Search results for "Photometry"
showing 10 items of 797 documents
Arsenic content of Spanish cows' milk determined by dry ashing hydride generation atomic absorption spectrometry.
1994
SummaryThe arsenic content of cows' milk consumed in Spain was determined. A procedure using dry ashing hydride generation atomic absorption spectrometry was developed for the purpose. Experimental conditions for the destruction of organic matter were established and an interference study was carried out. The method developed has a detection limit of 0·1 ng/g, a relative SD of 5%, and a recovery (mean ± CSI) of 100 ± 4%. The accuracy of the method was checked by analysis of a certified sample of IAEA milk powder (mean ± CSI: certified, 4·85 ± 0·32 ng/g; found, 5·04 ± 0·81 ng/g). The proposed procedure was used to analyse cows' milk samples. The extremely low arsenic levels found do not pres…
Speciation of chromium in natural waters by micropumping multicommutated light emitting diode photometry.
2007
Abstract A simple and sensitive multicommutated flow procedure, implemented by employing a homemade light emitting diode (LED) based photometer, has been developed for the determination of chromium (VI) and total chromium in water. The flow system comprised a set of four solenoid micro-pumps, which were assembled to work as fluid propelling and as commutating devices. The core of the detection unit comprised a green LED source, a photodiode and a homemade flow cell of 100 mm length and 2 mm inner diameter. The photometric procedure for the speciation of chromium in natural waters was based on the reaction of Cr (VI) with 1,5-diphenylcarbazide. Cr (III) was previously oxidized to Cr (VI) and…
Thermal lens spectrometric determination of cerium with oxine
1991
Abstract The spectrophotometric and photothermal (TLS) procedures for cerium determination using 8-hydroxyquinoline (oxine), after extraction into chloroform, are compared. Photothermal measurements are made using a coaxial pump/probe thermal lens spectrometer. The use of high-purity reagents at low concentrations permits a decrease in the TLS blank signal and noise, leading to a limit of detection of 9 × 10−9 M (cerium extract concentration), 40-fold lower than the spectrophotometric value. The dynamic range extended up to 6 × 10−7 M and the relative standard deviation for 5 × 10−7 M cerium was 3.9%.
3D and multispectral imaging for subcutaneous veins detection.
2009
The first and perhaps most important phase of a surgical procedure is the insertion of an intravenous (IV) catheter. Currently, this is performed manually by trained personnel. In some visions of future operating rooms, however, this process is to be replaced by an automated system. Experiments to determine the best NIR wavelengths to optimize vein contrast for physiological differences such as skin tone and/or the presence of hair on the arm or wrist surface are presented. For illumination our system is composed of a mercury arc lamp coupled to a 10nm band-pass spectrometer. A structured lighting system is also coupled to our multispectral system in order to provide 3D information of the p…
Ligand effects on the structures and magnetic properties of tricyanomethanide-containing copper(II) complexes.
2007
The preparation, crystal structure and magnetic properties of four heteroleptic copper(II) complexes with the tricyanomethanide (tcm(-)) and the heterocyclic nitrogen donors 3,6-bis(2-pyridyl)pyridazine (dppn), 2,5-bis(2-pyridyl)pyrazine (2,5-dpp), 2,3-bis(2-pyridyl)pyrazine (2,3-dpp) and 2,3-bis(2-pyridyl)quinoxaline (2,3-dpq) are reported, {[Cu(2)(dppn)(OH)(tcm)(2)] x tcm}(n) (1), {[Cu(2,5-dpp)(tcm)] x tcm}(n) (2), {[Cu(2)(2,3-dpp)(2)(tcm)(3)(H(2)O)(0.5)] x tcm x 0.5H(2)O}(n) (3) and [Cu(2,3-dpq)(tcm)(2)](n) (4). 1 has a ladder-like structure with single mu-1,5-tcm ligands forming the sides and a bis-bidentate dppn and a single mu-hydroxo providing the rung. Each copper atom in 1 exhibits…
A method for the determination of dimethylamine in air by collection on solid support sorbent with subsequent derivatization and spectrophotometric a…
2005
A new method for dimethylamine determination in air is reported. The proposed assay is based on the employment of C18-packed solid phase extraction cartridges for sampling. The retained amine is then derivatized inside the cartridges with the reagent 1,2-naphthoquinone-4-sulfonate. By observing the coloured area of the cartridge, a semiquantitative estimation of the amine can be made. It was also possible to distinguish between primary and secondary amines by visual inspection. Quantitative tests entailed desorption from the cartridges of the derivatives formed, and measurement of the absorbance of the collected extracts. The selected conditions were applied to quantify dimethylamine up to …
Sensitive determination of aliphatic amines in water by high-performance liquid chromatography with chemiluminescence detection.
2004
A sensitive method has been developed for liquid chromatographic determination of short aliphatic amines in water samples. Analytes are preconcentrated and dansylated on solid sorbents (C18 solid-phase extraction cartridges). The dansyl derivatives are chromatographed and post-column mixed with peroxyoxalate (TCPO) and H2O2 in order to perform chemiluminescence detection. Optimal results have been obtained using a sample volume of 5 ml. The method has been applied to the quantification or screening of several aliphatic amines: methylamine, ethylamine, butylamine, diethylamine, pentylamine and hexylamine. The screening procedure has been developed including also polyamines (putrescine, cadav…
CuInS2 Films for Photovoltaic Applications Deposited by a Low-Cost Method.
2006
We report an atmospheric-pressure deposition method for preparing well-adhered and compact CuInS 2 films. The precursor film is obtained by a solution-coating technique and is subjected to a low-cost and safe one-step reduction-sulfurization treatment. A maximum thickness of 300 nm is achieved per layer, and up to three layers were sulfurized at a time. The obtained films were characterized by X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM) and visible-near-infrared (vis-NIR) spectrophotometry.
Synthesis and Spectroscopic Properties of Silica−Dye−Semiconductor Nanocrystal Hybrid Particles
2010
We prepared silica-dye-nanocrystal hybrid particles and studied the energy transfer from semiconductor nanocrystals (= donor) to organic dye molecules (= acceptor). Multishell CdSe/CdS/ZnS semiconductor nanocrystals were adsorbed onto monodisperse Stöber silica particles with an outer silica shell of thickness 2-23 nm containing organic dye molecules (Texas Red). The thickness of this dye layer has a strong effect on the energy transfer efficiency, which is explained by the increase in the number of dye molecules homogeneously distributed within the silica shell, in combination with an enhanced surface adsorption of nanocrystals with increasing dye amount. Our conclusions were underlined by…
Evaluation of the pH effect of formulations on the skin permeability of drugs by biopartitioning micellar chromatography☆
2004
Dermal absorption of chemicals is an area of increasing interest for the pharmaceutical and cosmetic industries, as well as in dermal exposure and risk assessment processes. Biopartitioning micellar chromatography (BMC) is a mode of reversed phase micellar chromatography that has proved to be useful in the description and prediction of several pharmacological properties of xenobiotics including oral drug absorption, ocular and skin drug permeability. The present paper deals with the application of biopartitionig micellar chromatography to evaluate the pH effect on the skin permeability of twelve non-steroidal anti-inflammatory drugs and lidocaine. For this purpose the BMC retention of the w…