Search results for "Note"
showing 10 items of 10709 documents
Acoustic spectral hole-burning in a two-level system ensemble
2020
AbstractMicroscopic two-level system (TLS) defects at dielectric surfaces and interfaces are among the dominant sources of loss in superconducting quantum circuits, and their properties have been extensively probed using superconducting resonators and qubits. We report on spectroscopy of TLSs coupling to the strain field in a surface acoustic wave (SAW) resonator. The narrow free spectral range of the resonator allows for two-tone spectroscopy where a strong pump is applied at one resonance, while a weak signal is used to probe a different mode. We map the spectral hole burnt by the pump tone as a function of frequency and extract parameters of the TLS ensemble. Our results suggest that det…
Challenges in the determination of engineered nanomaterials in foods
2016
Detection, characterization, and quantification of engineering nanomaterials (ENMs) in foods is still a pending issue that needs to be tackle to protect consumers and to fix some related aspects (e.g. labelling or control). The global challenge for the analytical sciences is that ENMs are a new sort of analytes, involving both chemical (composition, mass and number concentration) and physical information (e.g. size, shape, aggregation). In this critical review, we evaluate and compare the procedures involved in the analytical methods and studies developed thus far for the identification and quantification of ENMs in food. We discuss advantages and limitation as well as prospects. We pointed…
Nanomaterial-based molecularly imprinted polymers for pesticides detection: Recent trends and future prospects
2020
Abstract Pesticides have been widely used in agricultural and industrial production to prevent pests. So, sensing pesticides with high selectivity and sensitivity level plays a significant role in food safety management. Molecularly imprinted polymer (MIP) based sensors overcome the current restriction of traditional detection approaches and offer great potential for efficient, low-cost and low detection limit using smart miniaturized equipment. But some drawbacks could come from the lack of electrocatalytic activity and conductivity of MIPs that restrict their utilization in the sensing field. The integration of NPs with MIPs has opened new ways for rapid screening and monitoring of pestic…
Sorting of Single Biomolecules based on Fourier Polar Representation of Surface Enhanced Raman Spectra
2016
AbstractSurface enhanced Raman scattering (SERS) spectroscopy becomes increasingly used in biosensors for its capacity to detect and identify single molecules. In practice, a large number of SERS spectra are acquired and reliable ranking methods are thus essential for analysing all these data. Supervised classification strategies, which are the most effective methods, are usually applied but they require pre-determined models or classes. In this work, we propose to sort SERS spectra in unknown groups with an alternative strategy called Fourier polar representation. This non-fitting method based on simple Fourier sine and cosine transforms produces a fast and graphical representation for sor…
Seismic evaluation of ordinary RC buildings retrofitted with externally bonded FRPs using a reliability-based approach
2020
International audience; Despite the extensive literature on reinforced concrete (RC) members retrofitted with fiberreinforced polymer (FRP) composites, few studies have employed a reliability-based approach to evaluate the seismic performance of RC buildings in terms of their collapse capacity and ductility. In this study, the performance of a poorly-confined RC building structure is investigated for different FRP retrofitting schemes using different configurations and combinations of wrapping and flange-bonded FRPs, as two well-established techniques. A nonlinear pushover analysis is then implemented with a computational reliability analysis based on Latin Hypercube Sampling (LHS) to deter…
On the Interconnections of HV–MV Stations to Global Grounding Systems
2019
The interconnection of grounding systems of HV-MV stations via the armors of medium voltage cables, is herein analyzed to verify the effects on touch voltages in ground-fault conditions. The major contributions of this paper are two: the analysis of the impact of an HV ground-fault on a global grounding system (GGS), and the analysis of the parameters that may affect safety due to the interconnection between HV-MV stations and the GGS. The authors have analyzed cases when the connection of an HV-MV station to a GGS improves safety, and then may introduce hazards under ground-fault conditions. Two main issues are herein discussed: 1) the transfer of dangerous voltages to substations, due to …
A review of thermochemical energy storage systems for power grid support
2020
Power systems in the future are expected to be characterized by an increasing penetration of renewable energy sources systems. To achieve the ambitious goals of the “clean energy transition”, energy storage is a key factor, needed in power system design and operation as well as power-to-heat, allowing more flexibility linking the power networks and the heating/cooling demands. Thermochemical systems coupled to power-to-heat are receiving an increasing attention due to their better performance in comparison with sensible and latent heat storage technologies, in particular, in terms of storage time dynamics and energy density. In this work, a comprehensive review of the state of art of theore…
Constitutive Models for the Tensile Behaviour of TRM Materials: Literature Review and Experimental Verification
2021
In recent years, the scientific community has focused its interest on innovative inorganic matrix composite materials, namely TRM (Textile Reinforced Mortar). This class of materials satisfies the need of retrofitting existing masonry buildings, by keeping the compatibility with the substrate. Different recent studies were addressed to improve the knowledge on their mechanical behaviour and some theoretical models were proposed for predicting the tensile response of TRM strips. However, this task is complex due to the heterogeneity of the constituent materials and the stress transfer mechanism developed between matrix and fabric through the interface in the cracked stage. This paper present…
Biochemical sensors: The state of the art
1995
The basic components of a (bio)chemical sensor and the main concepts involved in the (bio)chemical sensor methodology are considered in order to depict the state of the art of the development of research in this field, paying special attention to the evolution of the published scientific literature in analytical chemistry.
An omics perspective to the molecular mechanisms of anticancer metallo-drugs in the computational microscope era
2017
Introduction: Metallo-drugs have attracted enormous interest for cancer treatment. The achievements of this drug-type are summarized by the success story of cisplatin. That being said, there have been many drawbacks with its clinical use, which prompted decades worth of research efforts to move towards safer and more effective agents, either containing platinum or different metals. Areas covered: In this review, the authors provide an atomistic picture of the molecular mechanisms involving selected metallo-drugs from structural and molecular simulation studies. They also provide an omics perspective, pointing out many unsettled aspects of the most relevant families of metallo-drugs at an ep…