Search results for "Power System"
showing 10 items of 322 documents
Transition of a distribution system towards an active network. Part II: Economical analysis of selected scenario
2011
This paper outlines the economical issues related to the transition of the energy generation for a real MV/LV distribution system from a ‘fuel based’ one to a distributed and smart ‘renewables based’ one. It is the prosecution of a companion paper, which addressed the technical issues connected to such transition. The study has been carried out by University of Palermo and ENEA (Italy), on a portion of real MV/LV distribution system of the research center ENEA of Casaccia (Rome, Italy). The analysis is carried out for a specific scenario chosen among those proposed in the companion paper.
Higher PV Module Efficiency by a Novel CBS Bypass
2011
There is an increasing focus on reducing costs and improving efficiency for photovoltaic (PV) cells and modules as well as finding a more efficient approach to the product manufacturing. This letter introduces an innovative solution to bypass shaded PV cells instead of a traditional Schottky diode, in order to avoid overheating of cells in the case of partial shading. The goal is to reduce the power dissipation and improve the general efficiency of a PV generator. A novel device called cool bypass switch is then presented. It is made up of a Power MOS driven by a controller with the task to charge a storage capacitor. Tests and comparisons with standard Schottky diodes are then performed an…
Numerical Analysis of Medium Scale PV Plants and Their Power-Flow Control System With a Simple Three Phase Inverter
2012
This paper presents a mathematical analysis of a medium scale Photovoltaic (PV) power generation system connected to the distribution network and of its control system, in which the conversion stage is unique thanks to the absence of a boost chopper. Boost choppers are usually used as actuator for maximum power point tracking (MPPT). The conducted analysis leads to the conclusion that the used inverter presents two degrees of freedom that can be easily exploited in a control system in which the inverter simultaneously realizes the interconnection to the grid and at the same time realizes the MPPT control. The structure of the control system is then presented, discussed and then validated by…
Uncertainty evaluation of a Backward/Forward Load Flow algorithm for a MV smart grid
2015
This paper presents the uncertainty evaluation of an innovative measurement algorithm for load flow analysis in MV distribution networks. The measurement procedure is based on Low Voltage (LV) load power measurements applied on a Backward/Forward (B/F) algorithm for the Load Flow (LF) resolution. Furthermore, in the procedure a three phase voltage measurement at the MV generating substation bus-bars is also considered. The accuracy analysis of the LF algorithm is performed in the case of a real load condition in the distribution grid of Ustica island, Italy. The analysis takes into account the uncertainty of the measurement instruments at the LV side of each secondary substation power trans…
Survey on power increase of power by employment of PV reconfigurator
2015
This paper shows the performance of a PV system under shadow projection on PV panels. The reconfiguration techniques, employing a microprocessor-based system, modifies the layout of the PV plant by physically changing the connections among modules, in order to recover the loss of power due to the shadows. Different cases have been considered to evaluate the increase of power.
Uprating an Overhead Line. Italian TSO Applications for Integration of RES
2013
The increase of Renewable Energy Sources (RES) production units has caused significant changes in the electrical system configuration. The existing structural asset isn't adequate to dispatch these new power flows that, at same time, should be favorite by various TSOs in order to obtain incentives. The outage of primary substations on the grid and the increase of consumptions have caused growing load currents on existing overhead line. This paper, after introducing thermal resistant conductors and Dynamic Rating (DR) solutions, reports an applications used by TERNA Group S.p.A. (Italian TSO). These systems are already installed on lines and they are contributing to increase power flows than…
A suitable control technique for fault-tolerant converters in Distributed Generation
2011
The penetration of Distributed Generation (DG) in power systems is deeply changing the existing distribution networks which is becoming a very sophisticated and complex systems incorporating both active (generators) and passive systems (distribution systems, converters and loads). The necessary simplification can be obtained dealing with small networks, namely Micro-Grids, reproducing, in a smaller scale, the structure and the problems of large networks including production, transmission and distribution of the electrical energy. In order to achieve an adequate level of reliability, fault-tolerant operations of micro-grids become very important. This result can be achieved only using power …
Distribution grid analysys through PSAT open source tools
2015
In this paper a study of an electrical distribution grid with presence of renewable energy sources performed using the Power System Analysis Tool is presented. The paper describes the load flow analysis of a real existing grid owned by the Italian DSO “ENEL Distribuzione SpA” and located in an urban area.
A New Device for the Control and the Connection to the Grid of Combined RES-based Generators and Electric Storage Systems
2013
In this paper a new device for the control and the connection to the supply utility grid of combined RES-based generators and electric storage systems is presented. The device is a bidirectional converter that can be controlled so as to facilitate the interface between the low voltage grid and photovoltaic or wind generators combined with batteries, contemporary addressing the requirements of the reference technical standards for users connection and providing different ancillary services. In the paper the functioning of the device and its circuit diagram are described, the single parts are shown and the potentiality of its control system are commented. © 2013 IEEE.
A novel fuel cell-based power system modeling approach
2013
Nowadays, fuel cells are the most promising source of energy for stationary applications. Unfortunately, the power density of fuel cells is not adequate for modern applications. A fuel cell - based hybrid power supply is required. The fuel cell is coupled with a high-energy density power source to improve performances of the composite power source. A power management stage is introduced between the two basic sources to control the power flow path from the fuel cell to the auxiliary source and the load. In order to avoid effects of a limited power density of the fuel cell on the whole power supply, sophisticated power management algorithms are implemented. Accurate modeling is required to te…