Search results for "Processes"

Reply to the comment on “Carbonate deposition and diagenesis in evaporitic environments: The evaporative and sulphur-bearing limestones during the se…

2016

Abstract Manzi et al. (in press) took the opportunity offered by our paper to repeat again all the set of ideas supporting an interpretative model of the Messinian Salinity Crisis (MSC), a model they assert to be valid for the whole Mediterranean basin. What emerges from reading this long comment may be summarized in one criticism of our article: we have not systematically applied their interpretative model to our data! The aim of our paper was not to promote their ideas, but to submit the results of more than 20 years of field studies and petrographical and geochemical analyses on Sicilian and Calabrian sequences of the Messinian “Calcare di Base”. It is out of our purpose to enumerate aga…

Hyper-extended rifted margin in the Tyrrhenian Sea, upper plate of the Ionian subduction zone

2011

The Tyrrhenian Sea is a Miocene to Present back-arc basin developed in the upper plate of the Ionian subduction zone. Refraction seismic data indicate that the central sector of the Marsili Basin is a zone of thin crust ∼7 km thick compatible with its oceanic origin (Steinmetz et al., 1983). Conventional models rather define a Continent-Ocean Transition (COT) with normal oceanic crust (i.e. Finetti et al., 2005). This does not seem to be the case for the whole Tyrrhenian Basin. Serpentinized peridotites, emplaced during Pliocene, have been drilled at ODP Site 651 (Sartori et al. 2004). The W Calabria segment of the Tyrrhenian continental margin is peculiar as seismic data has excluded the p…

THE ROLE OF VOLCANIC AND ANTHROPOGENIC ACTIVITIES IN CONTROLLING THE EROSION PROCESSES AT VULCANO ISLAND (ITALY)

2011

The paper describes the erosion processes acting at La Fossa cone (Vulcano Island, Italy). La Fossa cone is a stratovolcano made up of pyroclastic deposits and lavas covered by tuffs from the last eruption, dated 1888-90. Its flanks are affected by intense water erosion phenomena leading to the formation of denudation surfaces due to sheet erosion, rills, gullies and small canyons. As a consequence of very intense rainfalls, episodic debris flows occur along main gullies and canyons. Fumarolic activity plays an important role in the control of erosion processes, being both an obstacle for the growth of vegetation and a weathering factor. The GIS analysis and comparison of geo-referenced map…

Deep-seated gravitational slope deformations in western Sicily: Controlling factors, triggering mechanisms, and morphoevolutionary models

2014

Abstract A study of deep-seated gravitational slope deformation (DSGSD) phenomena affecting areas of various geological and geomorphological settings in western Sicily is described. Western Sicily is underlain by a thin-skinned imbricate wedge of Meso–Cenozoic carbonate and siliciclastic rocks that formed by the stacking of several thrust nappes over the Iblean foreland. Locally, the original thrust sheets are folded and cut by high-angle faults. Large areas of western Sicily now display high relief energy due to Plio-Pleistocene block-faulting and uplifting, and the Quaternary morphogenetic phases are characterised by incision, thereby triggering widespread DSGSDs. To identify controlling …

Climate Change in the Mediterranean Basin (Part I): Induced Alterations on Climate Forcings and Hydrological Processes

2022

In the last years, the Mediterranean basin has been widely recognized as one of the most vulnerable areas in the world to climate change; because of its high concentration of urban and industrial settlements, it is one of the most impacted areas of the world in terms of water scarcity. The present paper aims at reviewing the main observed and predicted effects of climate change on hydrological processes directly related to water availability in the Mediterranean Basin, mainly focusing on the last ten years of research. While an in-depth discussion about possible future water scarcity problem in the Mediterranean area and the sources of uncertainty affecting future climate projections and im…

Proceedings of 13th International Workshop on physical processes in natural waters

2009

Sequential Batch Membrane BioReactor treating saline wastewater

2015

A sequential batch membrane bioreactor treating high strength salinity wastewater has been investigated. The salt effects on carbon and nutrient removal, fouling behaviour as well as biomass kinetics have been analysed. Salinity was increased at step of 2 g NaCl L-1 per week. The total COD removal efficiency was high (93%) along the entire experimental campaign. However, the biological contribution on the COD removal efficiency was reduced with the increase of salinity. The lowest nitrification removal efficiency (63%) was obtained at 10 g NaCl L-1 salinity due to the lower nitrifier activity. Regarding membrane fouling, the irreversible cake deposition was the predominant fouling mechanism…

Experimental characterization of friction properties of materials for innovative beam-to-column dissipative connection for low-damage RC structures

2023

Low-damage design of structures in seismic-prone areas is becoming an efficient strategy to obtain "earthquake-proof" buildings, i.e. buildings that, even in the case of severe seismic actions, experience a low or negligible amount of damage. Besides the safeguard of human lives, this design strategy aims also to limit the downtime of buildings, which represents a significant source of economic loss, and to ensure an immediate occupancy in the aftermath of an earthquake. In this context, focusing on moment-resisting frames (MRFs), several solutions have been developed for the beam-to-column connections (BCCs) of steel and precast/prestressed concrete structures, but very few for cast-in-sit…

Innovative connections for steel-concrete-trussed beams: a patented solution

2023

The most recent design strategies welcome the adoption of innovative techniques for seismic energy input mitigation, aiming to achieve high dissipation capacity, prevent the structure from collapse and ensure the serviceability of the construction. Friction damper devices have been widely adopted in framed steel structures for decades, while their introduction in different structural types is still under investigation. This paper presents the outcomes of innovative research supported by the industry and conducted on beam-to-column connections of RC structures in which the beams are Hybrid Steel-Trussed Concrete Beams (HSTCBs) and the columns are classical RC pillars. An innovative solution,…

Progetti per raccontare la città

2020

Nell’ambito di una ricerca interdipartimentale il lavoro presenta l’esperienza di coordinamento di una attività progettuale condotta con giovani laureati nel centro storico di Caltabellotta, i cui lavori si offrono come occasione per aiutare la città a precisare intenzioni e atteggiamenti, riflessioni e azioni per innescare processi reali di rigenerazione. Un testo iniziale precisa e racconta le finalità del coordinamento.