Search results for "OPTICS"

Grain boundary ridges slow dawn grain boundary motion: In-situ observation

2014

Abstract The impact of grain boundary (GB) ridge on motion of high-angle GB in Zn was studied. The steady-state motion of faceted GB half-loop with [ 10 1 ¯ 0 ] tilt GB and GB ridge was recorded in-situ. The temperatures of faceting–roughening transition were experimentally defined for three GB half-loops. Above the transition temperature GB half-loops had GB “rough-to-rough” ridge with continuously curved GB segments. Below the transition temperature a facet appeared and coexisted with two “facet-to-rough” ridges. For the first time we could extract mobility of “rough-to-rough” and “rough-to-facet” ridges and bring out clearly that GB ridge slows down GB motion. Present removes contradicti…

Grooving by Nd:YAG laser treatment

2000

Abstract The properties of the laser beam have been used to produce deep and thin grooves in metals, melted material being removed with the assistance of a high velocity gas. Preliminary experiments show that the geometry and the location of the gas inlet tube are the main parameters governing the evacuation of the scoria. The influence of the nature of the materials on the depth of the grooves is discussed from examination of the grooves realized on various metals (copper, aluminum, titanium,…). Finally, a statistical study is performed to indicate the parameters that have to be controlled to secure regular grooves. It appears that the groove width is not too much affected by parameter var…

Numerical study of silicon crystal ridge growth

2014

Abstract The size of the ridge-like protrusions appearing on the external surface of dislocation-free 〈 100 〉 silicon crystals grown from a melt was studied theoretically. According to existing models the growth of the ridges is caused by the presence of { 111 } crystal planes at the crystal–melt interface. They affect the height of triple phase line, free surface orientation and the crystal growth angle. A numerical 2-dimensional model was proposed for the calculation of the size of the crystal ridges. The model included the effect of the undercooling of the crystal–melt interface on the crystal growth angle. The numerical model estimated the effect of the ridge size on the free surface at…

Volcanic CO_2 detection with a DFM/OPA-based lidar

2015

The DFM/OPA-based lidar BILLI was used to investigate the volcanic plume released by the hydrothermal vent of Pisciarelli, in the Campi Flegrei volcano. BILLI remotely measured CO2 concentrations in cross-sections of the nearvent plume using the differential absorption technique. To our knowledge, this is the first example of lidar-based measurement of volcanic CO2 . The spatial resolution was 1.5 m and the temporal resolution 20 s. © 2015 Optical Society of America.

Fast tracking of wind speed with a differential absorption LiDAR system: First results of an experimental campaign at Stromboli volcano

2017

Carbon dioxide ( CO 2 ) is considered a precursor gas of volcanic eruptions by volcanologists. Monitoring the anomalous release of this parameter, we can retrieve useful information for the mitigation of volcanic hazards, such as for air traffic security. From a dataset collected during the Stromboli volcano field campaign, an assessment of the wind speed, in both horizontal and vertical paths, performing a fast tracking of this parameter was retrieved. This was determined with a newly designed shot-per-shot differential absorption LiDAR system operated in the near-infrared spectral region due to the simultaneous reconstruction of CO 2 concentrations and wind speeds, using the same sample o…

Corrigendum: A new archive of large volcanic events over the past millennium derived from reconstructed summer temperatures (2017 Environ. Res. Lett.…

2017

First-time lidar measurement of water vapor flux in a volcanic plume

2011

Abstract The CO 2 laser-based lidar ATLAS has been used to study the Stromboli volcano plume. ATLAS measured water vapor concentration in cross-sections of the plume and wind speed at the crater. Water vapor concentration and wind speed were retrieved by differential absorption lidar and correlation technique, respectively. Lidar returns were obtained up to a range of 3 km. The spatial resolution was 15 m and the temporal resolution was 20 s. By combining these measurements, the water vapor flux in the Stromboli volcano plume was found. To our knowledge, it is the first time that lidar retrieves water vapor concentrations in a volcanic plume.

Glyphosate Sensor Based on Nanostructured Water-Gated CuO Field-Effect Transistor

2022

This research presents a comparative analysis of water-gated thin film transistors based on a copper oxide (CuO) semiconductor in the form of a smooth film and a nanostructured surface. A smooth CuO film was deposited through reactive magnetron sputtering followed by annealing in atmosphere at a temperature of 280 (Formula presented.) C. Copper oxide nanostructures were obtained by hydrothermal synthesis on a preliminary magnetron sputtered 2 nm thick CuO precursor followed by annealing at 280 (Formula presented.) C. An X-ray diffraction (XRD) analysis of the samples revealed the presence of a tenorite (CuO) phase with a predominant orientation of (002). Scanning electron microscopy (SEM) a…

Epistemic network analyses of economics students' graph understanding. An eye-tracking study

2020

Learning to solve graph tasks is one of the key prerequisites of acquiring domain-specific knowledge in most study domains. Analyses of graph understanding often use eye-tracking and focus on analyzing how much time students spend gazing at particular areas of a graph&mdash

Transient guided-mode resonance metasurfaces with phase-transition materials

2023

We investigate transient, photo-thermally induced metasurface effects in a planar thin-film multilayer based on a phase-transition material. Illumination of a properly designed multilayer with two obliquely incident and phase-coherent pulsed pumps induces a transient and reversible temperature pattern in the phase-transition layer. The deep periodic modulation of the refractive index, caused by the interfering pumps, produces a transient Fano-like spectral feature associated with a guided-mode resonance. A coupled opto-thermal model is employed to analyze the temporal dynamics of the transient metasurface and to evaluate its speed and modulation capabilities. Using near-infrared pump pulses…