Search results for "Pellets"

Volatile compounds extracted from polypropylene pellets by hot water: influence of the level of the peroxide agents

1992

To improve the quality level of plastic packaging materials, we determined the influence of chemical degradation of polypropylene (PP) upon the amount of volatile components extracted by hot water from PP pellets. Two formulations were analyzed and compared: PP CR (degraded) and PP (not degraded). After Likens-Nickerson's extraction of the pellets and concentration of the extract, an HPLC fractionation was made to collect three fractions of different poiarities: a pentane (A), a dichloromethane (B), and an ether (C) fraction. Fractions (B) and (C) were olfactively evaluated by GC sniffing to be most interesting. Their analysis by GC/MS coupling allowed the identification of different compon…

Identification of off-flavor compounds in high-density polyethylene (HDPE) with different amounts of abscents

1998

The use of synthetic pipes for drinking water distribution has increased. High desnity polyethylene (HPDE) is preferred because of its favorable mechanical properties, ease of handling during manufacturing, and low permeability to external contaminants. Off-flavor drinking water is a problem with plastic pipes. The compounds causing off-flavors are mainly carbonyl compounds. A combined zeolite called Abscents is used to eliminate odors and to remove odor-causing compounds. In this study, four different amounts of Abscents were added to raw HDPE pellets, and the influence on the off-flavor properties were analyzed. When the maximum amount of Abscents was added, almost all the carbonyl compou…

EPR RESPONSE OF PHENOLIC SOLID STATE PELLETS FOR DOSIMETRY OF RADIO- THERAPEUTIC PHOTON AND ELECTRON BEAMS

2020

Characterization of phenolic solid state pellets for ESR dosimetry with radio-therapeutic photon and electron beams

2018

Introduction Among the various dosimetric techniques used for characterizing the radiation beams used in radiation therapy, the electron spin resonance (ESR) arouses increasing interest for applications in various therapy procedures. In this work we report the ESR investigation of particular phenol compound (IRGANOX 1076) exposed to clinical photon and electron beams (Gallo et al., 2017). Methods Phenol (IRGANOX 1076 - Sigma Aldrich) pellets were produced also with paraffin (10% by weight). Phenol pellets were exposed to clinical photon and electron beams at various energies produced by a linear accelerator (LINAC) Siemens Primus (Siemens Medical Systems, CA, USA) installed at the Radiother…

A pilot-scale study of struvite precipitation in a stirred tank reactor: Conditions influencing the process

2008

Currently, the two most developed techniques for recovering phosphorus from wastewater consist of the formation of calcium phosphates and struvite (MgNH(4)PO(4).6H(2)O). In this work the influence of the operational conditions on the struvite precipitation process (pH in the reactor, hydraulic retention time, and magnesium:phosphorus, nitrogen:phosphorus, and calcium:magnesium molar ratios) have been studied. Twenty-three experiments with artificial wastewater were performed in a stirred reactor. In order to obtain the pH value maintenance during the crystallization process, a fuzzy logic control has been developed. High phosphorus removal efficiencies were reliably achieved precipitating t…

Chlorinated dioxins and dibenzothiophenes in fly ash samples from combustion of peat, wood chips, refuse derived fuels and liquid packaging boards

1995

Abstract Peat, wood chips, refuse derived fuel and liquid packaging board in different combinations were burned at a temperature of at least 850 °C. Fly ash samples from these combustions were analyzed for polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzothiophenes (PCDBTs) by high resolution GC/MS. The concentrations of tri- and tetrachlorodibenzothiophenes and tri-, tetra- and pentachlorodioxins were highest when mixtures of wood chips and refuse derived fuel (RDF) were burned. The fly ash from the combustion of pure peat pellets did not contain any polychlorinated dibenzothiophenes. When wood chips and RDF were burned the concentrations of chlorinated compounds in fly…

Electric Field Effect on the Thermal Decomposition and Co-combustion of Straw with Solid Fuel Pellets

2019

The aim of this study was to provide more effective use of straw for energy production by co-firing wheat straw pellets with solid fuels (wood, peat pellets) under additional electric control of the combustion characteristics at thermo-chemical conversion of fuel mixtures. Effects of the DC electric field on the main combustion characteristics were studied experimentally using a fixed-bed experimental setup with a heat output up to 4 kW. An axisymmetric electric field was applied to the flame base between the positively charged electrode and the grounded wall of the combustion chamber. The experimental study includes local measurements of the composition of the gasification gas, flame tempe…

Catalytic hydrothermal liquefaction of municipal sludge assisted by formic acid for the production of next-generation fuels

2021

Abstract Hydrothermal liquefaction (HTL) of municipal sludge (MS) was studied at 325 °C and 30 min at 10 and 30% w/w concentration of MS using formic acid (FA) as a green liquid hydrogen donor both in the absence and in the presence of heterogeneous catalysts. Pellets of commercial NiMo/Al2O3, CoMo/Al2O3 and felt of activated carbon ACF 1600 were used as catalysts. The addition of FA at high MS loading allowed to increase the yields in BC from 41 to 62% and its H/C ratio from 1.80 to 2.01 leading to energy recovery (ER) higher than 100%.When heterogeneous catalysts were used together with FA, a marked improvement of BC yields and quality was obtained at 10% MS loading. This behavior was not…

Who eats first? Uptake of pellet bait by target and non-target species

2002

House mice (Mus domesticus) are an important vertebrate pest in Australian agriculture. We studied the uptake of non-toxic placebo bait pellets targeted on house mice from bait stations in the grain-growing region of southeastern Australia. Bait stations allowed access for either ants; ants and mice or ants, mice, and birds. Soy meal bait pellets offered in December were of low preference for both ants and mice, but were eaten by birds in one study plot. In January, there were no differences between bait stations in the amount of wheat bait pellets removed indicating that the pellet bait had been primarily removed by ants. Most pellet bait was removed during the first 12 h after distributio…

The Properties Of Commercial Alumina Base Materials And Their Effect On The Manufacture Of Active Porous Alumina Supports By Means Of Extrusion

1983

The behaviour of 60 commercial base aluminas (macrocrystalline non-porous gibbsites, microcrystalline non-porous and porous boehmites, thermally activated porous boehmites and gibbsites) was studied via paste processing and extrusion in order to produce active porous alumina pellets. The most decisive properties of the base materials with respect to extrusion were: the degree of dehydration, the mean of aggregate size, the shape of aggregate size distribution, the shape of aggregates, the size of primary crystallites and the specific surface area. The relevance of these properties to those of the final pellets, i.e. crushing strength, porosity, pore volume distribution and specific surface …