Search results for "Plastics"

Structure and phase transitions of a liquid crystalline polymer

1981

The structures, textures as well as thermodynamic properties of a side chain polymer exhibiting a liquid crystalline phase in addition to a partially crystalline state and the isotropic fluid state were investigated. Furthermore the kinetics of phase transitions between these states were analyzed. It was found that the properties of this polymer are intermediate between that of low molecular weight liquid crystals and common polymers. In particular it was observed that the relation between the liquid crystalline texture and the structure is different from that of low molecular weight liquid crystals and that the properties of the crystalline and liquid crystalline state depend strongly on t…

How Structure-Related Collapse Mechanisms Determine Nanoscale Inhomogeneities in Thermoresponsive Polymers

2012

Continuous wave electron paramagnetic resonance (CW EPR) spectroscopy on the amphiphilic spin probe TEMPO in solutions of selectively chosen functional, thermoresponsive poly(propylene oxide) (PPO)- and poly(ethylene oxide) (PEO)-based copolymers of both linear and branched structure is used to elucidate their host–guest interactions and inverse phase transitions. Three different fundamental types of host–guest interactions between probes and polymers could be correlated to the phase transition mechanisms (supported by MD simulations), evidencing that these proceed via nanoscale inhomogeneities of the polymers. Because of their ability to host small amphiphilic guest molecules, thermorespon…

Liquid-liquid phase equilibria in polymer solutions and polymer mixtures

2002

The pressure dependence of liquid-liquid equilibria in weakly interacting binary macromolecular systems (homopolymer solutions and blends) will be discussed. The common origin of the separate high-temperature/low-temperature and high-pressure/low-pressure branches of demixing curves will be demonstrated by extending the study into the region of metastable liquid states including the undercooled, overheated and stretched states (i.e. states at negative pressures). The seemingly different response of the UCST-branch of solutions and blends when pressurized (pressure induced mixing for most polymer solutions, pressure induced demixing for most blends) will be explained in terms of the location…

Study of the micro-phase separation in LC-polymers with paired mesogens

1990

Differential scanning calorimetry and miscibility investigations were used to study the micro-phase separation of liquid-crystalline dimesogenic side-group polysiloxanes. Diluted co-polysiloxanes exhibit two glass transition temperatures and an unusual miscibility behavior. The observed biphasic character is compared with that of certain amphiphilic systems.

1995

Surfaces have a profound effect on the structure and related properties of multiphase polymeric materials, such as polymer mixtures and block copolymer mesophases. In particular, phase transitions in the bulk (unmixing, microphase separation, etc.) may be complemented by surface-induced transitions (formation of wetting layers, surface-directed spinodal decomposition, surface-induced ordering). This review gives a brief introduction to the phenomenological theories of such phenomena, emphasizing the simplest approach based on Flory—Huggins—de Gennes free energy functionals and associated Monte Carlo simulations. More sophisticated theories and recent experiments are mentioned briefly.

One- and two-component bottle-brush polymers: simulations compared to theoretical predictions

2007

Scaling predictions and results from self-consistent field calculations for bottle-brush polymers with a rigid backbone and flexible side chains under good solvent conditions are summarized and their validity and applicability is assessed by a comparison with Monte Carlo simulations of a simple lattice model. It is shown that under typical conditions, as they are also present in experiments, only a rather weak stretching of the side chains is realized, and then the scaling predictions based on the extension of the Daoud-Cotton blob picture are not applicable. Also two-component bottle brush polymers are considered, where two types (A,B) of side chains are grafted, assuming that monomers of …

A kinetic study of the formation of smectic phases in novel liquid crystal ionogens

2013

[EN] A multi-rate non-isothermal kinetic analysis of the isotropic-melt to liquid crystalline phase transition of novel liquid crystalline ionogenic copolymers, LCIs, the 10-(4-methoxyazobenzene-4'-oxy)decyl methacrylate]-co-2-(acrylamido-2-methyl-1-propanesulfonic acid)s, 10-MeOAzB/AMPS, copolymers, has been performed by means of calorimetric experiments. An analytical methodology which includes the study of the phase transition rate parameter, the determination of the activation energies by using Kissinger and Flynn-Wall-Ozawa models, and the study of the phase transition kinetics by the use of the Avrami theory, has been applied. The formation of the mesophases from the isotropic state o…

Photosensitive functionalized surface-modified quantum dots for polymeric structures via two-photon-initiated polymerization technique.

2015

In this paper, the surface modification of CdSe- and CdZnS-based quantum dots (QDs) with a functional silica shell is reported. Functionalized silica shells are prepared by two routes: either by ligand exchange and a modified Stober process or by a miniemulsion process with amphiphilic poly(oxyethylene) nonylphenylether also know as Igepal CO-520 (IG) as oligomeric amphiphile and modified silica precursors. The polymerizable groups on the functionalized silica shell allow covalent bonding to a polymer matrix and prevent demixing during polymerization and crosslinking. This allows the homogeneous incorporation of QDs in a crosslinked polymer matrix. This paper furthermore demonstrates that t…

Polydispersity Effects on Interpenetration in Compressed Brushes

2019

We study the effect of polydispersity on the compression and interpenetration properties of two opposing polymer brushes by numerical self-consistent field approach and by analytical theory. Polydispersity is represented by an experimentally relevant Schulz–Zimm chain-length distribution. We focus on three different polydispersities representing sharp, moderate, and extremely wide chain length distributions and derive approximate analytical expressions for the pressure–separation curves, Π(D). We study the brush interpenetration and quantify it in terms of the overlap integral, Γ, representing the number of interbrush contacts, and interpenetration length, δ. For the case of moderate densit…

Third virial coefficient for 4-arm and 6-arm star polymers

2008

We discuss the computation of the third virial coefficient in polymer systems, focusing on an additional contribution absent in the case of monoatomic fluids. We determine the interpenetration ratio and several quantities that involve the third virial coefficient for star polymers with 4 and 6 arms in the good-solvent regime, in the limit of a large degree of polymerization.