Search results for "RADIOCHEMISTRY"
showing 10 items of 273 documents
Optical spectroscopy using mass-separated beams: Nuclear properties of unstable indium and tin isotopes
1987
Abstract Collinear fast-beam laser-spectroscopy has been used to measure the hyperfine structure and isotope shift of several indium and tin isotopes. The related experimental techniques are described, including the preparation of mass-separated beams of neutron-deficient indium and tin isotopes at the GSI on-line mass separator following fusion-evaporation reactions. The deviation of the observed dependence of the charge radii upon the neutron number from the expected behaviour is briefly discussed.
Development of a liquid Pb-Bi target for high-power ISOL facilities
2016
Abstract This paper describes some R&D activities conducted in support of the design and safe operation of a high-power liquid Pb-Bi target within the LIEBE (Liquid Eutectic Lead Bismuth Loop Target for EURISOL) project. The target material is lead bismuth eutectic (LBE) which also acts as a primary coolant. As a consequence of interaction of the highly pulsed 1.4-GeV protons at ISOLDE with the target, heat powers of the order of 2 GW would be instantaneously deposited in the target during a bunch. Considerable R&D effort is thus required to demonstrate its continued coolability and structural integrity. This paper mainly reports on the conjugate flow (CFD) and heat deposition (Monte Carlo)…
Accumulation of radiation defects and products of radiolysis in lithium orthosilicate pebbles with silicon dioxide additions under action of high abs…
2012
Abstract One of the technological problems of a fusion reactor is the change in composition and structure of ceramic breeders (Li 4 SiO 4 or Li 2 TiO 3 pebbles) during long-term operation. In this study changes in the composition and microstructure of Li 4 SiO 4 pebbles with 2.5 wt% silicon dioxide additions, fabricated by a melt-spraying process, were investigated after fast electron irradiation ( E = 5 MeV, dose rate up to 88 MGy h −1 ) with high absorbed dose from 1.3 to 10.6 GGy at high temperature (543–573 K) in air and argon atmosphere. Three types of pebbles with different diameters and grain sizes were investigated. Products of radiolysis were studied by means of FTIR and XRD. TSL …
Radiation-induced effects in neutron- and electron-irradiated lithium silicate ceramic breeder pebbles
2020
Abstract Ceramic breeder (CB) pebbles consisting of lithium orthosilicate (Li4SiO4) as the main phase and lithium metasilicate (Li2SiO3) as a secondary phase were analysed with respect to radiation-induced defects and radiolysis products. Therefore, pebbles that were irradiated with neutrons in the so-called HICU experiment ( H igh neutron fluence i rradiation of pebble sta c ks for f u sion) were compared to pebbles irradiated with accelerated electrons and to an unirradiated sample. Fourier transformation infrared spectroscopy was used to investigate changes in the phase composition. Beside an expected increase in the second phase in the neutron-irradiated samples, no further significant …
Lead–gold eutectic: An alternative liquid target material candidate for high power spallation neutron sources
2011
Abstract One of the main technical concerns of Megawatt-class spallation neutron sources is the removal of the heat deposited in the target station. A way to overcome it is to use targets consisting of flowing liquid metals, but the already tested materials – mercury and lead–bismuth eutectic (LBE) – are not unproblematic. We show here that another eutectic alloy containing lead and gold (LGE) could be a suitable alternative. Besides a chemical toxicity lower than mercury, this low melting-point alloy has the advantage of being solid at RT. Moreover, it combines a neutron production similar to mercury and LBE with smaller amounts of alpha-emitting nuclides, relieving safety and environmenta…
Thermoluminescence response of sodalime glass irradiated with proton and neutron beams
2012
In the research field of emergency dosimeters to be used in case of accidental radiation exposure of the population, watch glass has been considered as a possible fortuitous dosimetric material. This paper reports on results obtained by thermoluminescence of glass samples exposed to neutron and proton beams. Thermoluminescent glow curves have been analyzed for each irradiation studying the modifications induced by the irradiation as a function of proton dose or neutron fluence. The glow curve in a specific temperature range has been used as dosimetric parameter. The thermoluminescence response of samples exposed to protons has been found to be linear in the dose range between 2 and 20 Gy an…
ESR and PL centers induced by gamma rays in silica
1996
We have studied the point defects created by γ irradiation in various types of commercial silica glasses, including both natural and synthetic samples, with different OH content, in the low dose regime (0.05–100 Mrad). We found that the growth rate of E′ centers depends strongly on the silica type, ranging from 2 × 1015 cm−3 Mrad−1 to 6 × 1017 cm−3 Mrad−1. Samples of natural silica are rather susceptible to γ ray exposure, as E′ concentration saturates (typically 5 × 1017 cm−3) for doses as low as a few Mrads. For both synthetic and natural samples, the radiation hardness is higher in wet than in dry silica. Moreover, we found a strict correlation between the concentration of E′ centers and…
Formation and accumulation of radiation-induced defects and radiolysis products in modified lithium orthosilicate pebbles with additions of titanium …
2016
Abstract Lithium orthosilicate (Li4SiO4) pebbles with 2.5 wt.% excess of silicon dioxide (SiO2) are the European Union's designated reference tritium breeding ceramics for the Helium Cooled Pebble Bed (HCPB) Test Blanket Module (TBM). However, the latest irradiation experiments showed that the reference Li4SiO4 pebbles may crack and form fragments under operation conditions as expected in the HCPB TBM. Therefore, it has been suggested to change the chemical composition of the reference Li4SiO4 pebbles and to add titanium dioxide (TiO2), to obtain lithium metatitanate (Li2TiO3) as a second phase. The aim of this research was to investigate the formation and accumulation of radiation-induced …
Tritium retention measurements by accelerator mass spectrometry and full combustion of W-coated and uncoated CFC tiles from the JET divertor
2016
Abstract Accelerator mass spectrometry (AMS) and the full combustion method (FCM) followed by liquid scintillation counting were applied to quantitatively determine the tritium retention in the tungsten-coated carbon fibre composites (CFC), in comparison to uncoated CFC tiles from the JET divertor. The tiles were adjacent and exposed to plasma operations between 2007 and 2009. The tritium depth profiles are showing that the tritium retention on the W-coated tile was reduced by a factor of 13.5 in comparison to the uncoated tile whereas the bulk tritium concentration is approximately the same for both tiles.
New nuclides: Neptunium-243 and neptunium-244
1987
We have observedγ-rays following the β−-decay of243Np and244Np after chemical isolation of neptunium isotopes from the products of the reaction of 835 MeV136Xe with244Pu. The ground-state of 1.85-min243Np hasJ=5/2. The decay of 2.29-min244Np (probableJπ=7−) populates high-spin members of the ground state rotational band in244Pu.