Search results for "REF"

Light-induced transmission nonlinearities in gallium selenide

1999

The intensity of a He–Ne laser (633 nm, 5 mW) transmitted by different GaSe samples is observed to change in correlation with a Nd-yttrium–aluminum–garnet laser pulse (532 nm, 7.8 ns, 3 mJ) which excites them. Such time response has been attributed to a nonlinear optical effect, i.e., a decrease in the refractive index due to the exciton screening by the photogenerated carriers. A calculation of the absorption coefficient and refractive index at different carrier concentrations has led to a reconstruction of transmittance transients which fully agree with the experimental data at different incident intensities and temperatures. Chantal.Ferrer@uv.es ; Jaqueline.Bouvier@uv.es ; Miguel.Andres@…

2014

In this paper mathematical modeling of a vehicle crash test based on a single-mass is studied. The model under consideration consists of a single-mass coupled with a spring and/or a damper. The parameters for the spring and damper are obtained by analyzing the measured acceleration in the center of gravity of the vehicle during a crash. A model with a nonlinear spring and damper is also proposed and the parameters will be optimized with different damper and spring characteristics and optimization algorithms. The optimization algorithms used are interior-point and firefly algorithm. The objective of this paper is to compare different methods used to establish a simple model of a car crash an…

Optical absorption of divalent metal tungstates: Correlation between the band-gap energy and the cation ionic radius

2008

We have carried out optical-absorption and reflectance measurements at room temperature in single crystals of AWO4 tungstates (A = Ba, Ca, Cd, Cu, Pb, Sr, and Zn). From the experimental results their band-gap energy has been determined to be 5.26 eV (BaWO4), 5.08 eV (SrWO4), 4.94 eV (CaWO4), 4.15 eV (CdWO4), 3.9-4.4 eV (ZnWO4), 3.8-4.2 eV (PbWO4), and 2.3 eV (CuWO4). The results are discussed in terms of the electronic structure of the studied tungstates. It has been found that those compounds where only the s electron states of the A2+ cation hybridize with the O 2p and W 5d states (e.g BaWO4) have larger band-gap energies than those where also p, d, and f states of the A2+ cation contribu…

2015

This paper provides a commentary on the academic literature on accounting conservatism with a view to highlighting the insights of that literature that are potentially useful for accounting standar...

A comparative study on sample preparation procedures for supplementary foods by ICP-OES: Green chemistry considerations

2015

An inductively coupled plasma optical emission (ICP-OES) method was developed for the simultaneous determination of major, minor and trace elements in food. Preliminary studies focused on selecting suitable operational conditions in order to provide the highest sensitivity and to maximize the number of analytes to be determined without spectral or matrix interference. Ruthenium and rhenium were evaluated as internal standards and samples were analyzed at different dilution levels. Furthermore, a comparative study was carried out by using three sample digestion methods, microwave-assisted digestion with HNO3/H2O2, dry ashing and dry ashing with Mg(NO3)2/MgO as an ashing aid. Adequate precisi…

Development of a GC–MS/MS strategy to determine 15 mycotoxins and metabolites in human urine

2014

The widespread mycotoxins contamination of food commodities has made the monitoring of their levels essential. To overcome the disadvantages of the indirect approach by food analysis, detection of mycotoxin as biomarkers in urine provides a useful and specific data for exposure assessment to these food contaminants. In this work, a sensitive, rapid and accurate method based on gas chromatography-tandem mass spectrometry procedure to determine 15 mycotoxins and metabolites in human urine was optimized and validated taking into consideration the guidelines specified in Commission Decision 2002/657/EC and 401/2006/EC. A salting-out assisted acetonitrile-based extraction was used for sample pre…

Significance of passively induced stretch reflexes on achilles tendon force enhancement

1998

An in vivo buckle transducer technique was applied to study the reflex contribution to ATF enhancement during passive dorsiflexion stretches. Single stretches led to a linear ATF increase in the absence of an EMG reflex response, whereas clear ATF enhancement over the passive component occurred 13-15 ms after the onset of EMG responses. To quantify the reflexly induced increase in ATF, the stretched position was maintained. The mean reflex effect was two to four times greater than the passive stretch effect.

Medial gastrocnemius muscle and tendon interaction during gait in typically developing children and children with cerebral palsy

2020

1. IntroductionEfficient gait is dependent on optimal interaction between musclesand tendons [1]. Pathological changes in the extensibility of the MGmuscle fascicles, whole muscle-belly and Achilles tendon have beenreported in children with spastic cerebral palsy (CP) [2]. Studying therelative length of these tissues during gait can improve our understandingof their dynamics and, inferably, the control strategies used inCP. In-vivo dynamic ultrasound imaging has been used to visualise theinteraction between the MG muscle and tendon during 3D gait analysis.However, most studies combined ultrasound imaging of one variable(either fascicles or muscle-belly and tendon) with some form ofmusculosk…

Mechanism of crystallization of fast fired mullite-based glass–ceramic glazes for floor-tiles

2006

Abstract The mechanism of crystallization from a B 2 O 3 -containing glass, with composition based in the CaO–MgO–Al 2 O 3 –SiO 2 system, to a glass–ceramic glaze was studied by different techniques. Glass powder pellets were fast heated, simulating current industrial tile processing methods, at several temperatures from 700 to 1200 °C with a 5 min hold. Microstructural study by field emission scanning electron microscopy revealed that a phase separation phenomenon occurred in the glass, which promoted the onset of mullite crystallization at 900 °C. The amount of mullite in the glass heated between 1100 and 1200 °C was around 20 wt%, as determined by Rietveld refinement. The microstructure …

Effect of boron oxide on the microstructure of mullite-based glass-ceramic glazes for floor-tiles in the CaO–MgO–Al2O3–SiO2 system

2006

Abstract The effect of increasing replacement of Al2O3 by B2O3 in a parent glass on the sintering and further crystallization of mullite was investigated. The composition of the parent glass was chosen in the mullite primary phase field of the CaO–MgO–Al2O3–SiO2 quaternary system. Glass powder pellets were heated under standard (10 °C/min and 2 h of hold time) and fast heatings (25 °C/min and 5 min of hold time) at different temperatures from 700 to 1190 °C. Sintering of B2O3-containing glasses took place in the range between 850 and 1050 °C. X-ray diffraction results showed that mullite formed as unique crystalline phase for glasses containing amounts of B2O3 larger than 6 wt%. For lower a…