Search results for "Reagent"
showing 10 items of 699 documents
Direct determination by portable ED-XRF of mineral profile in cocoa powder samples
2019
Abstract The present study has exploited the rapidity of the analysis and the multi-elemental capability of the energy dispersive X- ray fluorescence (ED-XRF) technique for the mineral profile determination in cocoa powder. A fast, cheap and environmental sustainable method without reagent consumption or toxic waste generation has been proposed. The samples can be prepared in the form of pellets of 13 mm in diameter and 2–3 mm thickness. The different internal calibrations used by ED-XRF equipment did not provide accurate results when comparing the mineral profile with the concentration obtained by Inductively Couple Plasma Optical Emission Spectroscopy (ICP-OES) after microwave assisted di…
Effect of thermal treatment on the structural evolution of 3:2 and 2:1 mullite monophasic gels
2005
Abstract Single phase mullite gels with composition 3Al2O3 · 2SiO2 (3:2) and 2Al2O3 · SiO2 (2:1) were prepared by the semialkoxide method using aluminum nitrate nonahydrate and tetraethylorthosilicate as reagents. The influence of the thermal processing conditions on the reaction sequence was investigated. Both 3:2 and 2:1 mullite gels formed orthorhombic mullite under fast heating (40 °C/min) at 900 °C. Slow heatings delayed the formation of mullite in both gel compositions but no formation of spinel was detected between 1000 °C and 1100 °C. The slow transformation of pentacoordinated aluminum to octahedral and tetrahedral arrangements probably depends on the larger size and extent of the …
Studies of the Phosphatization of Steel and its Corrosion Products
1986
The reaction of phosphoric acid with steel is a basic process in many technological procedures. A typical example is the pretreatment of steel surfaces for the application of coatings. The aim of the treatment is to clean the surface, to produce a homogeneousr tight, and smooth cover and to provide a reliable adhesion between the steel substrate and the coating. This example points out that the phase composition of the layer formed is of great interest, and that reactions with residues on the surface, such as oxides and corrosion products, have to be considered, too. The same holds for phosphate layers formed in order to modify the mechanical or corrosion behavior of steel surfaces. Because…
Selective Photocatalytic Oxidation of 4-Methoxybenzyl Alcohol to p-Anisaldehyde in Organic-Free Water in a Continuous Annular Fixed Bed Reactor
2007
Photocatalytic oxidation of 4-methoxybenzyl alcohol to p-anisaldehyde was performed in water organic-free solutions by using a fixed bed continuous photoreactor containing Pyrex beads on which a TiO2 home prepared photocatalyst was supported. The influence of liquid flow rate, inlet alcohol concentration and catalyst amount on the photoprocess was studied. The highest selectivity to p-anisaldehyde was about 47% being CO2, the other main oxidation product; traces of 4-methoxybenzoic acid were also detected. The radiation field inside the photoreactor has been modelled by applying the Monte Carlo method thus allowing the determination of the local volumetric rate of photon absorption (LVRPA).…
FIA—FT—IR determination of ibuprofen in pharmaceuticals
1992
A method has been developed for the determination of Ibuprofen (2-[4-isobutylphenyl]-propionic acid) in pharmaceuticals by FT-IR, using the carbonyl band which this compound presents at 1710 cm(-1) in carbon tetrachloride solutions. Samples are dissolved in carbon tetrachloride. In this solvent the excipients are not soluble and so the drug can be directly determined without any additional treatment. The use of a simple FIA manifold permits one to carry out this analysis with a low consumption of reagent and the FT-IR provides a continuous monitoring of the spectral base-line which permits an accurate determination of the maximum in the absorbance band. Also, the FIA system permits easy and…
Lead speciation in rainwater samples by modified fused silica capillaries coupled to a direct injection nebulizer (DIN) for sample introduction in IC…
2001
Lead speciation using modified silica capillaries for the introduction of liquid samples to a direct injection nebulizer of an inductively coupled plasma quadrupole mass spectrometer is described and demonstrated. The fused silica capillaries were coated by covalently bonding a cation exchange active organic molecule to the activated capillary surface. The best results were obtained by introducing a bifunctional reagent in a prior step. In this case, a silane reagent was chosen which acted as a methacrylic acid group for further binding. The influence of the chemical modification of the surface of the sample capillary of the DIN on the selective retention of inorganic lead (Pb2+) and trieth…
LC-MS/MS characterisation and determination of dansyl chloride derivatised glyphosate, aminomethylphosphonic acid (AMPA), and glufosinate in foods of…
2021
Abstract Glyphosate and other polar and acidic pesticides have been particularly studied due to the concerns over widespread and intensive use. The chemical properties of these compounds necessitate use of customised methods, such as derivatisation or ion exchange chromatography. These approaches present a compatibility problem with ESI-MS due to presence of salts and non-volatile compounds. For that reason, a simple procedure has been developed for the extraction, pre-column derivatisation with dansyl chloride (5-(dimethylamino)naphthalene-1-sulfonyl chloride), and mass spectrometric detection of glyphosate, AMPA, and glufosinate after the separation on a C18 stationary phase. The dansyl d…
Nitrogen recovery using a membrane contactor: Modelling nitrogen and pH evolution
2020
[EN] A hollow fibre membrane contactor has been applied for nitrogen recovery from anaerobic digestion supernatant at different operating conditions obtaining nitrogen recovery efficiencies over 99 %. A mathematical model able to represent the time evolution of pH and nitrogen concentration during the recovery process is presented in this paper. The developed model accurately reproduced the results obtained in 26 experiments carried out at different pH values (from 9 to 11), temperatures (from 25 to 35 degrees C), membrane surfaces (from 1.2 to 2.4 m(2)) and feed flow rates (from 0.33 x 10(-5) to 5.83 x 10(-5) m(3)/s) predicting the variations in nitrogen recovery rates measured at the diff…
Removal of algae from biological cultures: a challenge for electrocoagulation?
2014
BACKGROUND In the search for novel technologies for the treatment of urban wastewater, combined anaerobic–algae membrane bioreactors have become a very interesting choice. Recovery of algae produced in these reactors has become the key point to obtain a good economic efficiency with this technology. In this work, electrocoagulation is studied as an alternative for the coarse removal of algae from a biological culture. RESULTS Results demonstrate that the electrochemical technology is a suitable technology for this purpose allowing the removal of more than 90% of the algae without modifying significantly the pH and with an operating cost below 0.04 € m−3. The same general trends are observed…
ChemInform Abstract: Metal- and Reagent-Free Highly Selective Anodic Cross-Coupling Reaction of Phenols.
2014
Boron-doped diamond electrodes allow the direct anodic cross-coupling of phenols in hexafluoroisopropanol without using leaving functions or protecting groups.