Search results for "Photocatalysis."
showing 10 items of 584 documents
Influence of fluorine on the synthesis of anatase TiO2for photocatalytic partial oxidation: Are exposed facets the main actors?
2018
Anatase TiO2 samples were synthesized in the presence of different amounts of HF acid with the aim of understanding the effect of the presence of fluorine on the photocatalytic activity. It is well known that the presence of fluoride ions influences the photocatalytic performance by adsorption on the surface of TiO2 and that they are capping agents in the control of specific exposed facets. The samples were characterized by X-ray diffraction (XRD), Raman spectroscopy, nitrogen adsorption–desorption measurements, scanning electron microscopy (SEM), transmission electron microscopy (TEM), UV-vis spectrophotometry, and X-ray photoelectron spectroscopy (XPS). The photocatalytic activity was eva…
PHOTOCATALYTIC ACTIVITY OF TIO2 IN ITS POLYMORPHIC FORMS ANATASE, BROOKITE AND RUTILE
2012
Determination of the crystallinity of TiO2 photocatalysts
2018
Abstract This study reports a new simple method to determine the crystallinity of anatase and rutile TiO2 photocatalysts. The crystallinity degree of various anatase and rutile samples was estimated by XRD analysis from the ratio among the full width at half maximum intensities of the main diffraction peaks of anatase or rutile and the (111) peak of CaF2 as internal standard. The photocatalytic activity of selected powders was tested employing the photodegradation of 4-nitrophenol in aqueous solution as probe reaction. The results showed that the photoactivity of the investigated samples increased with increasing crystallinity and crystallite size.
Photocatalytic activity of nanocrystalline TiO2 (brookite, rutile and brookite-based) powders prepared by thermohydrolysis of TiCl4 in aqueous chlori…
2008
Abstract Nanocrystalline TiO2 powders were synthesized by thermohydrolysis of TiCl4 in HCl or NaCl aqueous solutions. Rutile, mixtures of brookite and rutile or mixtures of anatase, brookite and rutile were obtained depending on the acidity of the medium. Crystalline phases and composition of the mixtures were identified by using XRD analysis. Pure brookite nanoparticles, separated from the mixtures of brookite and rutile by simple peptization with water, were stable against transformation to rutile up to 750 °C. The prepared TiO2 powders were characterized by thermal analysis, diffuse reflectance spectroscopy and BET surface area determinations. The band gap of bulky brookite was estimated…
Photoactivity of Nanostructured TiO2 Catalysts in Aqueous System and their Surface Acid-Base, Bulk and Textural Properties
2007
This work reports on the characterisation and determintion of the photocatalytic activity of some TiO2 catalysts prepared using TiCl4 as precursor. The samples, consisting of suspensions, dispersions or powders of nanonstructured anatase or rutile phases, were obtained in very mild conditions, i.e., by boiling the solution obtained after hydrolysis of TiCl4 at atmospheric pressure: it is worth noting that no calcination was necessary to obtain photoactive phases. The samples were characterised by X-ray diffraction (XRD), determination of the BET specific surface area (SSA), scanning electron microscopy (SEM) observations and diffuse reflectance spectroscopy (DRS). FT-IR spectroscopy was use…
Visible light photocatalytic activity of macro-mesoporous TiO2-CeO2inverse opals
2018
Macro-mesoporous TiO2 inverse opal materials were synthesized and they were tested as photocatalysts under visible light irradiation. The influence of cerium oxide addition towards the Rhodamine B (RhB) photodegradation activity was evaluated. Structural, textural, spectral and surface properties of the TiO2-CeO2 inverse opal nanocomposites were studied by XRD, XPS, SEM, TEM, N2 adsorption-desorption, Diffuse Reflectance UV–vis and Photoluminescence spectroscopies. Compared to commercial TiO2 anatase, the macro-mesoporous TiO2 inverse opal exhibited six times higher kinetic rate constant in the RhB degradation under visible light irradiation. The good photocatalytic activity was related to …
Turning lipophilic phthalocyanines/TiO2 composites into efficient photocatalysts for the conversion of CO2 into formic acid under UV–vis light irradi…
2014
Metal-free, Cu(II)- or Zn(II) tetrakis [4-(2,4-bis-(1,1-dimethylpropyl)phenoxy)]phthalocyanines loaded over TiO2 (anatase) proved to be active in the photoreduction of CO2 to formic acid (HCO2H) in water under UV-vis light. CuPc/TiO2 is catalyst of choice, allowing to reach a maximum yield of HCO2H, unequalled by any other similar catalytic systems. Because of their low environmental impact, low potential cost, and efficient power conversion, these multipurpose materials show promise in the setup of sustainable methods for CO2 valorization. (C) 2014 Elsevier B.V. All rights reserved.
Influence of metallic silver and of platinum-silver bimetallic deposits on the photocatalytic activity of titania (anatase and rutile) in organic and…
1998
Abstract The influence of deposited silver upon the photocatalytic activity of titania in the rutile and anatase allotropic forms has been studied in three different reactions. The common feature found for these three reactions was an electron transfer from illuminated TiO 2 to silver particles. In the first reaction (platinum photodeposition). it has been shown that the initial presence of metallic silver orientates the localization of subsequent Pt photodeposits with, in particular, a 100% selectivity to Pt deposition on top of silver particles or agglomerates previously deposited on anatase. In the second reaction (2-propanol oxidation), Ag deposit was found beneficial for the activity o…
A structural investigation of titanium dioxide photocatalysts
1991
Abstract A study of the structure and the morphology of a titanium dioxide photocatalyst (Degussa P25) reveals multiphasic material consisting of an amorphous state, together with the crystalline phases anatase and rutile in the approximate proportions 80 20 . Transmission electron microscopy provides evidence that some individual particles are a mixture of the amorphous state with either the anatase phase or with the rutile phase, and that some particles, which are mostly anatase, are covered by a thin overlayer of rutile which manifests its presence by the appearance of Moire fringes. The photocatalytic activity of this form of titanium dioxide is reported as being greater than the activi…
Alkaline treatment as a means to boost the activity of TiO(2)in selective photocatalytic processes
2020
In this work, the activity enhancement of TiO(2)photocatalysts by alkaline treatment has been investigated. Commercial (BDH, U.K., anatase phase) TiO(2)samples, treated in alkaline solutions of NaOH at different concentrations and temperatures, were tested for the photocatalytic partial oxidation of 3-pyridinemethanol in water under UVA irradiation to form vitamin B-3. Photocatalyst characterization has been carried out by XRD, BET, TEM, TGA, photoluminescence, FTIR, Raman, DRS, EPR and photocurrent measurements. The alkaline-treated samples showed an increased activity of up to 7 times (by considering first order rate constant values) compared to untreated BDH and the superior performance …