Search results for "Noise level"
showing 10 items of 30 documents
Auto-Adaptive Trigger and Pulse Extraction for Digital Processing in Nuclear Instrumentation
2015
International audience; This paper presents a novel auto-adaptive method for pulse triggering and extraction. Pulse triggering uses a threshold that must be placed as close as possible to the noise level. We do this by means of an adaptive threshold level based on real-time noise level estimation. A dynamic estimation of the pulse length is also used for pulse selection. The proposed approach is largely insensitive to noise and enables autonomous extraction of pulses regardless of their shape, height or length. The proposed approach can be used with numerous types of detectors from an analog-to-digital converter, and can be used in conjunction with various pulse processing techniques such a…
AMADEUS-The acoustic neutrino detection test system of the ANTARES deep-sea neutrino telescope
2011
The AMADEUS (ANTARES Modules for the Acoustic Detection Under the Sea) system which is described in this article aims at the investigation of techniques for acoustic detection of neutrinos in the deep sea. It is integrated into the ANTARES neutrino telescope in the Mediterranean Sea. Its acoustic sensors, installed at water depths between 2050 and 2300 m, employ piezo-electric elements for the broad-band recording of signals with frequencies ranging up to 125 kHz. The typical sensitivity of the sensors is around - 145 dB re 1 V/mu Pa (including preamplifier). Completed in May 2008, AMADEUS consists of six "acoustic clusters", each comprising six acoustic sensors that are arranged at distanc…
Stochastic resonance in a tunnel diode.
1994
We study stochastic resonance in a fast bistable electronic system: a tunnel diode. We investigate the phenomenon in a higher frequency regime than that studied in previous experiments. Detailed measurements of the output signal are reported for two values of the frequency of the periodic signal: ${\mathit{f}}_{\mathit{s}}$=1 kHz and ${\mathit{f}}_{\mathit{s}}$=10 kHz. We observe, in one case (${\mathit{f}}_{\mathit{s}}$=1 kHz), a nonmonotonic behavior characterized by a sharp dip in the output noise level measured at the frequency of the driving signal.
Effect of boat noise on the behaviour of bluefin tuna Thunnus thynnus in the Mediterranean Sea
2007
The effect of boat noise on the behaviour of bluefin tuna Thunnus thynnus was investi- gated in the Egadi Islands, Sicily, during spring 2005 using a fixed tuna trap set near shipping routes. Tuna behaviour was observed when exposed to both natural ambient sound and sound generated by hydrofoil passenger ferries, small boats and large car ferries. Acoustical and behavioural analyses were conducted with and without extraneous sound to define a list of behavioural categories. Each vessel produced different engine sounds with regard to their composition and bandwidth, and all were distinctly different from ambient sound levels. In the absence of boat noise, tuna assumed a con- centrated coordi…
Background studies for acoustic neutrino detection at the South Pole
2011
The detection of acoustic signals from ultra-high energy neutrino interactions is a promising method to measure the tiny flux of cosmogenic neutrinos expected on Earth. The energy threshold for this process depends strongly on the absolute noise level in the target material. The South Pole Acoustic Test Setup (SPATS), deployed in the upper part of four boreholes of the IceCube Neutrino Observatory, has monitored the noise in Antarctic ice at the geographic South Pole for more than two years down to 500 m depth. The noise is very stable and Gaussian distributed. Lacking an in-situ calibration up to now, laboratory measurements have been used to estimate the absolute noise level in the 10 to …
STUDY ON NOISE LEVEL GENERATED BY HUMAN ACTIVITIES IN SIBIU CITY, ROMANIA
2014
In this paper I have proposed an analysis and monitoring of the noise sources in the open spaces of air traffic, rail and car in Sibiu. From centralizing data obtained from the analysis of the measurements performed with equipment noise levels, we concluded that the noise and vibration produced by means of Transportation (air, road, rail) can affect human health if they exceed limits. Noise is present and part of our lives and always a source of pollution as any of modern man is not conscious.
Side Effects of Ambient Noise Immunity Techniques on Outdoor IEEE 802.11 Deployments
2008
A very common conclusion of many experimental studies about IEEE 802.11 outdoor network deployments is that their poor performance results derive from the unfavorable interference and multi-path signals in which the WLAN-cards are required to operate. Goal of this paper is to show that this condition does not always hold, and unexpected and inaccurated PHY layer implementations can be a primary cause of packet losses. With the support of extensive measurement campaigns led in our campus, we provide the performance evidence that IEEE 802.11 outdoor performance impairments are strongly affected by proprietary interference mitigation techniques that adaptively adjust the WLAN-card receiver sen…
Seismo-stratigraphic model of “La Bandita” area in the Palermo Plain (Sicily, Italy) through HVSR inversion constrained by stratigraphic data
2018
Ambient noise Horizontal-to-Vertical Spectral Ratio (HVSR) technique is commonly used approach to obtain 1D models of the shear-wave velocity in the shallow surface of an investigated area. However, obtained models can have a wide margin of uncertainty if inversions have not been appropriately constrained by detailed stratigraphic information. An application of HVSR inversion constrained by lithostratigraphic data is presented in order to verify the effectiveness of this technique for purposes of geological and geophysical reconstruction of a sedimentary basin in a densely urbanized area. This is often the case of seismic microzonation studies, in which almost all the information derives fr…
An automatic method for metabolic evaluation of gamma knife treatments
2015
Lesion volume delineation of Positron Emission Tomography images is challenging because of the low spatial resolution and high noise level. Aim of this work is the development of an operator independent segmentation method of metabolic images. For this purpose, an algorithm for the biological tumor volume delineation based on random walks on graphs has been used. Twenty-four cerebral tumors are segmented to evaluate the functional follow-up after Gamma Knife radiotherapy treatment. Experimental results show that the segmentation algorithm is accurate and has real-time performance. In addition, it can reflect metabolic changes useful to evaluate radiotherapy response in treated patients.
Noise levels in a dental teaching institute: a matter of concern!
2011
Objective: To measure and assess the noise levels produced by various dental equipments in different areas of a dental institution and to recommend improvements if noise levels are not within permissible limits. Material and Methods: Sound levels were measured at three different areas of a dental institution where learning and teaching activities are organized. The sound level was measured using a sound level meter known as ‘decibulolmeter’. In each area the noise level was assessed at two positions-one, at 6 inches from the operators ear and second, at the chairside instrument trolley. Noise levels were also assessed from a central location of the clinic area when multiple equipments were …