Search results for "Peat"
showing 10 items of 1026 documents
Comparison of direct mass spectrometry methods for the on-line analysis of volatile compounds in foods
2013
For the on-line monitoring of flavour compound release, atmospheric pressure chemical ionization (APCI) and proton transfer reaction (PTR) combined to mass spectrometry (MS) are the most often used ionization technologies. APCI-MS was questioned for the quantification of volatiles in complex mixtures, but direct comparisons of APCI and PTR techniques applied on the same samples remain scarce. The aim of this work was to compare the potentialities of both techniques for the study of in vitro and in vivo flavour release. Aroma release from flavoured aqueous solutions (in vitro measurements in Teflon bags and glass vials) or flavoured candies (in vivo measurements on six panellists) was studie…
Theoretical prediction of the chemiluminescence behaviour of the ergot alkaloids
2004
Abstract The present manuscript is dealing with the application of molecular connectivity calculations to predict the chemiluminescent behaviour of ergot alkaloids when they react with common strong oxidants in liquid phase. Twenty compounds were theoretically studied by means of a discriminant equation formerly published, being 19 of them predicted as chemiluminescent with a high probability. Empirical confirmation of the chemiluminometric behaviour is performed with the few soluble and commercially available ergot alkaloids. On the basis of these results, a new FIA-direct chemiluminescent method is proposed for the determination of the ergot presenting the higher light emission, the pharm…
Resin and fatty-acid analysis by solid-phase extraction coupled to atmospheric pressure chemical ionization–mass spectrometry
2007
Using gas-chromatographic analysis, the suitability of liquid–liquid extraction and solid-phase extraction (SPE) methods was studied for the rapid separation of resin and fatty-acid fractions from papermaking process waters. In the second phase of this study, a novel procedure (correlation coefficient >0.99 and repeatability RSD <8%) for on-line monitoring of selected individual acid components (limits of detection 11–78 µg L−1) by SPE combined with atmospheric pressure chemical ionization–mass spectrometry was developed. The suitability of this technique for quality control of papermaking process waters was tested by means of industrial samples. The method was also found suitable for the a…
Analytical strategy photodegradation/chemiluminescence/continuous-flow multicommutation methodology for the determination of the herbicide Propanil
2006
The present paper is dealing with an analytical strategy based on coupling photodegradation, chemiluminescence and multicommutation continuous-flow methodology for the determination of the pesticide Propanil, a common herbicide. The pesticide solution is inserted as small segments sequentially alternated with segments of the solution for adjusting the suitable medium for the photodegradation. Both flow-rates (sample and medium) are adjusted to required time for photodegradation, 2.0 min; and then, the resulting solution is also sequentially inserted as segments alternated with segments of the oxidizing solutions system, 1.00 x 10(-4) mol 1(-1) potassium permanganate in 2.00 mol 1(-1) sulphu…
Quality control of Metamitron in agrochemicals using Fourier transform infrared spectroscopy in the middle and near range
2006
Abstract Two vibrational spectrometry-based methodologies were developed for Metamitron determination in pesticide formulations. Fourier transform-middle infrared (FT-MIR) procedure was based on the extraction of Metamitron by CHCl 3 and latter determination by peak area measurement between 1556 and 1533 cm −1 , corrected with a two points baseline established from 1572 to 1514 cm −1 . Fourier transform-near infrared (FT-NIR) determination was made after the extraction of Metamitron in acetonitrile and measuring the peak area between 6434 and 6394 cm −1 corrected using a two points baseline defined between 6555 and 6228 cm −1 . Repeatability, as relative standard deviation, of 5 independent…
Solid-phase FT-Raman determination of caffeine in energy drinks
2005
Abstract A solid-phase vibrational spectrometry-based methodology (solid-phase Fourier transform-Raman spectrometry, SP-FT-Raman) has been developed for caffeine determination in commercial energy drink samples. The Raman spectra of caffeine, fixed on a C18 solid phase packed into a glass tube of 5 mm i.d., was obtained directly between 3500 and 70 cm −1 . In order to quantify caffeine, Raman intensity between 573 and 542 cm −1 corrected using a baseline defined between 580 and 540 cm −1 was used. A repeatability of 3%, as relative standard deviation of five analysis of a 200 mg l −1 concentration, and a limit of detection of 18 mg l −1 were obtained. The SP-FT-Raman procedure provides a sa…
Determination of uranium in tap water by ICP-MS
2000
A fast and accurate procedure has been developed for the determination of uranium at microg L(-1) level in tap and mineral water. The method is based on the direct introduction of samples, without any chemical pre-treatment, into an inductively coupled plasma mass spectrometer (ICP-MS). Uranium was determined at the mass number 238 using Rh as internal standard. The method provides a limit of detection of 2 ng L(-1) and a good repeatability with relative standard deviation values (RSD) about 3% for five independent analyses of samples containing 73 microg L(-1) of uranium. Recovery percentage values found for the determination of uranium in spiked natural samples varied between 91% and 106%…
Simultaneous detection of three antiviral and four antibiotic compounds in source-separated urine with liquid chromatography
2013
An analytical method for the simultaneous screening of three antiviral agents (nevirapine, zidovudine, lamivudine), four antibiotics (sulfamethoxazole, trimethoprim, ciprofloxacin, rifampicin) and one reference compound (carbamazepine) in human urine was developed. Separation was achieved with a Kinetex XB-C18 (75 × 4.6 mm, 2.6 μm) column after the extraction of pharmaceuticals from urine with SPE. Gradient elution with a mobile phase consisting of acetonitrile and 10 mM KH2 PO4 (pH 2.5), and diode array detection with monitoring at 210 and 264 nm was applied. The developed method was validated in terms of selectivity, linearity, stability and sensitivity. Repeatability (n = 3) and between-…
Near infrared determination of Diuron in pesticide formulations
2005
Abstract A simple, fast and environmentally friendly near infrared (NIR)-based methodology was developed for Diuron determination in pesticide formulations. This methodology was based on the pesticide extraction with acetonitrile and subsequent transmittance measurement determination by peak area measurement between 2021 and 2047 nm, corrected with a single point baseline established at 2071 nm. The repeatability, as relative standard deviation of five independent analysis of a 15.3 mg g −1 Diuron standard was 0.03% and the limit of detection 0.013 mg g −1 . The reagent consumption was clearly reduced in front of a chromatographic reference procedure from 39.1 ml acetonitrile per sample, re…
A rapid and sensitive gas chromatography-mass spectrometry method for the quality control of perfumes: simultaneous determination of phthalates
2013
A rapid and sensitive analytical gas chromatography-mass spectrometry (GC-MS) method for perfume analysis to determine the phthalates banned by the European Union Regulation on cosmetic samples is presented. This method has been tested in commercial alcoholic perfume samples for the determination of the following seven phthalates: dibutyl phthalate, bis(2-ethylhexyl) phthalate, bis(2-methoxyethyl) phthalate, n-pentyl-isopentylphthalate, di-n-pentyl phthalate, diisopentylphthalate and benzyl butyl phthalate. Sample evaporation and redissolution in ethanol is carried out before GC-MS analysis, with no dilution of the sample. External calibration and standard addition calibration are compared …