Search results for "Photodegradation"

Photodegradation kinetics of aniline, 4-ethylaniline, and 4-chloroaniline in aqueous suspension of polycrystalline titanium dioxide

2000

The photodegradation process of aniline, 4-ethylaniline, and 4-chloroaniline in aqueous suspension of irradiated TiO2 (anatase) powder has been investigated. A batch photoreactor with immersed lamp irradiating in the near-UV region has been used for carrying out the reactivity experiments. For each substrate the influence of the initial concentration of organic compound and of pH on the degradation rate has been investigated. The main intermediates and the end products have been identified and determined, the total mass balance being satisfied. The kinetic modelling of the series of reactions occurring in the system has been satisfactorily carried out with a Langmuir-Hinshelwood rate law. T…

High photodegradation and antibacterial activity of BN–Ag/TiO 2 composite nanofibers under visible light

2018

To develop material with good photocatalytic properties for organic compound degradation and bacterial removal, we produced Ag/TiO2 and BN–Ag/TiO2 composite nanofibers that included controlled amounts of boron nitride (BN) nanosheets and silver (Ag). After annealing at 500 °C under air, we used scanning electron microscopy, transmission electron microscopy, Brunauer–Emmet–Teller analysis, X-ray diffraction, energy-dispersive X-ray spectroscopy, Raman spectroscopy, UV-visible reflectance spectroscopy and room temperature photoluminescence to investigate the morphological, structural and optical properties of all samples. The photocatalytic tests using methylene blue under visible light, in r…

Photocatalytic oxidation of phenol on TiO2 powders. A Fourier transform infrared study

1994

Abstract In the present paper a detailed investigation of a well known photoreaction, i.e. phenol photodegradation in the presence of TiO2, has been carried out. The Fourier transform infrared (FT-IR) technique has been used to characterize the catalyst surface and to follow the photoprocess by “in situ” measurements in a gas—solid regime, simulating the aqueous liquid—solid regime in which this photodegradation reaction has been usually carried out. The influence on the photoprocess of the surface hydroxylation of the catalyst has been investigated and the presence of some reaction intermediates has been revealed by FT-IR. The experimental results have demonstrated that the chosen gas—soli…

Photocatalytic oxidation of toluene on irradiated TiO2: comparison of degradation performance in humidified air, in water and in water containing a z…

2003

Photocatalytic degradation of toluene was carried out both in gas–solid and in liquid–solid regime by using polycrystalline samples of TiO2 Merck and TiO2 Degussa P25. For the gas–solid regime two types of continuous photoreactor were used, a fixed bed one of cylindrical shape and a Carberry type photoreactor, both irradiated by near-UV light. The inlet reacting mixture consisted of air containing toluene and water vapours. The influence of the gas flow rate and the presence of water vapour on the photocatalytic process was investigated. CO2 and benzaldehyde were the toluene degradation products detected in the gas phase by using TiO2 Merck. In the presence of water vapour this catalyst exh…

ZnO nanorods covered with a TiO2 layer: simple sol–gel preparation, and optical, photocatalytic and photoelectrochemical properties

2015

In this work, composite core–shell ZnO/TiO2 materials were fabricated by deposition of TiO2 layers via a sol–gel method onto ZnO nanorods hydrothermally grown on an ITO electrode. Two approaches to the sol–gel procedure resulted in strongly different morphologies and thicknesses of the deposited TiO2 layer, as shown in electron microscopy studies. The decrease of the optical band gap energies of the ZnO/TiO2 composites by about 0.2–0.3 eV with respect to the TiO2 nanoparticles and ZnO nanorods was determined from UV-Vis diffuse reflectance spectra. The photocatalytic activities of the systems were determined by investigation of the decolorization of Methylene Blue (MB) in aqueous solution, …

Removal of drugs in aqueous systens by photoassisted degradation

2005

Aqueous solutions of tetracycline, lincomycin and ranitidine were irradiated with UV light in homogeneous and heterogeneous systems. Two commercial polycrystalline TiO2 powders (Degussa P25 and Merck) were used as photocatalysts. After 5A h, an appreciable photolytic degradation of tetracycline and ranitidine was observed while the degradation of lincomycin was noticeably lower. As far as the mineralization is concerned, a small decrease of the TOC values was measured in the case of tetracycline whereas negligible variations were found for lincomycin or ranitidine. The presence of the photocatalysts greatly enhanced the degradation rates of the drugs with respect to those observed during th…

ChemInform Abstract: Coupled Semiconductor Systems for Photocatalysis. Preparation and Characterization of Polycrystalline Mixed WO3/WS2 Powders.

2010

Mixed WO3/WS2 powders were prepared by oxidation of WS2. The physical properties of the samples were characterized by X-ray diffraction, diffuse reflectance spectroscopy, and scanning electron microscopy; they were strongly dependent upon the time and temperature of oxidation. The chemical state and the elemental distribution of the sample surface were investigated by X-ray photoelectron spectroscopy. The photocatalytic results have showed that the aqueous suspensions of the mixed WO3/WS2 systems have significantly higher activities than pure WS2 and WO3 for the photodegradation of phenol. The enhanced performance can be related to the presence of heterojunctions WO3/WS2 on the single parti…

FI-chemiluminometric study of thiazides by on-line photochemical reaction

2004

The present manuscript deals with a simple and sensitive flow-injection method for the chemiluminescent determination of thiazides. The method is based on the on-line photodegradation and chemiluminescent determination of the resulting photo-fragments. The on-line photodegradation is performed in basic medium by using a photoreactor consisting of a 550 cm long x 0.8 mm ID piece of PTFE tubing helically coiled around an 8 W low-pressure mercury lamp. The determination of the photo-irradiated thiazides is performed by a chemiluminescent oxidative reaction with Ce(IV) in sulphuric acid medium. A heterogeneous group of thiazides (indapamide, metolazone, hydroflumethiazide, chlorthalidone and be…

1984

Surface characterisation of metal ions loaded TiO2 photocatalysts: structure–activity relationship

2004

Abstract Transition metal loaded TiO 2 powders were characterised and tested for the photodegradation of some organic acids. Both Lewis and Bronsted surface acid sites were present in the samples containing large amounts of Mo, V and W. The Bronsted sites are associated to the presence of the transition metals as they do not exist in the unloaded support, and in particular to the presence of these metals in high oxidation states. The trend of the pzc values of the various powders matches rather well both with the surface acidity of the samples experimentally determined by NH 3 adsorption and with a scale of acidity/basicity for bulk binary oxides. XPS investigation indicates that only the p…