Search results for "Photodetector"

Solar blind detectors based on AlGaN grown on sapphire

2005

Solar blind detectors have been fabricated based on AlGaN heterostructures grown on sapphire by molecular beam epitaxy or chemical vapour deposition. MSM and Schottky detectors were investigated. High performance devices have been obtained thanks to an optimization of the material crystalline quality (including the suppression of cracks) and of the process. We show that the spectral limitations of MSM detectors are dictated by intrinsic phenomena that are analysed in details while the responsivity and detectivity also depends on the technological process with a special emphasis on the geometry of finger and contact pads. One and two dimensional arrays have been fabricated and preliminary re…

Potential application of some wide band gap materials for UV dosimetry

2005

Properties of some wide band gap materials–natural and CVD diamonds – have been studied for their potential application in UV dosimetry, using methods of optically stimulated luminescence and thermoluminescence. The observed properties are compared with those of the previously studied AlN ceramics. From the OSL excitation spectra, it follows that spectral sensitivity of the studied materials falls mainly into the UVC range, OSL and TL emission spectra are located within the visible light region, thus suitable for usual photodetectors. OSL stimulation spectra of the studied materials have a continuous character and are located in a broad visible/near infrared spectral region implying that th…

Photodétecteurs UV à base GaAlN

2004

Mode family analysis for PMMA WGM micro resonators using spot intensity changes

2021

The whispering gallery modes (WGM) micro resonators are based on elliptical objects, which can be made from optically transparent materials, The geometry of the object enables optical wave circulating inside the ellipse using total internal reflection. If there is a monochromatic light source with constant intensity to the ellipse, constructive interference may be observed. Poly methyl methacrylate acrylic (PMMA) WGM micro resonators are commercially available with typical optical quality factor of 103-104. These could limit problems with WGM micro resonator expensive manufacturing. Thanks to advances in high resolution image processing, read-outs using spectroscopy (single photo detector) …

Ligand-Length Modification in CsPbBr3 Perovskite Nanocrystals and Bilayers with PbS Quantum Dots for Improved Photodetection Performance

2020

Nanocrystals surface chemistry engineering offers a direct approach to tune charge carrier dynamics in nanocrystals-based photodetectors. For this purpose, we have investigated the effects of altering the surface chemistry of thin films of CsPbBr3 perovskite nanocrystals produced by the doctor blading technique, via solid state ligand-exchange using 3-mercaptopropionic acid (MPA). The electrical and electro-optical properties of photovoltaic and photoconductor devices were improved after the MPA ligand exchange, mainly because of a mobility increase up to 5 &times

Design and development of a continuous wave functional near infrared spectroscopy system

2014

Functional Near InfraRed Spectroscopy uses light sources and optical detectors for human brain monitoring. In this paper, a portable, low cost, battery-operated, multi-channel, continuous wave fNIRS embedded system, hosting up to 64 LED sources and 128 Silicon PhotoMultiplier optical detectors, is reported on. The designed system is based on a scalable architecture, in which each probe consists of 8 modular and flexible stands, able to host 4 bi-color LEDs as light sources, 16 silicon photomultipliers as photodetectors and a temperature sensor. The hardware structure allows to easily set up several relevant parameters: the timing of the LEDs, the optical power emitted by the LEDs; the acqui…

Design of a Multichannel Continuous Wave fNIRS System implemented with SiPM

2013

Development of a CW-fNIRS System for brain monitoring

2014

Progettazione e realizzazione di un sistema Continuous Wave fNIRS basato su tecnologia SiPM

2014

Progettazione e realizzazione di un sistema Continuous Wave fNIRS basato su tecnologia SiPM

Optical techniques represent a suitable tool for in vivo and non-invasive diagnosis of human brain and tissues. Functional Near InfraRed Spectroscopy (fNIRS) is revealing as an emerging neuroimaging technology, since it is safe, relatively inexpensive and little cumbersome. fNIRS relies on the measurement of the oxygen concentration in the blood by means of light beams impinging on the tissues under test. Haemoglobin concentration variations (oxygenated/deoxygenated) can provide very important information on brain activity and allow to discriminate the main brain area involved during tests. Herein, we present the design and development of an innovative solution for a portable continuous wav…