Search results for "POLARIZATION"
showing 10 items of 1884 documents
Influence of sulphite on the passivation of iron
1991
Abstract Mossbauer spectroscopy and electrochemical measurements were used to study the passivation of iron and steels in a sulphite containing solution. The potentiodynamic curves show that passivation occurs at −140 mV potential vs saturated calomel electrode ( sce ). The main phase of the passive layer was found to be γ-FeOOH, while FeSO 4 ·H 2 O on the surface and FeSO 3 ·3H 2 O inside the layer were identified as minor phases in the case of polarization in a solution of pH 3.37. Only γ-FeOOH was observed on the surface of samples polarized at pH 6.6.
Study of Passive Films Formed on AISI 316L Stainless Steel in Non-Polluted and Underwater-Volcano-Polluted Seawater
2014
This work studies the semiconducting behavior of passive films formed on AISI 316L (UNS S31603) in two different sea-water solutions, non-polluted and polluted, collected from the volcano of El Hierro Island. Polarization measurements, potentiostatic passivation tests, electrochemical impedance spectroscopy, and capacitance measurements were performed. Results show that the polluted seawater worsens passivation kinetics. Additionally, passive films formed on AISI 316L stainless steel in polluted seawater have been found to be less protective than those formed in non-polluted seawater, showing a more defective structure, owing to the acidity of the polluted medium.
Electrochemical impedance spectroscopy for studying passive layers on steel rebars immersed in alkaline solutions simulating concrete pores
2007
Present paper deals with the use of the electrochemical impedance spectroscopy to identify different processes in the passive layer growth over steel rebar surface immersed in an alkaline media simulating the concrete pore solution. Two cases have been considered: a passive layer spontaneously grown in a high alkaline media and a passive layer assisted by the application of an anodic potential in the same media. The application of electric equivalent circuits allows distinguishing between the different mechanisms occurring in this passive layer when grows in different conditions. An electric equivalent circuit with two RC loops connected in parallel is often used for fitting the EIS diagram…
Electrochemically-induced TiO2 incorporation for enhancing corrosion and tribocorrosion resistance of PEO coating on 7075 Al alloy
2018
Abstract 7075 Al alloy was PEO-treated in a silicate based electrolyte containing 3 g l-1 potassium titanyl oxalate using unipolar and bipolar pulsed current waveforms. The coating formed by the bipolar waveform with the wider cathodic pulses showed volcano-like surface morphology with no evidence of large pores at the metal/coating interface. It revealed the highest corrosion performance due to the synergistic effect of TiO2 incorporation and structural/morphological features along with a better passivation behavior indicating no pitting susceptibility. For this coating, the tribocorrosion tests showed no potential drop during sliding under 1 N with the lowest volume loss of 0.022 mm3.
Investigation on passivity of titanium under steady-state conditions in acidic solutions
2011
Abstract The passivity of titanium was studied using potentiostatic polarization combined with Mott–Schottky analysis in acidic solutions. The oxide layer was characterized as an n-type semiconducting, oxygen deficient oxide (TiO1.993–1.996) with a donor density in the range of 1019–1020 cm−3 depending on electrode potential and electrolyte pH. The calculated thickness for the inner oxide layer was in the range of 1–4 nm, increasing linearly with applied potential and exponentially with electrolyte pH. The potential- and pH-dependence of the inner oxide thickness was interpreted by a modified point defect model for the migration-controlled oxide growth, in which the rate-determining step in…
Influence of Compressive Stress on Dielectric and Ferroelectric Properties of the(Na0.5Bi0.5)0.7Sr0.3TiO3Ceramics
2013
Good quality lead-free ceramics of (Na0.5Bi0.5)0.7Sr0.3TiO3(NBTS30) have been produced by a solid phase sintering process. The dependence of dielectric and ferroelectric properties on the unaxial pressure (0–1200 bar) were investigated. A shift and decrease of maximum value of e, decrease of the thermal hysteresis and coercive field and increase of polarization with increasing pressure were observed. The results were discussed in terms of an elastic changes in inter-ionic distances in a crystal structure and switching nanoregions under the action of pressure. The NBTS30 ceramic is expected to be a new promising candidate for lead-free electronic material.
Direct observation of half-metallicity in the Heusler compound $Co_{2}MnSi$
2014
Ferromagnetic thin films of Heusler compounds are highly relevant for spintronic applications owing to their predicted half-metallicity, that is, 100% spin polarization at the Fermi energy. However, experimental evidence for this property is scarce. Here we investigate epitaxial thin films of the compound Co2MnSi in situ by ultraviolet-photoemission spectroscopy, taking advantage of a novel multi-channel spin filter. By this surface sensitive method, an exceptionally large spin polarization of () % at room temperature is observed directly. As a more bulk sensitive method, additional ex situ spin-integrated high energy X-ray photoemission spectroscopy experiments are performed. All experimen…
Polarized recombination of acoustically transported carriers in GaAs nanowires
2012
: The oscillating piezoelectric field of a surface acoustic wave (SAW) is employed to transport photoexcited electrons and holes in GaAs nanowires deposited on a SAW delay line on a LiNbO3 crystal. The carriers generated in the nanowire by a focused light spot are acoustically transferred to a second location where they recombine. We show that the recombination of the transported carriers occurs in a zinc blende section on top of the predominant wurtzite nanowire. This allows contactless control of the linear polarized emission by SAWs which is governed by the crystal structure. Additional polarization-resolved photoluminescence measurements were performed to investigate spin conservation d…
Conductance control at the LaAlO3/SrTiO3-interface by a multiferroic BiFeO3 ad-layer
2014
Multilayered BiFeO3 (BFO)/LaAlO3 (LAO) thin film samples were fabricated on SrTiO3 (STO) substrates by pulsed laser deposition. In this work, the ferroelectric polarization of a multiferroic BFO ad-layer on top of the quasi-two-dimensional electron gas (2DEG) at the LAO/STO interface is used to manipulate the conductivity of the quasi-2DEG. By microstructuring the conductive area of the LAO/STO-interface, a four-point geometry for the measurement of the resistivity was achieved. Piezo force microscopy allows for imaging and poling the spontaneous ferroelectric polarization of the multiferroic layer. The resistance changes showed a linear dependence on the area scanned and a hysteretic behav…
A nondestructive analysis of the B diffusion in Ta–CoFeB–MgO–CoFeB–Ta magnetic tunnel junctions by hard x-ray photoemission
2010
This work reports on hard x-ray photoelectron spectroscopy (HAXPES) of CoFeB based tunnel junctions. Aim is to explain the role of the boron diffusion for the observed improvement of the tunneling magnetoresistance ratio with increasing annealing temperature. The high bulk sensitivity of HAXPES was used as a nondestructive technique to analyze CoFeB–MgO–CoFeB magnetic tunnel junctions. The investigated samples were processed at different annealing temperatures from 523 to 923 K. Hard x-ray core level spectroscopy reveals an enforced diffusion of boron from the CoFeB into the adjacent Ta layer with increasing annealing temperature. The dependence of the tunneling magnetoresistance on the ann…