proposed routing discovery process selects a path that potentially traverses nodes with lighter traffic load and lower number of carried flows. With a given number of non-overlapping channels, the optimal solution …
A combined relay-selection and routing protocol for cooperative wireless sensor networks
2012
International audience; In wireless sensor networks several constraints decrease communications performances. In fact, channel randomness and energy restrictions make classical routing protocols inefficient. Therefore, the design of new routing protocols that cope with these constraints become mandatory. The main objective of this paper is to present a multi-objective routing algorithm RBCR that computes routing path based on the energy consumption and channel qualities. Additionally, the channel qualities are evaluated based on the presence of relay nodes. Compared to AODV and AODV associated to a cooperative MAC protocol, RBCR provides better performances in term of delivery ratio, power …
Distance Constrained Mapping to Support NoC Platforms Based on Source Routing
2010
Efficient NoC is crucial for communication among processing elements in a highly parallel processing systems on chip. Mapping cores to slots in a NoC platform and designing efficient routing algorithms are two key problems in NoC design. Source routing offers major advantages over distributed routing especially for regular topology NoC platforms. But it suffers from a serious drawback of overhead since it requires whole communication path to be stored in every packet header. In this paper, we present a core mapping technique which helps to achieve a mapping with the constraint over the path length. We have found that the path length constraint of just 50% is sufficient in most cases. We als…
A Network Protocol to Enhance Robustness in Tree-Based WSNs Using Data Aggregation
2007
This paper proposes a data gathering strategy for wireless sensor networks and an implementation based on the IEEE 802.15.4 standard. The algorithm combines the benefits of single-path and multi-path routing strategies in a hybrid solution which makes use of alternative paths when necessary. We adopt a caching and retransmission technique, which exploits some peculiar features of data aggregation, with the use of implicit acknowledgments of reception. The paper also discusses simulation results that show how the mentioned techniques, combined with exploitation of the features of the IEEE 802.15.4 standard have been used to obtain an efficient protocol that takes energy consumption into acco…
Accurate reliability and availability models for direct interconnection networks
2001
Fault tolerance in multicomputer interconnection networks has been traditionally studied by determining the worst possible combination of faulty components that causes its failure and then assuming that this will occur. But, the probability of the worst possible combination is usually low, and the routing algorithm may be able to find a route between source and destination nodes. The network dependability parameters computed according to this approach will be underestimated. In this paper we propose a methodology for accurately evaluating interconnection network dependability. In addition, we apply it to obtain an accurate estimation of the reliability and availability parameters in a 2-D m…
QoS Based Routing Protocol for Intra-Mesh Infrastructure Communications
2015
International audience; Mesh Networks (WMNs) have been considered as a promising alternative to conventional wired networks, thanks to its flexibility and easy deployment. Thus, to ensure a satisfying level of QoS guarantees for real-time and streaming applications such as Voice over IP (VoIP) and Video on Demand (VoD), we propose a novel QoS based routing protocol for wireless mesh environments, called Hybrid QoS Mesh Routing (HQMR), jointly with a clustering algorithm to enhance scalability issues within the mesh infrastructure. HQMR is composed of two routing sub-protocols: a reactive routing sub-protocol for intra-infrastructure communications and a proactive QoS based multi-tree routin…
Self-configuring multipath intra-mesh infrastructure QoS based routing
2016
International audience; Multi-path routing concept was largely exploited in wireless networks to provide benefits such as fault tolerance, load balancing, performance improvement in terms of latency, etc. In this paper, we propose a multi-path routing based protocol named MP-IMRR (Multi-path Intra-Mesh infrastructure Routing protocol) to improve our previously defined QoS based routing protocol for wireless mesh networks (i.e. IMRR). MP-IMRR is defined in order to achieve better reactivity and faster recovery from eventual route failures than the IMRR protocol by adopting the backup routes concept. Besides, given the complexity increase while considering network management systems, we adopt…
A secure intersection-based routing protocol for data collection in urban vehicular networks
2014
Data routing has gained great intention since the appearance of Vehicular Networks (VANETs). However, in the presence of attackers, reliable and trustworthy operations in such networks become impossible without securing routing protocols. In this paper, we target to study and design a secure routing protocol S-GyTAR for vehicular environments. Several kinds of routing techniques are proposed in the literature and could be classified into topology-based or position-based strategies. Position-based is the most investigated strategy in vehicular networks due to the unique characteristics of such networks. For this reason, this work is based on the well-known intersection-based routing protocol…