Search results for "Power output"
showing 6 items of 56 documents
Unilateral Conditioning Contractions Enhance Power Output in Elite Short Track Speed Skaters
2018
AbstractThe objective of the present study was to assess the effect of unilateral lower-body-conditioning muscle contractions during multiple sets of fatiguing repeated jumps in elite athletes. Five elite short-track speed-skating athletes performed 9 sets of 6 maximal consecutive jumps on 2 separate occasions: with (COND) and without (CTRL) preliminary voluntary conditioning contractions (CC) 5 min before the beginning of the sets. The CC consisted of 2 consecutive 3 s maximal unilateral isometric squats against a fixed bar, resulting in a 6 s overall isometric contraction per leg. For each set, power output (PO) was measured using a linear position transducer and averaged over the 6 corre…
Neuromuscular function during prolonged pedalling exercise at different cadences
2005
Aim: The purpose of the present work was to assess the strategies set by the central nervous system in order to provide the power output required throughout a prolonged (1-h) pedalling exercise performed at different cadences (50 rpm, 110 rpm and the freely chosen cadence). Methods: Neuromuscular (NM) activity of vastus lateralis, rectus femoris, biceps femoris and gastrocnemius lateralis muscles was studied quantitatively [root-mean square (RMS) and mean power frequency (MPF)] and qualitatively (timing of onset and offset of muscle bursts during crank cycle). Results: The present results showed that increased cadence resulted in earlier muscle activation in crank cycle. The influence of ca…
Operator Revenue Analysis for Device-to-Device Communications Overlaying Cellular Network
2018
Device-to-device (D2D) communications has recently gathered significant research interest due to its efficient utilization of already depleting wireless spectrum. In this article, we considered a scenario where D2D users communicate in the presence of cellular users in an overlay network setup. In order to analyze the revenue of service providers in monetary terms, the paper provides exact expressions of operator profit for both D2D and cellular users. More specifically, we take into account different network parameters including user density, transmit power and channel variations to understand their impact on the total revenue of the operator. Finally, we derive the balancing value of freq…
Effects of Temperature and Humidity on Radio Signal Strength in Outdoor Wireless Sensor Networks
2015
Many wireless sensor networks operating outdoors are exposed to changing weather conditions, which may cause severe degradation in system performance. Therefore, it is essential to explore the factors affecting radio link quality in order to mitigate their impact and to adapt to varying conditions. In this paper, we study the effects of temperature and humidity on radio signal strength in outdoor wireless sensor networks. Experimental measurements were performed using Atmel ZigBit 2.4GHz wireless modules, both in summer and wintertime. We employed all the radio channels specified by IEEE 802.15.4 for 2.4GHz ISM frequency band with two transmit power levels. The results show that changes in …
On the effects of transmit power control on the energy consumption of WiFi network cards
2009
Transmit power control has been largely proposed as a solution to improve the performance of packet radio systems in terms of increased throughput, spatial reuse and battery lifetime for mobile terminals. However, the benefits of transmit power control schemes on these different performance figures may strongly depend on the employed PHY technology and channel access mechanism. In this paper, we focus on the effects of power control on the energy consumption of WiFi network cards. By means of several experimental tests carried out under different operation conditions and modulation schemes, we try to justify why the reduction of the transmission power has a marginal effect on the overall en…
Comparison of inter-trial recovery times for the determination of critical power and W' in cycling
2017
Critical Power (CP) and W’ are often determined using multi-day testing protocols. To investigate this cumbersome testing method, the purpose of this study was to compare the differences between the conventional use of a 24-h inter-trial recovery time with those of 3 h and 30 min for the determination of CP and W’. Methods: 9 moderately trained cyclists performed an incremental test to exhaustion to establish the power output associated with the maximum oxygen uptake (p V O2max), and 3 protocols requiring time-to-exhaustion trials at a constant work-rate performed at 80%, 100% and 105% of p VO2max. Design: Protocol A utilised 24-h inter-trial recovery (CP24/W’24), protocol B utilised 3-h in…