Search results for "Partial Pressure"
showing 10 items of 145 documents
Effects of ocean acidification on embryonic respiration and development of a temperate wrasse living along a natural CO2 gradient
2016
Volcanic CO2 seeps provide opportunities to investigate the effects of ocean acidification on organisms in the wild. To understand the influence of increasing CO2 concentrations on the metabolic rate (oxygen consumption) and the development of ocellated wrasse early life stages, we ran two field experiments, collecting embryos from nesting sites with different partial pressures of CO2 [pCO2; ambient (400 µatm) and high (800-1000 µatm)] and reciprocally transplanting embryos from ambient- to high-CO2 sites for 30 h. Ocellated wrasse offspring brooded in different CO2 conditions had similar responses, but after transplanting portions of nests to the high-CO2 site, embryos from parents that sp…
Distribution of oxygen partial pressure in a two-dimensional tissue supplied by capillary meshes and concurrent and countercurrent systems
1969
Abstract For the calculations of oxygen partial pressure in a two-dimensional tissue model supplied by a capillary network (inhomogeneously perfused tissue), two differential equations are given that describe the process in the tissue and capillaries. The differential equations are coupled by the boundary conditions. Results obtained by using the method of successive displacements are given for the two-dimensional problem. This method exhibits a satisfactory convergence. The accuracy of the results is about ±5% based on the initial concentration. The results for the network model are compared with those for equivalent concurrent and countercurrent systems. Equivalence means in this connecti…
Morphology transitions in ZnO nanorods grown by MOCVD
2012
Morphology transitions (nanorods–nanowalls and nanorods–nanotubes-layer) were induced in the growth of ZnO nanostructures by metal organic chemical vapor deposition (MOCVD) on c-sapphire, using helium as carrier gas, and dimethylzinc–triethylamine and nitrous oxide as zinc and oxygen sources, respectively. A systematic study of the influence of the VI/II ratio and precursor flow-rates on the morphology of ZnO nanorod arrays has been carried out, taking advantage of the ability of MOCVD to individually control the precursor partial pressures. Growth mechanisms are discussed to understand the evolution of the nanostructures morphology for different growth conditions. In particular, the influe…
AES and CEMS analysis of the formation of layers on Si steel under thermal treatment in a flux of H2/water vapour
1991
The near surface diffusion and reaction processes in iron-silicon steel (3.1 wt.%Si) during 10 min decarburization in water vapour/hydrogen have been studied. The decarburization temperature has been varied between 506 and 714°C for the fixed partial pressure ratio pH2O/pH2=0.017. An outer layer of SiO2 forms on the surface with its thickness increasing with temperature. From 600°C upwards, the decarburization process is hindered and a cementite layer is formed below the SiO2 layer. The formation of fayalite at the surface has been studied at a fixed decarburization temperature with pH2O/pH2 ranging from 0.017 to 0.49. The scale thickness reduces abruptly just before the ratio pH2O/pH2 nece…
Modeling of PAH elimination by adiabatic steam stripping and intraparticle desorption
2003
The decontamination process of solids loaded with PAH in a pilot plant is modeled. This process is separated into two main stages: fast steam stripping at the entrance of the separation tube and the subsequent slow desorption of PAH from the interior of the soil particles. The stripping process also occurs in two stages: fast diffusion controlled saturation of the partial pressures followed by the heat transfer controlled evaporation. The phase diagram of PAH/water is constructed using both the microscopic model and empirical relationships for systems with wide miscibility gaps. The numerical basis for the calculations describing desorption from the soil particles is discussed. The model fo…
Performance of EasyBreath® Decathlon Snorkeling mask for Delivering Continuous Positive Airway Pressure
2020
ABSTRACTBackgroundDuring the COVID-19 pandemic, the need for noninvasive respiratory support devices has dramatically increased, sometimes exceeding hospital capacity. The full-face Decathlon snorkeling mask, EasyBreath® (EB® mask), has been adapted to deliver continuous positive airway pressure (CPAP) as an emergency respiratory interface. We aimed to assess the performance of this modified EB® mask.MethodsCPAP set at 5, 10, and 15 cmH2O was delivered to 10 healthy volunteers with a high-flow system generator set at 40, 80, and 120 L min-1 and with a turbine-driven ventilator during both spontaneous and loaded (resistor) breathing. Inspiratory CO2 partial pressure (PiCO2), pressure inside …
Effect of arterial oxygen tension on cerebral blood flow at different levels of arterial PCO2.
1970
Die Wirkung des arteriellen O2-Partialdruckes auf die Durchblutung des Grosshirns, Kleinhirns und Hirnstammes bei normalen und erhohten CO2-Partialdrucken im arteriellen Blut wird an der anaesthesierten Katze untersucht. Die Wirkung des PaO2 ist von der Hohe des PaCO2 abhangig.
Study of the ZnO crystal growth by vapour transport methods
2004
Abstract The crystal growth of ZnO by vapour transport is classically made with the assistance of additional species that produce a gaseous mixture, the role of which remains often uncertain in the transport and growth process. Initially, in order to study the mass transport process, a numerical simulation is made to analyse which are the requirements to have an effective transport. As the pressure of each gaseous species is generally unknown, the numerical study has been performed for different total pressures. It is found that, if congruent and equilibrium conditions are assumed at the sublimation and crystallisation interfaces, effective growth conditions can only be attained for a narro…
Interaction of Ni/SiO2 with thiophene.
2009
Abstract The interaction between Ni/SiO 2 (18 wt%) and thiophene was studied by thermal gravimetric analysis (TGA) and in a fixed-bed reactor. The samples were prepared by incipient wetness impregnation and reaction was realized in hydrogen flow at 280–360 °C in the presence of 10–40 mbar of thiophene. It is found that sulfidation of Ni is not complete in TGA experiments and the maximum achievable transformation degree depends not only on the temperature and thiophene pressure, but also on the sample weight and the gas flow rate. The maximum transformation degree is shown to vary reversibly when conditions are changed. Analysis of the reaction products during sulfidation in a fixed-bed reac…
Nitrogen plasma pressure influence on the composition of TiNxOy sputtered films
2002
Thin films of TiNxOy were deposited by d.c. magnetron sputtering on glass substrates using an (Ar+,N2) plasma and Ti target. The N2 partial pressure was changed from 2.3 × 10−4 mbar to 4.6 × 10−3 mbar in order to obtain films with increasing nitrogen contents. X-ray photoelectron spectroscopy was used to determine the as-deposited composition. The presence of oxygen, which is probably due to contamination from the residual atmosphere in the vacuum chamber, is always detected, both in the surface layers and in the bulk of the films, confirming the formation of TiNxOy. When the nitrogen partial pressure was increased, a maximum for the nitrogen content in the films was reached, corresponding …