Search results for "O2"
showing 10 items of 1115 documents
Photoactivity under visible light of metal loaded TiO2 catalysts prepared by low frequency ultrasound treatment
2017
Abstract Visible-light responsive bare and metal loaded (Pt, Ag, Rh, Pd) TiO 2 photocatalysts were prepared by using a simple ultrasound treatment. This method induced bulk oxygen deficiency resulting in a narrowing bandgap (from 3.18 to 3.04 eV) and in visible light absorption. The samples were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), BET specific surface area (SSA) and pore size distribution (PSD), UV–vis diffuse reflectance spectroscopy (DRS), Raman spectroscopy and X-ray photoelectron spectroscopy (XPS). The photocatalytic activity of the samples was evaluated by using the 4-nitrophenol oxidation reaction and the photocatalytic oxidation of glucose w…
Enhanced Solar Light Photocatalytic Activity of Ag Doped TiO2–Ag3PO4 Composites
2020
Composites comprised of Ag3PO4 and bare TiO2 (TiO2@Ag3PO4) or silver doped TiO2 (Ag@TiO2&ndash
High-performance of PbO2 nanowire electrodes for lead-acid battery
2014
Abstract PbO2 nanowires were obtained by template electrodeposition in polycarbonate membranes and tested as positive electrode for lead-acid battery. Nanowires were grown on the same material acting as current collector that was electrodeposited too. The nanostructured electrodes were assembled in a zero-gap configuration using commercial negative plate and separator. Cell performance was tested by galvanostatic charge/discharge cycles in a 5 M H2SO4 aqueous electrolyte. PbO2 nanostructured electrodes were able to deliver at 1C rate an almost constant capacity of about 190 mAh g−1 (85% of active material utilization), close to the theoretical value (224 mAh g−1). The nanowire array provide…
Doped TiO2 Nanomaterials and Applications
2008
This special issue brieflyreviews some trends and factors that have impacted heterogeneous photocatalysis with next generation TiO2 nanophotocatalysts that could absorband make use of both UV (290–400 nm) and visible (400–700 nm) sunlight to enhance process efficiencies, along with some issues of current debate in the fundamental understanding of the science that underpins the field. Preparative methods and some characteristics features of doped TiO2 as well as its environmental applications are presented and described. The next generation of doped TiO2 photocatalysts should enhance overall process photoefficiencies in many cases, since doped TiO2s absorb a greater quantity of solar radiati…
Heterogeneous photocatalytic materials for sustainable formation of high-value chemicals in green solvents
2021
Abstract The most investigated materials used as heterogeneous photocatalysts for the formation of high-value chemicals under mild experimental conditions are presented in this survey. Only papers reporting reactions carried out in harmless solvents such as water, the green solvent par excellence, are reported. Metal oxides have been used often, but carbon-based materials such as carbon nitride and graphene, metal nanoparticles, sulphides and selenides also have received a great attention mainly due to their good performances both in partial oxidations and reductions. The results presented indicate that an appropriate choice of the photocatalytic material is the main problem to be faced to …
Large scale synthesis of nanostructured zirconia-based compounds from freeze-dried precursors
2013
Nanocrystalline zirconia powders have been obtained at the multigram scale by thermal decomposition of precursors resulting from the freeze-drying of aqueous acetic solutions. This technique has equally made possible to synthesize a variety of nanostructured yttria or scandia doped zirconia compositions. SEM images, as well as the analysis of the XRD patterns, show the nanoparticulated character of those solids obtained at low temperature, with typical particle size in the 10–15 nm range when prepared at 673 K. The presence of the monoclinic, the tetragonal or both phases depends on the temperature of the thermal treatment, the doping concentration and the nature of the dopant. In addition,…
Effect of oxygen deficiency on the radiation sensitivity of sol-gel Ge-doped amorphous SiO2
2008
We report experimental investigation by electron paramagnetic resonance (EPR) measurements of room temperature γ-ray irradiation effects in sol-gel Ge doped amorphous SiO2. We used materials with Ge content from 10 up to 104 part per million (ppm) mol obtained with different preparations. These latter gave rise to samples characterized by different extents of oxygen deficiency, estimated from the absorption band at ~5.15 eV of the Ge oxygen deficient centers (GeODC(II)). The irradiation at doses up to ~400 kGy induces the E'-Ge, Ge(1) and Ge(2) paramagnetic centers around g ~ 2 with concentrations depending on Ge and on GeODC(II) content. We found correlation between Ge(2) and GeODC(II) con…
Near-Infrared Emission of O2 Embedded in Amorphous SiO2 Nanoparticles
2011
We report an experimental study on the emission properties of O2 molecules loaded by a thermal diffusion process at 200 °C into high-purity silica nanoparticles with mean diameters of 7 and 40 nm. The embedded O 2 features a singlet to triplet emission band peaked at 1272 nm in agreement with the band observed for bulk silica materials. The photoluminescence excitation spectra have been determined in the visible and in the infrared range and are characterized by narrow bands peaked at 691, 764, and 1069 nm, respectively. By comparison of the transition energies, the vibrational quanta have been determined for the ground and for both the excited states; the values found are lower than the co…
Improvement in the performance of low temperature H2-O2 fuel cell with chitosanephosphotungstic acid composite membranes
2016
Abstract Free-standing chitosan/phosphotungstic acid polyelectrolyte membranes, prepared by ionotropic gelation on alumina porous supports, were employed as proton conductor in low temperature H 2 –O 2 fuel cell. A drying step on glass substrate was introduced in the fabrication procedure to reduce shrinkage and consequent corrugation. Membranes were tested with electrodes prepared according to different procedures and with two different Pt loadings, namely 0.5 and 1 mg cm −2 . Both the investigated kinds of electrodes allowed to get very promising power peaks of 550 mW cm −2 in spite of the different Pt content. The polarization curves and the electrochemical impedance spectra suggest that…
Charge Transport Layers Limiting the Efficiency of Perovskite Solar Cells: How To Optimize Conductivity, Doping, and Thickness
2019
Perovskite solar cells (PSCs) are one of the main research topics of the photovoltaic community; with efficiencies now reaching up to 24%, PSCs are on the way to catching up with classical inorganic solar cells. However, PSCs have not yet reached their full potential. In fact, their efficiency is still limited by nonradiative recombination, mainly via trap-states and by losses due to the poor transport properties of the commonly used transport layers (TLs). Indeed, state-of-the-art TLs (especially if organic) suffer from rather low mobilities, typically within 10(-5) and 10(-2) cm(-2) V-1 s(-1), when compared to the high mobilities, 1-10 cm(-2) V-1 s(-1), measured for perovskites. This work…