Search results for "Oxide"
showing 10 items of 6424 documents
High-resolution stimulated Raman spectroscopy and analysis of the ν 1 band of osmium tetroxide
2012
D.B.P. and R.Z.M. acknowledge the financial support of the Ministry of Science and Innovation through research grant no. FIS2009-08069.
Evaluation of Thin Film Microextraction for trace elemental analysis of liquid samples using LIBS detection
2021
An analytical methodology based in the combination of Thin Film Microextraction with Laser-induced Breakdown Spectroscopy (TFME-LIBS) was investigated, for the first time, for detection of Cu, Cr, Ni and Pb in aqueous solutions. In this methodology, the analytes were extracted in a thin film of adsorbent material deposited on a solid support, which was introduced in the sample to analyse. After extraction, the analytes retained in the adsorbent were analysed by LIBS. In order to obtain adsorbent films useful for the microextraction step, two different experimental procedures for film generation, denoted as Drop Casting Deposition and Mould Deposition, were evaluated. In both cases, graphene…
Photocatalytic degradation of phenol in aqueous titanium dioxide dispersions
1988
The results of a study of photocatalytic degradation of phenol using aqueous oxygenated TiO2 (anatase) suspensions in a batch Pyrex photoreactor are reported. The influence on the photodegradation rate of various parameters as pH, phenol and TiO2 content, oxygen partial pressure, anions present in the dispersions was investigated. A complete oxidation of phenol was observed. Intermediate compounds, catechol and quinone, were detected. It was observed that the photodegradation also proceeded with sunlight radiation. A mechanistic and kinetic model, which accounts for the results obtained, is given. Likely reasons for inactivity of the rutile modification for this reaction are also given.
Visible light photocatalytic activity of macro-mesoporous TiO2-CeO2inverse opals
2018
Macro-mesoporous TiO2 inverse opal materials were synthesized and they were tested as photocatalysts under visible light irradiation. The influence of cerium oxide addition towards the Rhodamine B (RhB) photodegradation activity was evaluated. Structural, textural, spectral and surface properties of the TiO2-CeO2 inverse opal nanocomposites were studied by XRD, XPS, SEM, TEM, N2 adsorption-desorption, Diffuse Reflectance UV–vis and Photoluminescence spectroscopies. Compared to commercial TiO2 anatase, the macro-mesoporous TiO2 inverse opal exhibited six times higher kinetic rate constant in the RhB degradation under visible light irradiation. The good photocatalytic activity was related to …
A structural investigation of titanium dioxide photocatalysts
1991
Abstract A study of the structure and the morphology of a titanium dioxide photocatalyst (Degussa P25) reveals multiphasic material consisting of an amorphous state, together with the crystalline phases anatase and rutile in the approximate proportions 80 20 . Transmission electron microscopy provides evidence that some individual particles are a mixture of the amorphous state with either the anatase phase or with the rutile phase, and that some particles, which are mostly anatase, are covered by a thin overlayer of rutile which manifests its presence by the appearance of Moire fringes. The photocatalytic activity of this form of titanium dioxide is reported as being greater than the activi…
Hybrid TiO2 @ phthalocyanine catalysts in photooxidation of 4-nitrophenol: Effect of the matrix and sensitizer type
2020
Abstract Microcrystalline and nanocrystalline anatase (TiO2) based hybrid photocatalysts including selected phthalocyanine sensitizers were explored in photooxidation of 4-nitrophenol (4-NP) in water. Composites obtained with the homemade pure nano-anatase displayed a very poor catalytic performance compared to the other ones prepared from the commercial Tioxide-Huntsman (micro) and Evonik P25 (nano) products. In particular, the microcrystalline anatase impregnated with sandwich phthalocyanines of Gd or Yb showed excellent results both in photooxidation of 4-NP and hydroquinone, and proved the only ones which completely removed these two compounds from the system during the same reaction cy…
Fourier Transform Infrared Study of the Performance of Nanostructured TiO2 Particles for the Photocatalytic Oxidation of Gaseous Toluene
2001
Thermal and hydrothermal treatments have been applied to an amorphous TiO2 precursor for obtaining nanosized TiO2 particles (P11t and P11h, respectively) of different photocatalytic properties. The activity of these catalysts has been tested by performing the toluene oxidation in gas phase in a continuous photoreactor. A Fourier transform infrared (FTIR) investigation of the catalysts under conditions prevailing during the test photoreaction has also been carried out. The photoreactivity results showed that CO2 was the main oxidation product and benzaldehyde a stable intermediate. Anatase P11t photoactivity was similar to that observed for commercial photocatalysts, while anatase P11h prese…
NiO diluted in high surface area TiO2 as efficient catalysts for the oxidative dehydrogenation of ethane
2017
[EN] Catalysts consisting of NiO diluted in high surface area TiO2 can be as efficient in the oxidative dehydrogenation of ethane as the most selective NiO-promoted catalysts reported previously in the literature. By selecting the titania matrix and the NiO loading, yields to ethylene over 40% have been obtained. In the present article, three different titanium oxides (TiO2) have been employed as supports or diluters of nickel oxide and have been tested in the oxidative dehydrogenation of ethane to ethylene. All TiO2 used present anatase as the main crystalline phase and different surface areas of 11,55 and 85 m(2) g(-1). It has been observed that by selecting an appropriate nickel loading …
Reactive direct current magnetron sputtered TiO2 thin films with amorphous to crystalline structures.
2008
International audience; TiO2 thin films were deposited on soda–lime glass substrates by reactive direct current magnetron sputtering in a mixture of pure argon and oxygen. The influence of both the deposition time, td, and the post-annealing treatments on the films morphology, composition and structure was analyzed by scanning electron microscopy, ellipsometry, X-ray photoelectrons spectroscopy, X-ray diffraction (XRD) and Raman spectroscopy. Amorphous TiO2 was obtained for the shortest deposition time, td=15 min. Increasing td up to 30 min, poorly crystallized anatase and rutile phases were formed together with amorphous TiO2, as was revealed by complementary XRD patterns and Raman spectra…
Study of surface layers and ejected powder formed by oxidation of titanium substrates with a pulsed Nd:YAG laser beam.
2009
Laser treatment of a titanium surface at certain conditions initiates the formation of titanium oxide layers as well as micro (nano) scale powder ejected from the surface of the substrate. The resultant morphology of the surface as well as the size and the structure of the particles are all strongly dependent on the treatment parameters (laser fluence, pulse frequency, overlap parameter, etc.). In this study, titanium substrates were treated with an industrial pulsed Nd:YAG laser in air, with varying parameters. Surface layers and ejected materials were compared using scanning and transmission electron microscopy, X-ray diffraction and Raman spectroscopy. The rutile phase of TiO(2) dominate…