Search results for "Neutron source"
showing 10 items of 53 documents
Measurement of fission yields and isomeric yield ratios at IGISOL
2018
Data on fission yields and isomeric yield ratios (IYR) are tools to study the fission process, in particular the generation of angular momentum. We use the IGISOL facility with the Penning trap JYFLTRAP in Jyväskylä, Finland, for such measurements on 232Th and natU targets. Previously published fission yield data from IGISOL concern the 232Th(p,f) and 238U(p,f) reactions at 25 and 50 MeV. Recently, a neutron source, using the Be(p,n) reaction, has been developed, installed and tested. We summarize the results for (p,f) focusing on the first measurement of IYR by direct ion counting. We also present first results for IYR and relative yields for Sn and Sb isotopes in the 128-133 mass range fr…
Characterization of a Be(p,xn) Neutron Source for Fission Yields Measurements
2013
We report on measurements performed at The Svedberg Laboratory (TSL) to characterize a proton-neutron converter for independent fission yield studies at the IGISOL-JYFLTRAP facility (Jyv\"askyl\"a, Finland). A 30 MeV proton beam impinged on a 5 mm water-cooled Beryllium target. Two independent experimental techniques have been used to measure the neutron spectrum: a Time of Flight (TOF) system used to estimate the high-energy contribution, and a Bonner Sphere Spectrometer able to provide precise results from thermal energies up to 20 MeV. An overlap between the energy regions covered by the two systems will permit a cross-check of the results from the different techniques. In this paper, th…
A study of the potential influence of frame coolant on HCLL-TBM nuclear response
2007
Abstract Within the European Fusion Technology Programme, the Helium-Cooled Lithium Lead (HCLL) breeding blanket concept is one of the two EU lines to be developed for a long term fusion reactor, in particular with the aim of manufacturing a test blanket module (TBM) to be implemented in ITER. The HCLL-TBM is foreseen to be located in an ITER equatorial port, being housed inside a steel-supporting frame, actively cooled by pressurized water. This supporting frame has been designed to house two different TBMs providing two cavities separated by a dividing plate 20 cm thick. As the nuclear response of HCLL-TBM could vary with the supporting frame configuration and composition, a parametric st…
MONSTER: a time of flight spectrometer for β-delayed neutron emission measurements
2012
The knowledge of the β-decay properties of nuclei contributes decisively to our understanding of nuclear phenomena: the β-delayed neutron emission of neutron rich nuclei plays an important role in the nucleosynthesis r-process and constitutes a probe for nuclear structure of very neutron rich nuclei providing information about the high energy part of the full beta strength (Sβ) function. In addition, β-delayed neutrons are essential for the control and safety of nuclear reactors. In order to determine the neutron energy spectra and emission probabilities from neutron precursors a MOdular Neutron time-of-flight SpectromeTER (MONSTER) has been proposed for the DESPEC experiment at the future …
Neutron generator for BNCT based on high current ECR ion source with gyrotron plasma heating
2015
BNCT development nowadays is constrained by a progress in neutron sources design. Creation of a cheap and compact intense neutron source would significantly simplify trial treatments avoiding use of expensive and complicated nuclear reactors and accelerators. D-D or D-T neutron generator is one of alternative types of such sources for. A so-called high current quasi-gasdynamic ECR ion source with plasma heating by millimeter wave gyrotron radiation is suggested to be used in a scheme of D-D neutron generator in the present work. Ion source of that type was developed in the Institute of Applied Physics of Russian Academy of Sciences (Nizhny Novgorod, Russia). It can produce deuteron ion beam…
Helium burning of22Ne
1989
The22Ne(α, γ)26Mg and22Ne(α, n)25Mg reactions were investigated forE α(lab) from 0.71 to 2.25 MeV. Neon gas enriched to 99% in22Ne was recirculated in a differentially pumped gas target system of the extended type. Theγ-ray transitions were observed with Ge(Li) detectors and the neutrons with3He ionization chambers. A previously known resonance at ER(lab)=2.05 MeV was verified and 15 new resonances were found in the energy range covered, with the lowest at ER(lab)=0.83 MeV. Information on resonance energies, widths, strengths,γ-ray branching ratios, as well asJ π assignments, is reported. The energy range investigated corresponds to the important temperature range ofT 9 from 0.3 to 1.4 (109…
Probing neutrino magnetic moments at the Spallation Neutron Source facility
2015
24 pages.- 8 figures
Production and characterization of a custom-made 228Th source with reduced neutron source strength for the Borexino experiment
2012
A custom-made 228Th source of several MBq activity was produced for the Borexino experiment for studying the external background of the detector. The aim was to reduce the unwanted neutron emission produced via (alpha,n) reactions in ceramics used typically for commercial 228Th sources. For this purpose a ThCl4 solution was converted chemically into ThO2 and embedded into a gold foil. The paper describes the production and the characterization of the custom-made source by means of gamma-activity, dose rate and neutron source strength measurements. From gamma-spectroscopic measurements it was deduced that the activity transfer from the initial solution to the final source was >91% (at 68%…
Transmission of very slow neutrons through material foils and its influence on the design of ultracold neutron sources
2009
At the Paul Scherrer Institute (PSI), a very intense source of ultracold neutrons (UCN) is being built. The UCN converter of solid deuterium must be contained in a vessel. Produced UCN leave that vessel through its top lid. To decide on the design of the vessel and the top lid, we have measured the transmission of neutrons with velocities between 3 and 20 m/s through different material foils. Contrary to expectations, we found that transmission through aluminium and aluminium alloys is equal or even higher compared to zirconium and reactor-grade zirconium alloys, respectively.
Accurate Fission Data for Nuclear Safety
2013
The Accurate fission data for nuclear safety (AlFONS) project aims at high precision measurements of fission yields, using the renewed IGISOL mass separator facility in combination with a new high current light ion cyclotron at the University of Jyvaskyla. The 30 MeV proton beam will be used to create fast and thermal neutron spectra for the study of neutron induced fission yields. Thanks to a series of mass separating elements, culminating with the JYFLTRAP Penning trap, it is possible to achieve a mass resolving power in the order of a few hundred thousands. In this paper we present the experimental setup and the design of a neutron converter target for IGISOL. The goal is to have a flexi…