Search results for "Permittivity"

PLZTx/65/35 ceramics (x = 2 and 4) under electromechanical and temperature loading

2010

The effect of uniaxial pressure (0–1000 bars) applied parallel to the ac electric field on dielectric properties of La-modified lead–zirconate–titanate, Pb(Ti,Zr)O3 (PZT), ceramics with Zr/Ti ratio of 65/35 was investigated. The experimental results revealed that applying uniaxial pressure leads to a reduction of the peak intensity of the electric permittivity (e), of the frequency dispersion as well as of the dielectric hysteresis. Moreover, with increasing pressure, the peak intensity of e becomes diffuse and shifts to a higher temperature. It was concluded that applying uniaxial pressure induces similar effects as increasing the Ti–ion concentration in PZT system. The obtained results we…

Distribution of the relaxation times of the new relaxor 0.4PSN–0.3PMN–0.3PZN ceramics

2005

Abstract The real distribution function of the relaxation times g ( τ ) of the relaxor ferroelectric ceramics 0.4PSN–0.3PMN–0.3PZN is calculated from the experimental dielectric spectra obtained in the frequency range from 20 Hz to 1.25 GHz. Below the Burns temperature T B  ≅ 380 K, where the clusters begin to appear on cooling, the distribution of the relaxation times is symmetrically shaped. On cooling, the permittivity and loss spectra strongly broaden and slow down. The g ( τ ) function becomes asymmetrically shaped and the second maximum appears. The width of the g ( τ ) function is calculated at different temperatures. The shortest relaxation time is of the order of 10 −12  s and it r…

Crystal chemical and dielectric properties of Pb0.5(5-x)LaxNb5-xFexO15system with “tetragonal tungsten bronze” structural type

2005

The lanthanum-lead and iron-niobium coupled substitution in PbNb 2 O 6 have allowed to isolate new materials of a general formula Pb 0.5(5-x) La x Nb 5-x Fe x O 15 crystallising with the tetragonal tungsten bronze structural type. The resulting influence on the lattice parameters, the ferroelectric Curie temperature and Cole - Cole plots are presented. A typical ferroelectric - paraelectric behaviour occurs in the composition range 0 ≤ x ≤ 0.33 while, a relaxor behaviour is observed in the composition range 0.33 < x < 1.

Dielectric Measurements on SBN:Ce

1995

New ferroelectric materials on the basis of PbSc1/2Nb1/2O3–PbLu1/2Nb1/2O3 solid solutions

2004

Abstract Original binary solid solutions PbSc 1/2 Nb 1/2 O 3 –PbLu 1/2 Nb 1/2 O 3 (PSN-PLuN) have been produced. First of all nominally pure PSN and PLuN were synthesized by solid state reaction from oxides and carbonates. These compounds were mixed in different proportions to obtain (1− x )PSN− x PLuN solid solutions. Ceramic samples were hot-pressed at gradual change of the temperature. Solid solutions have the perovskite structure and are completely soluble in each other. Differential thermal analysis and X-ray diffraction were used to examine the synthesis and phase constitution. Dielectric properties—dielectric permittivity e and dielectric loss tan δ of ceramic samples of originally s…

BST ceramics: Effect of attrition milling on dielectric properties

2004

Abstract The effect of grain size on the dielectric properties of Ba0.6Sr0.4TiO3 (BST) ceramics is investigated. Attrition milling is chosen to obtain nanometre particle size from micrometre particle size powders. Fine grained ceramics are obtained by hot uniaxial pressing (HUP). Additionally, the present study is focused on the effect of the nature of milling balls on loss tangent and permittivity. For that, three kinds of balls are tested: calcia, yttria or ceria stabilised zirconia balls. The properties of these samples are evaluated in the range of MHz. The balls induce an involuntary doping of powders which modifies the dielectric properties, especially the Curie temperature and loss t…

Dielectric properties and partial discharge endurance of polypropylene-silica nanocomposite

2010

This paper presents the results of the dielectric properties and partial discharge endurance measurements conducted on polypropylene (PP)-silica nanocomposite. The material compounds were analyzed with micro-Raman spectroscopy, X-ray tomography and transmission electron microscopy (TEM). ac and dc breakdown strength of the materials was measured. Dielectric response, capacitance and loss factor of the film samples were measured as a function of temperature and frequency. Partial discharge (PD) endurance of the reference PP and PP Silica nanocomposite was studied as a function of ac voltage. Material surfaces were analyzed after PD stress with optical microscopy. All dielectric measurements …

Ferroelectricity and piezoelectricity in soft biological tissue: Porcine aortic walls revisited

2017

Recently reported piezoresponse force microscopy (PFM) measurements have proposed that porcine aortic walls are ferroelectric. This finding may have great implications for understanding biophysical properties of cardiovascular diseases such as arteriosclerosis. However, the complex anatomical structure of the aortic wall with different extracellular matrices appears unlikely to be ferroelectric. The reason is that a prerequisite for ferroelectricity, which is the spontaneous switching of the polarization, is a polar crystal structure of the material. Although the PFM measurements were performed locally, the phase-voltage hysteresis loops could be reproduced at different positions on the tis…

Optically assisted trapping with high-permittivity dielectric rings: Towards optical aerosol filtration

2016

Controlling the transport, trapping, and filtering of nanoparticles is important for many applications. By virtue of their weak response to gravity and their thermal motion, various physical mechanisms can be exploited for such operations on nanoparticles. However, the manipulation based on optical forces is potentially most appealing since it constitutes a highly deterministic approach. Plasmonic nanostructures have been suggested for this purpose, but they possess the disadvantages of locally generating heat and trapping the nanoparticles directly on surface. Here, we propose the use of dielectric rings made of high permittivity materials for trapping nanoparticles. Thanks to their abilit…

Effect of a filler on the dielectric properties of an epoxy resin

1983

The effect of aluminum hydroxide upon the dielectric properties of an epoxy resin has been studied in a wide frequency and temperature range. An interfacial polarization effect, known as the Maxwell–Wagner–Sillars polarization is evidenced for the filled resin, which shows a higher permittivity, a higher dielectric loss, and a β transition with a larger relaxation time. The glass transition temperature is, on the contrary, mostly unaffected by the presence of the filler.