Search results for "NEWA"
showing 10 items of 2491 documents
Highly Active and Stable NiCuMo Electrocatalyst Supported on 304 Stainless Steel Porous Transport Layer for Hydrogen Evolution in Alkaline Water Elec…
2023
Several functionalized porous transport layers with Pt-free electrocatalysts for hydrogen evolution reaction in alkaline conditions, based on Ni, Cu, and Mo, are prepared through electrodeposition onto a 304 stainless steel mesh. Morphological characterization confirms the fabrication of electrodes with high electrochemical surface active area due to the formation of hierarchical nanostructures. Mo presence into the electrocatalysts increases the activity toward the hydrogen evolution reaction. The optimization of electrodeposition process leads to the preparation of highly active NiCuMo electrocatalyst that exhibits near zero onset overpotential and overpotentials of 15 and 113 mV at 10 an…
Activated carbon from hydrolysis lignin: Effect of activation method on carbon properties
2022
This study presents the effects of different activation methods to produce activated carbon from the hydrolysis lignin. Pretreatment of the feedstock with common mineral acids (HCL, HNO3, and H3PO4), different steam rates for physical activation, and different chemical activating agents (ZnCl2, Na2CO3, and KOH) for chemical activation were investigated. The pretreated biomass was carbonized and activated in one-stage process and the surface characteristics, such as total pore volume, pore size distribution and specific surface area, were investigated. The results showed that the activated carbon surface properties were not greatly affected by acid pretreatment. Brunauer-Emmett-Teller (BET) …
Rapid one-step solvent-free acid-catalyzed mechanical depolymerization of pine sawdust to high-yield water-soluble sugars
2017
Abstract One-step absolute solvent-free acid-catalyzed mechanical depolymerization of pine sawdust (PSD) and commercially available α-cellulose to water-soluble sugars was carried out using ball milling. For comparison purposes, the commonly reported “solvent-free” mechanocatalytic depolymerization of lignocellulose method, which normally involves three steps (acid impregnation in solvent, vacuum drying, and mechanical depolymerization of lignocellulose), was performed. The 3,5-dinitrosalicylic acid (DNS) method was used to measure the total reducing sugar (TRS) of the obtained sugar solution, and major monosaccharides in the solution were analyzed by capillary electrophoresis (CE). More th…
Anomalous electrical parameters improvement in Ruthenium DSSC
2018
. In this work, we present a series of measurements carried out on Ruthenium-based Dye Sensitized Solar Cells (DSSCs) after the application of different external electrical field values. Such measurements have been performed both in the dark and by illuminating the sample with sunlight emitted by a solar simulator (AM1.5G spectrum with a power irradiance of 1000 W/m2). Our results demonstrate that the initial electrical bias field modifies in both cases the behavior of the cell in terms of an anomalous improvement of the main electrical parameters.
Anomalous performance enhancement effects in Ruthenium-based Dye Sensitized Solar Cells
2017
Dye Sensitized Solar Cells (DSSCs) are nowadays more and more employed since they present lower production costs than traditional silicon photovoltaic devices. An interesting phenomenon affecting such devices consists in the fact that current density-voltage (J-V) characteristic can depend on the history of the cell prior to the measurement, which often can be assimilated to an anomalous hysteresis effect. In this work, we study such phenomenon on Ruthenium-based DSSCs through a series of measurements performed after applying different values of external electrical field to the cell. The measurements have been carried out both under simulated sunlight (AM1.5G - 1000 W/m2) and in the dark. W…
Daytime sensible heat flux estimation over heterogeneous surfaces using multitemporal land‐surface temperature observations
2016
Equations based on surface renewal (SR) analysis to estimate the sensible heat flux (H) require as input the mean ramp amplitude and period observed in the ramp‐like pattern of the air temperature measured at high frequency. A SR‐based method to estimate sensible heat flux (HSR‐LST) requiring only low‐frequency measurements of the air temperature, horizontal mean wind speed, and land‐surface temperature as input was derived and tested under unstable conditions over a heterogeneous canopy (olive grove). HSR‐LST assumes that the mean ramp amplitude can be inferred from the difference between land‐surface temperature and mean air temperature through a linear relationship and that the ramp freq…
A new application for nickel foam in alkaline fuel cells
2009
The use of nickel foam as an electrode substrate in alkaline fuel cells (AFCs) has been investigated for bi-polar cells incorporating an electrically conducting gas diffusion layer. This contribution focuses on the cathode, and draws comparisons between nickel foam and nickel mesh substrates. One of the principal electrocatalysts for the cathodic reduction of oxygen is silver, so an improvement in electrochemical performance was obtained by electroplating the nickel foam with silver. The electrodeposition process was optimised to maximise electrochemical performance with a minimum of silver deposited. Nickel foam, which is less expensive than the usual nickel mesh, appears to be a good subs…
Ammonium adsorption, desorption and recovery by acid and alkaline treated zeolite
2021
In this study, the suitability of zeolite as a possible medium for ammonium adsorption, desorption and recovery from wastewater was investigated. Specifically, batch adsorption and desorption studies with solutions enriched in NH$_4^+$ were conducted employing zeolite to evaluate how the chemical treatment and contact time affect adsorption and desorption. Several experimental tests were carried out considering both untreated and treated zeolite. Untreated and HCl-Na treated zeolite adsorbed up to 11.8 mg NH$_4^+$ g$^{-1}$ and showed the highest efficiency in recovering NH$_4^+$ from aqueous solution. Regardless of pre-treatment, treatments with NaCl resulted in higher and faster adsorption…
Solvothermal Synthesis of Molybdenum–Tungsten Oxides and Their Application for Photoelectrochemical Water Splitting
2018
Molybdenum and tungsten oxides are of interest as semiconductors for the production of clean and sustainable energy. Here we show that synergistic effects arising from a combination of noncrystalli...
Nitrous oxide emissions in a membrane bioreactor treating saline wastewater contaminated by hydrocarbons
2016
The joint effect of wastewater salinity and hydrocarbons on nitrous oxide emission was investigated. The membrane bioreactor pilot plant was operated with two phases: i. biomass acclimation by increasing salinity from 10 gNaCl L−1 to 20 gNaCl L−1 (Phase I); ii. hydrocarbons dosing at 20 mg L−1 with a constant salt concentration of 20 gNaCl L−1 (Phase II). The Phase I revealed a relationship between nitrous oxide emissions and salinity. During the end of the Phase I, the activity of nitrifiers started to recover, indicating a partial acclimatization. During the Phase II, the hydrocarbon shock induced a temporary inhibition of the biomass with the suppression of nitrous oxide emissions. The r…