Search results for "Reagent"

Trends of Organic Electrosynthesis by Using Boron-Doped Diamond Electrodes

2019

The electro-organic synthesis is currently experiencing a renaissance due to the tremendous contributions of various electrocatalytic materials as well as the use of electric current as an inexpensive and suitable reagent to drive the electrosynthetic transformations, avoiding conventional chemical oxidizers or reducing agents. Consequently, electrosynthesis has a significant technical impact, because these processes can be easily scaled up, benefiting from advantages such as versatility, environmental compatibility (possibility of recovering and recycling non-converted substrates), automation (switching on or off electric current), inherent safety and potential cost effectiveness among oth…

Heterogeneous photocatalytic materials for sustainable formation of high-value chemicals in green solvents

2021

Abstract The most investigated materials used as heterogeneous photocatalysts for the formation of high-value chemicals under mild experimental conditions are presented in this survey. Only papers reporting reactions carried out in harmless solvents such as water, the green solvent par excellence, are reported. Metal oxides have been used often, but carbon-based materials such as carbon nitride and graphene, metal nanoparticles, sulphides and selenides also have received a great attention mainly due to their good performances both in partial oxidations and reductions. The results presented indicate that an appropriate choice of the photocatalytic material is the main problem to be faced to …

Vinylphenylglycidyl ether-based colloidal architectures: high-functionality crosslinking reagents, hybrid raspberry-type particles and smart hydropho…

2014

An efficient synthetic strategy for the preparation of monodisperse colloidal core/shell architectures with reactive epoxy functionalities is reported, based on the bifunctional vinylphenylglycidyl ether monomer. Accessibility of the reactive immobilized epoxy moieties was quantified by UV/vis spectroscopy in an isorefractive medium. Inorganic–organic hybrid raspberry-type architectures revealed a tremendous inpact on the surface wettability of water.

Gold recycling at laboratory scale: from nanowaste to nanospheres

2019

The market for products based on nanotechnology, and with it the use of nanomaterials and the generation of nanowaste, increases day by day. Among the vast variety of nanomaterials available, gold nanoparticles (AuNPs) are among the most studied and applied in commercial products. This current situation requires both the development of recovery methods to reduce the amount of nanowaste produced, and new synthetic methods that allow the reuse of recovered gold for new nanomaterial production, keeping in mind both economical and ecological considerations. In this work, a methodology to recover gold from aqueous laboratory nanowaste and transform it into an aqueous HAuCl4 solution was develope…

Comparative evaluation of the swelling and degrees of cross-linking in three organic gel packings for SEC through some geometric parameters.

2003

Abstract The size exclusion chromatographic (SEC) behavior of five solvent/polymer systems in three organic column packings based on polystyrene/divinylbenzene (PS/DVB) copolymer, TSK-Gel H HR , μ-styragel and TSK-Gel H XL , has been compared. All the packings offer similar characteristics (pore size, particle size and efficiency) but some differences have been found when eluting the same systems. The different elution behavior observed in both polymeric gels has been analyzed in terms of their swelling and cross-linking degrees and of the fractal parameters. From the Universal Calibration plots, values of the chromatographic partition coefficient, K p , have been obtained and using some eq…

Nanostructuring with a crosslinkable discotic material.

2007

A high-yielding synthesis afforded a hexa-peri-hexabenzocoronene carrying acrylate units at the end of six attached alkyl spacers. The polymerization of these acrylate moieties could be initiated with thermal energy and through direct photoactivation without the addition of a photoinitiator. This allowed the organization of the liquid-crystalline material to be fixed in either the crystalline state or the mesophase, which preserved the organization in the respective phase. The use of a focused synchrotron beam permitted selected regions of a thin film to be rendered insoluble. After "developing" the film in this lithographic process by dissolving the soluble, unpolymerized material, defined…

Thalassiosira pseudonana diatom as biotemplate to produce a macroporous ordered carbon-rich material

2008

Abstract Ordered macroporous–mesoporous carbonaceous materials were produced as a direct replica of the Thalassiosira pseudonana diatom by infiltration of the skeleton with furfuryl alcohol. The final carbon-rich material preserves the macropores of the diatom acting as bio-template and new hierarchical macro–mesopores appears as the silica is eliminated through chemical etching. The final solid can be described as an organized array of carbon macrotubes. In order to understand the progressive silica etching and the subsequent effect on the final carbon material, different etching reagents have been used. Moreover, the similar pore topology of T. pseudonana and the well known MCM-41 mesopor…

Comparative performance of electrospun collagen nanofibers cross-linked by means of different methods.

2009

[EN] Collagen, as the major structural protein of the extracellular matrix in animals, is a versatile biomaterial of great interest in various engineering applications. Electrospun nanofibers of collagen are regarded as very promising materials for tissue engineering applications because they can reproduce the morphology of the natural bone but have as a drawback a poor structural consistency in wet conditions. In this paper, a comparative study between the performance of different cross-linking methods such as a milder enzymatic treatment procedure using transglutaminase, the use of N-[3-(dimethylamino)propyl]-N¿-ethylcarbodiimide hydrochloride/ N-hydroxysuccinimide, and genipin, and the u…

Front Cover: Metal‐ and Reagent‐Free Anodic Dehydrogenative Cross‐Coupling of Naphthylamines with Phenols (ChemElectroChem 9/2018)

2018

Novel biosensoric devices based on molecular protein hetero-multilayer films

1997

We have developed a novel concept for the modification of technical surfaces with molecularly well-organized layers of bioorganic components. A molecular construction set has been used to implement this concept which is based on molecularly stratified polyelectrolyte films as a structure decoupling protein layers from solid substrates. Utilizing this technology, one can start from a number of different substrates to obtain the same surface structures, on which protein hetero-multilayer films can be prepared to functionalize the interface for (potentially very different) purposes. We have demonstrated the viability of this concept by constructing a biosensor surface that was characterized by…