Search results for "Plastics"

Mechanical properties of recycled polymers

1999

Modifications of structure and morphology of the polymers induced by the thermomechanical stress (or by the presence of water for some polymers) during reprocessing can cause a drastic deterioration of mechanical properties of the recycled material. The property reprocessing relationships are an important tool to determine not only the properties of the recycled polymers but also the strategies to use (processing conditions, stabilizers, fillers, compatibilizers, etc) in order to obtain recycled polymers with good mechanical properties. In this work, typical behaviour of some mechanical properties as a function of the number of reprocessing operations is discussed and correlated with their …

Structural and morphological rearrangements in quenched poly(ethylene) by simultaneous SAXS/WAXS

2000

Structure formation by crystallization from the melt in a wide range of cooling rates (0.08-1 000°C/s) in low-density polyethylene has been studied by simultaneous small- and wide-angle X-ray scattering at the synchroton radiation source of DESY. The occurrence of two periodicities, characterized by different angular position of Bragg's maxima, was observed, pointing to the existence of two types of lamellar stacks, associated with two different long period values L 1 and L 2 (L 1 > L 2 ). L 1 depends on the cooling rate, whereas L 2 is almost constant. A comparison with isotactic polypropylene is performed, where a similar phenomenon takes place. While in the case of i-PP a definite correl…

Poly(N-isopropylacrylamide)-Modified Styrene-Butadiene Rubber as Thermoresponsive Material

2013

Fluorescence microscopy studies of layer/substrate interaction during the Langmuir-Blodgett transfer: Fractional condensation and local layer modific…

1991

Transfer fluorescence microscopy reveals the substrate-mediated fractional condensation and phase-selective deposition of dipalmitoylphosphatidylcholine (DPPC) and dimyristoylphosphatidylethanolamine (DMPE) monolayers during the LB-transfer. Preferentially the higher ordered liquid-condensed (LC) state is transferred onto the substrate during the transfer of a monolayer in the LC/LE (liquid/expanded) coexistence state on the water subphase. This is manifested in the directly observable attraction of LC-domains towards the three-phase line and observation of a domain-free gap as consequence of the segregation of the fluorescent probe into the floating monolayer adjacent to the three-phase li…

Hydrogels for potential colon drug release by thiol-ene conjugate addition of a new inulin derivative.

2008

Inulin was chosen as a starting polymer for biocompatible, pH-sensitive and biodegradable hydrogels. Three INUDVSA-TT hydrogels were obtained by crosslinking inulin derivatives with trimethylolpropane tris(3-mercaptopropionate) under varying conditions. The resulting hydrogels were cell compatible, as demonstrated by MTS and trypan blue exclusion assays acting on Caco-2 cells, and were biodegraded by inulinase and esterase, thus suggesting their use as colonic drug delivery systems. 2-Methoxyestradiol, an anti-cancer drug, was soaked in INUDVSA-TT hydrogels and its in vitro release and apoptotic effect on Caco-2 cells were evaluated.

Copolymerization of VDF and HFP in Supercritical Carbon Dioxide: A Robust Approach for Modeling Precipitation and Dispersion Kinetics

2011

A kinetic model is developed for the heterogeneous free-radical copolymerization of vinylidene fluoride and hexafluoropropylene in supercritical CO2. The model accounts for polymerization in both the dispersed (polymer-rich) phase and in the continuous (polymer-free) supercritical phase, for radical interphase transport, diffusion limitations, and chain-length-dependent termination in the polymer-rich phase. A parameter evaluation strategy is developed and detailed to estimate most of the kinetic parameters a priori while minimizing their evaluation by direct fitting. The resulting model predictions compare favorably with the experimental results of conversion and MWD at varying monomer fee…

Temperature dependence of surface reorganization characteristics of amphiphilic block copolymer in air and in water studied by scanning force microsc…

2015

We have investigated the surface reorganization characteristics of a novel amphiphilic diblock copolymer, poly(acetic acid-2-(2-(4-vinyl-phenoxy)-ethoxy)-ethylester)-block-polystyrene (PAEES-b-PS), in response to varying interfaces from air to water and vice-versa at various temperatures. The surface reorganization characteristics of the block copolymer films was monitored by scanning force microscopy, in order to delineate the kinetically controlled morphological process of surface reorganization of a diblock copolymer, with a particular emphasis on the phase contrast signal which allowed the determination of local composition patterns of PAEES-b-PS at the surface. Upon heating a water-an…

Polymer Brushes on Flat and Curved Substrates: Scaling Concepts and Computer Simulations

2007

The scaling concepts for isolated flexible macromolecules in good solvent grafted with one chain end to a flat surface (polymer mushrooms) as well as for layers of many overlapping end-grafted chain molecules (polymer brushes) are introduced. Monte Carlo attempts to test these concepts are briefly reviewed. Then the extension of these concepts to polymer brushes grafted to the interior of a cylinder surface is discussed. Molecular Dynamics results on chain average linear dimensions in the direction normal to the grafting surface and in axial direction are described, as well as distribution functions for the density of end monomers and of all monomers of the chains. It is argued that under t…

Influence of surface morphology on melting of polymer crystals II. Loops of random length and partially random reentry

1972

Abstract The melting behavior of single crystals with loops of random length and partially random reentry has been calculated under two different assumptions: (1) at each temperature the loops have an equilibrium end-to-end distance distribution and (2) a certain end-to-end distance distribution of the loops, ω(h), determined by the kinetics of the crystallization is frozen in and maintained during the whole heating process. The ω(h) is calculated by considering the loop formation process during crystallization and by introducing a parameter λ which expresses the tendency of the chains for adjacent reentry. In both cases a melting range is obtained. In case 2, the melting range depends stro…

A new liquid surface neutron reflectometer and its application to the study of DPPC in a monolayer at the air/water interface

1991

A constant wavelength neutron reflectometer is described. Using this reflectometer, the neutron reflectivities from phosphatidylcholine monolayers in the highly condensed LC phase on ultra pure H2O and D2O have been measured on a Wilhelmy film balance. The neutron reflectivities have been carefully compared with those obtained by the X-ray method applied to the same monolayer under similar conditions. A new approach to analyzing a combined set of data composed of X-ray and neutron reflectivities has been used. From the analysis it is concluded that despite their limited qz range neutron reflectivities are as essential as X-ray reflectivities for the unique determination of the monolayer str…