Search results for "RFA"
showing 10 items of 11106 documents
TASCAを用いたCn, Nh, Fl化学実験のためのHg, Tl, PbのSiO2及びAu表面に対するオンライン化学吸着研究
2018
Online gas-solid adsorption studies with single atom quantities of Hg, Tl, and Pb on SiO$_{2}$ and Au surfaces were carried out using short-lived radioisotopes with half-lives in the range of 4-49 s. This is a model study to measure adsorption enthalpies of superheavy elements Cn, Nh, and Fl. The short-lived isotopes were produced and separated by the gas-filled recoil separator TASCA at GSI. The products were stopped in He gas, and flushed into gas chromatography columns made of Si detectors whose surfaces were covered by SiO$_{2}$ or Au. The short-lived Tl and Pb were successfully measured by the Si detectors with the SiO$_{2}$ surface at room temperature. On the other hand, the Hg did no…
Influence of fluorine on the synthesis of anatase TiO2for photocatalytic partial oxidation: Are exposed facets the main actors?
2018
Anatase TiO2 samples were synthesized in the presence of different amounts of HF acid with the aim of understanding the effect of the presence of fluorine on the photocatalytic activity. It is well known that the presence of fluoride ions influences the photocatalytic performance by adsorption on the surface of TiO2 and that they are capping agents in the control of specific exposed facets. The samples were characterized by X-ray diffraction (XRD), Raman spectroscopy, nitrogen adsorption–desorption measurements, scanning electron microscopy (SEM), transmission electron microscopy (TEM), UV-vis spectrophotometry, and X-ray photoelectron spectroscopy (XPS). The photocatalytic activity was eva…
Photocatalytic activity of nanocrystalline TiO2 (brookite, rutile and brookite-based) powders prepared by thermohydrolysis of TiCl4 in aqueous chlori…
2008
Abstract Nanocrystalline TiO2 powders were synthesized by thermohydrolysis of TiCl4 in HCl or NaCl aqueous solutions. Rutile, mixtures of brookite and rutile or mixtures of anatase, brookite and rutile were obtained depending on the acidity of the medium. Crystalline phases and composition of the mixtures were identified by using XRD analysis. Pure brookite nanoparticles, separated from the mixtures of brookite and rutile by simple peptization with water, were stable against transformation to rutile up to 750 °C. The prepared TiO2 powders were characterized by thermal analysis, diffuse reflectance spectroscopy and BET surface area determinations. The band gap of bulky brookite was estimated…
Photoactivity of Nanostructured TiO2 Catalysts in Aqueous System and their Surface Acid-Base, Bulk and Textural Properties
2007
This work reports on the characterisation and determintion of the photocatalytic activity of some TiO2 catalysts prepared using TiCl4 as precursor. The samples, consisting of suspensions, dispersions or powders of nanonstructured anatase or rutile phases, were obtained in very mild conditions, i.e., by boiling the solution obtained after hydrolysis of TiCl4 at atmospheric pressure: it is worth noting that no calcination was necessary to obtain photoactive phases. The samples were characterised by X-ray diffraction (XRD), determination of the BET specific surface area (SSA), scanning electron microscopy (SEM) observations and diffuse reflectance spectroscopy (DRS). FT-IR spectroscopy was use…
Alkaline treatment as a means to boost the activity of TiO(2)in selective photocatalytic processes
2020
In this work, the activity enhancement of TiO(2)photocatalysts by alkaline treatment has been investigated. Commercial (BDH, U.K., anatase phase) TiO(2)samples, treated in alkaline solutions of NaOH at different concentrations and temperatures, were tested for the photocatalytic partial oxidation of 3-pyridinemethanol in water under UVA irradiation to form vitamin B-3. Photocatalyst characterization has been carried out by XRD, BET, TEM, TGA, photoluminescence, FTIR, Raman, DRS, EPR and photocurrent measurements. The alkaline-treated samples showed an increased activity of up to 7 times (by considering first order rate constant values) compared to untreated BDH and the superior performance …
Preparation and characterization of Al2O3 supported TiO2 catalysts employed for 4-nitrophenol photodegradation in aqueous medium
1998
Abstract In this paper the preparation and some bulk and surface characterizations of set of Al2O3 supported TiO2 photocatalysts are reported. The powders were home prepared by a wet impregnation method using titanium (IV) isopropylate. The impregnation was followed by thermal treatments and this procedure was repeated several times in order to obtain samples with different amounts of TiO2. The solids were characterized by X-ray diffraction, specific surface area determination, scanning electron microscopy coupled with an electron microprobe used in an energy-dispersive mode and diffuse reflectance spectroscopy. Moreover, all of them were tested as photocatalysts by using different kinds of…
Photocatalytic degradation of carbaryl in aqueous TiO2 suspensions containing surfactants
1999
The effect of ionic and non-ionic aliphatic surfactants on the photocatalytic degradation of Carbaryl (1-naphtyl-N-methylcarbamate) in aqueous solutions containing suspended TiO2 (anatase) particles, under irradiation with simulated AM1 solar light, was investigated. A neat inhibitory effect on the degradation rate was observed, depending on the nature of the surfactant and on the initial pH of the solution. The decay profiles of the primary process corresponded to the usual pseudo-first order kinetics for surfactant concentrations below the critical micellar concentration range, whereas a more complicate behaviour was observed in the presence of micellar aggregates. Mineralization of the p…
NiO diluted in high surface area TiO2 as efficient catalysts for the oxidative dehydrogenation of ethane
2017
[EN] Catalysts consisting of NiO diluted in high surface area TiO2 can be as efficient in the oxidative dehydrogenation of ethane as the most selective NiO-promoted catalysts reported previously in the literature. By selecting the titania matrix and the NiO loading, yields to ethylene over 40% have been obtained. In the present article, three different titanium oxides (TiO2) have been employed as supports or diluters of nickel oxide and have been tested in the oxidative dehydrogenation of ethane to ethylene. All TiO2 used present anatase as the main crystalline phase and different surface areas of 11,55 and 85 m(2) g(-1). It has been observed that by selecting an appropriate nickel loading …
Reactive direct current magnetron sputtered TiO2 thin films with amorphous to crystalline structures.
2008
International audience; TiO2 thin films were deposited on soda–lime glass substrates by reactive direct current magnetron sputtering in a mixture of pure argon and oxygen. The influence of both the deposition time, td, and the post-annealing treatments on the films morphology, composition and structure was analyzed by scanning electron microscopy, ellipsometry, X-ray photoelectrons spectroscopy, X-ray diffraction (XRD) and Raman spectroscopy. Amorphous TiO2 was obtained for the shortest deposition time, td=15 min. Increasing td up to 30 min, poorly crystallized anatase and rutile phases were formed together with amorphous TiO2, as was revealed by complementary XRD patterns and Raman spectra…
Study of surface layers and ejected powder formed by oxidation of titanium substrates with a pulsed Nd:YAG laser beam.
2009
Laser treatment of a titanium surface at certain conditions initiates the formation of titanium oxide layers as well as micro (nano) scale powder ejected from the surface of the substrate. The resultant morphology of the surface as well as the size and the structure of the particles are all strongly dependent on the treatment parameters (laser fluence, pulse frequency, overlap parameter, etc.). In this study, titanium substrates were treated with an industrial pulsed Nd:YAG laser in air, with varying parameters. Surface layers and ejected materials were compared using scanning and transmission electron microscopy, X-ray diffraction and Raman spectroscopy. The rutile phase of TiO(2) dominate…