Search results for "Pound"
showing 10 items of 35180 documents
Lattice sites of diffused gold and platinum in epitaxial ZnSe layers
2000
Abstract The lattice location of diffused gold and platinum in zinc selenide (ZnSe) epitaxial layers was studied using the Rutherford backscattering (RBS) channeling technique. Thin Au and Pt films were evaporated onto ZnSe samples. The Au/ZnSe samples were annealed at 525°C and the residual Au film was removed by etching. Channeling angular scan measurements showed that about 30% of Au atoms were close to substitutional site (displaced about 0.2 A). In the case of the Pt/ZnSe samples the annealing temperatures ranged from 600°C to 800°C. The Pt minimum yields along 〈1 0 0〉 direction were close to the random value, varying from 80% to 90%. The measured Pt angular scans along 〈1 0 0〉 and 〈1 …
Radiation resistance of nanolayered silicon nitride capacitors
2020
Abstract Single-layered and multi-layered 20–60 nm thick silicon nitride (Si3N4) dielectric nanofilms were fabricated using a low-pressure chemical vapour deposition (LPCVD) method. The X-ray photoelectron spectroscopy (XPS) confirmed less oxygen content in the multi-layered nanofilms. The capacitors with Si3N4 multilayer demonstrated a tendency to a higher breakdown voltage compared to the capacitors with Si3N4 single layer. Si3N4 nanofilms and capacitors with Si3N4 dielectric were exposed to 1 kGy dose of gamma photons. Fourier transform infrared (FTIR) spectroscopy analysis showed that no modifications of the chemical bonds of Si3N4 were present after irradiation. Also, gamma irradiation…
Impact of the molecular structure of an indandione fragment containing azobenzene derivatives on the morphology and electrical properties of thin fil…
2016
Abstract The solution casting method is low-cost processing method. Moreover, it is possible to prepare amorphous thin films by using this method, and thus, both optical quality and electrical properties could be improved in compare to polycrystalline films made by thermal evaporation in vacuum. Therefore, low-molecular-weight compounds that form amorphous structure from solution could be promising in organic electronics. In this work film morphology, molecule energy levels, and charge carrier mobility in thin films of indandione fragment containing azobenzene derivatives were studied. Deep charge carrier trapping states that drastically influenced charge carrier mobility were observed for …
Domain Walls Motions in Barium Titanate Ceramics
1996
The shear modulus and mechanical loss at low frequencies (0.01, 0.3, 1 Hz) are measured by an inverted pendulum for BaTiO 3 ceramic with large grain sizes. The permittivity and dielectric losses are also investigated for the same material at higher frequencies between 1 and 100 kHz as function of temperature. Those results show several relaxation peaks in the ferroelectric phases. The activation energy of each peak is obtained to be 0.29, 0.45, 0.68, 0.92 eV. The influences of strain amplitude and thermal treatments are studied specially for the mechanical relaxation peak located in the tetragonal phase. All the relaxation peaks could be associated to the interaction of oxygen vacancies in …
The effect of bias field on the dielectric response of Ba0.95Pb0.05TiO3+Со2О3
2021
The nature of the dielectric response in ferroelectric ceramics Ba0.95Pb0.05TiO3+Со2О3 (BPTC) under the influence of a constant bias field EB in the phase transition region is studied. It is found ...
Electromechanical properties of Na 0.5 Bi 0.5 TiO 3 -SrTiO 3 -PbTiO 3 solid solutions
2018
Abstract Thorough studies of electric field-induced strain are presented in 0.4Na1/2Bi1/2TiO3-(0.6-x)SrTiO3-xPbTiO3 (NBT-ST-PT) ternary solid solutions. The increase of concentration of lead x induces crossover from relaxor to ferroelectric. Strain in a relaxor state can be described by electrostrictive behavior. The electrostrictive coefficients correspond to other well-known relaxor ferroelectrics. The concentration region with a stable ferroelectric phase revealed that the polarization dependence of strain does not exhibit nonlinearity, although they are inherent to the electric field dependence of strain. In this case, electric field dependence of strain is described in terms of the Ray…
Effects of water removal on the structure and spin-crossover in an anilato-based compound
2021
The crucial role played by a crystallization water molecule in the spin crossover (SCO) temperature and its hysteresis is described and discussed in compound [NBu4][Fe(bpp)2][Cr(C6O4Br2)3]⋅2.5H2O (1), where bpp = 2,6-bis(pyrazol-3-yl)pyridine and (C6O4Br2)2− = dianion of the 3,6-dibromo-2,5-dihydroxy-1,4-benzoquinone. The compound has isolated [Fe(bpp)2]2+ cations surrounded by chiral [Cr(C6O4Br2)3]3− anions, NBu4+ cations, and a water molecule H-bonded to one of the non-coordinated N–H groups of one bpp ligand. This complex shows a gradual almost complete two-step spin transition centered at ca. 180 and 100 K with no hysteresis. The loss of the water molecules results in a phase transition…
Structural phase transition in [(C2H5)4N][(CH3)4N]ZnCl4
2019
The hybrid crystal [(C2H5)4N][(CH3)4N]ZnCl4 was studied using several experimental methods. DSC studies revealed the first order phase transition to the high temperature phase at about 496 K. This phase transition was confirmed in dielectric studies. Optical observation revealed the domain structure appearance characteristic for that of the phase transition between tetragonal and orthorhombic phases. This phase transition shows a lowering of symmetry as in the case of bromide analogs. Additionally, the optical studies showed the appearance of a number of cracks in the sample and in some cases, the samples became milky after cooling from the high temperature to the room temperature phase.
Controlled Cytotoxicity of Plasma Treated Water Formulated By Open-air Hybrid Mode Discharge
2017
Plasma‐activated liquids (PAL) attract increasing interest with demonstrated biological effects. Plasma exposure in air produces stable aqueous reactive species which can serve as chemical diagnostics of PAL systems. Here, we tailor aqueous reactive species inside plasma‐activated water (PAW) through treating water with AC air spark and glow discharges in contact with water. Chemical probing demonstrated species specificity between two types of PAW. Spark discharge PAW contains urn:x-wiley:14381656:media:ppap201600207:ppap201600207-math-0006 and urn:x-wiley:14381656:media:ppap201600207:ppap201600207-math-0007, while urn:x-wiley:14381656:media:ppap201600207:ppap201600207-math-0008and urn:x-w…
Measurement of the activation energies of oxygen ion diffusion in yttria stabilized zirconia by flicker noise spectroscopy
2019
The low-frequency noise in a nanometer-sized virtual memristor consisting of a contact of a conductive atomic force microscope (CAFM) probe to an yttria stabilized zirconia (YSZ) thin film deposited on a conductive substrate is investigated. YSZ is a promising material for the memristor application since it is featured by high oxygen ion mobility, and the oxygen vacancy concentration in YSZ can be controlled by varying the molar fraction of the stabilizing yttrium oxide. Due to the low diameter of the CAFM probe contact to the YSZ film (similar to 10nm), we are able to measure the electric current flowing through an individual filament both in the low resistive state (LRS) and in the high r…