Search results for "Reliability engineering"

Probabilistic Approach to the Design of Photovoltaic Distributed Generation in Low Voltage Feeder

2006

This paper presents the probabilistic approach to the design of photovoltaic (PV) distributed generation (DG) and its impact on low voltage (LV) feeder. Monte Carlo simulation is used to predict solar radiation and load, and an exact method is used to solve the power flow. The method is tested on two study cases, and the results are compared with those from deterministic approach based on commonly used scenarios. The probabilistic approach is shown necessary to obtain the optimum PV rating based on technical constraints and different objectives, including accepting a reasonable risk when needed. The results also indicate that PV-DG in a realistic case will most probably improve the voltage …

Real time assessment of hand-arm vibration system based on capacitive MEMS accelerometers

2012

Vibrations are a well known potential cause of health diseases and therefore constitute a main concern for the safety of workers in a large number of activities. In order to prevent health hazards, national and international institutions have issued laws and directives which establish recommended limits to the workers' exposure to vibrations during operations. Consequently, if the amount of adsorbed vibration exceeds the allowable daily limits the worker has to stop his job. Recent wireless sensing and communicating technologies can effectively be employed for such purpose, allowing to develop monitoring customized devices at affordable cost which could be easily employed during the workers…

Development of Diagnostic Systems for the Fault Tolerant Operation of Micro-Grids

2010

The progressive penetration level of Distributed Generation (DG) is destined to cause deep changes in the existing distribution networks no longer considered as passive terminations of the whole electrical system. A possible solution is the realization of small networks, namely the Micro-Grids, reproducing in themselves the structure of the main production and distribution of the electrical energy system. In order to gain an adequate reliability level of the micro-grids the individuation and the management of the faults with the goal of maintaining the micro-grid operation (fault tolerant operation) is quite important. In the present paper after the introduction of the aims of several diagn…

A review of multiple faults diagnosis methods in Voltage Source Inverters

2015

This paper examines, as in short review, the methods of diagnosis of simple and multiple faults on Voltage Source Inverter (VSI). The methods examined here are essentially based on the inspection of the load currents. Some of these diagnosis methods are characterized by low computational effort, other for a better reliability avoiding faultless positive tests. Some solutions are characterized by a share of these benefits while others prefer an enforcement of trustworthiness, in spite of the lower calculation amount. The analysis of the technical literature, certainly, offers a glimpse about the creation of new algorithms and significant advances for the future.

Multi-objective strategies for management and design of distributed electric storage systems in a Mediterranean island

2013

The paper proposes an analytical study about the design and operation of distributed Electrical Storage Systems(ESS) in an active distribution network supplying a Mediterranean island, according to different criteria. The approach is based on the application of a multi-objective optimization algorithm (NSGA-II) that outputs a set of optimized schedules of the ESS in different configurations when operated according to different criteria (minimum energy losses in the grid, total generation cost, greenhouse gas emissions, limiting the fluctuations of the generation from fossil fuel plants). Moreover the variability of the voltage profile has been investigated also by a comparison with a refere…

Mechanical Efficiency of SSC Exercise

2010

An economic study about the installation of PV plants reconfiguration systems in Italy

2014

This paper shows the economic convenience of the application of a reconfiguration system for photovoltaic plants, considering the incentives system in Italy and its recent modifications. The reconfiguration is an alternative to the Distributed Maximum Power Point Tracking, DMPPT, technique used to overcome the mismatch problem in Photovoltaic, PV, plants. The reconfiguration techniques employ a microprocessor-based system that modifies the layout of the PV plant by physically changing the connections among modules. After the explanation of the working principle of the PV reconfiguration system allowing the improvement of the efficiency of the same plant and the relevant installation, the ma…

Cost Analysis of FMS Throughput

1988

Abstract The need for an effective cost planning and control system is stressed in today highly competitive manufacturing environment. The conventional approaches of machining economics to cost analysis are no more able to cope with the new structure of the production costs in the highly automated - highly integrated manufacturing systems. Suitable cost analysis procedures should provide a strong integration between process planning data and overall system performances. The here proposed procedure for the estimate of the unit manufacturing cost in FMSs achieves this integration by using performance evaluation techniques like discrete event simulation or queueing network models.

Uprating an Overhead Line. Italian TSO Applications for Integration of RES

2013

The increase of Renewable Energy Sources (RES) production units has caused significant changes in the electrical system configuration. The existing structural asset isn't adequate to dispatch these new power flows that, at same time, should be favorite by various TSOs in order to obtain incentives. The outage of primary substations on the grid and the increase of consumptions have caused growing load currents on existing overhead line. This paper, after introducing thermal resistant conductors and Dynamic Rating (DR) solutions, reports an applications used by TERNA Group S.p.A. (Italian TSO). These systems are already installed on lines and they are contributing to increase power flows than…

Earthing system’s design in presence of non-uniform soil

2007

The authors propose a practical approach for facing the problem of the design of the earthing systems in two-layer soils. The approach is based on the calculation of an equivalent resistivity of the non-uniform soil through which the designer can treat this one as it was uniform. The purpose of the Authors is to provide an innovative simple method and some easy-to-use graphs for an easy earthing systems' design in two-layer soils.