Search results for "Reproducibility"
showing 10 items of 1976 documents
Green determination of eight water-soluble B vitamins in cosmetic products by liquid chromatography with ultraviolet detection.
2021
Abstract B vitamins are a group of compounds with beneficious properties for dermatologic care, and therefore they are included in the cosmetic formulations as high added-value ingredients. In this paper, an analytical method for the simultaneous determination of eight water-soluble B vitamins in cosmetic products is reported for the first time. This method is based on liquid chromatography with ultraviolet detection (LC-UV) analysis after simple water leaching of the analytes from the cosmetic matrix. No organic solvents are required, beyond the ethanol used in the chromatographic mobile phase. The proposed method has been successfully validated showing good linearity, limits of detection …
Sequential-injection determination of traces of disodium phenyl dibenzimidazole tetrasulphonate in urine from users of sunscreens by on-line solid-ph…
2005
Abstract A sensitive and selective method to determine disodium phenyl dibenzimidazole tetrasulphonate (PDT) in the urine of sunscreen users, which is suitable for studies on body accumulation/excretion is proposed. On-line solid-phase extraction allows the analyte to be retained and subsequentely eluted, using a strong anion exchange (SAX) microcolumn. Standard addition calibration was carried out with only one standard. The wavelengths of excitation and emission were 330 and 454 nm, respectively. The method allows PDT to be determined in both, spiked and unspiked human urine samples, without any pre-treatment. Results obtained for spiked urine samples (40–200 ng ml −1 ) showed the accurac…
New micromethod combining miniaturized matrix solid-phase dispersion and in-tube in-valve solid-phase microextraction for estimating polycyclic aroma…
2008
Abstract Miniaturized matrix solid-phase dispersion (MSPD) was developed for the extraction of common polycyclic aromatic hydrocarbons (PAHs) from bivalve samples (100 mg, dry weight). Additional clean-up and analyte enrichment was accomplished by in-tube solid-phase microextraction (SPME). For this purpose the extracts collected after MSPD were diluted with water and injected into a capillary column coated with the extractive phase. This capillary column was connected to the analytical column by means of a switching valve. Separation and quantification of the PAHs were carried out using a monolithic LC column and fluorescence detection. Since the in-tube SPME device allowed the processing …
Protein mapping by two-dimensional high performance liquid chromatography.
2000
Current developments in drug discovery in the pharmaceutical industry require highly efficient analytical systems for protein mapping providing high resolution, robustness, sensitivity, reproducibility and a high throughput of samples. The potential of two-dimensional (2D) HPLC as a complementary method to 2D-gel electrophoresis is investigated, especially in view of speed and repeatability. The method will be applied for proteins of a molecular mass <20 000 which are not well resolved in 2D-gel electrophoresis. The 2D-HPLC system described in this work consisted of anion- or cation-exchange chromatography in the first dimension and reversed-phase chromatography in the second dimension. We …
A direct Capillary Liquid Chromatography with electrochemical detection method for determination of phenols in water samples
2010
A fast and direct method based on the use of Capillary Liquid Chromatography (LC) with electrochemical (EC) detection has been described for phenols pollutants in water samples. Concretely, phenol, o-cresol, 2-chlorophenol and bisphenol A have been selected as target analytes. The combination of Capillary LC with EC detection avoided the necessity of preconcentration steps typically used in environmental analysis. The sample injected volume was 2 μL. The achieved detection limits were between 1 and 2 μg/L and the linear dynamic range was up to 50 μg/L for all studied phenols. The precision and uncertainty were satisfactory. The analysis time per sample was 10 min. The proposed procedure has…
Advantages of monolithic over particulate columns for multiresidue analysis of organic pollutants by in-tube solid-phase microextraction coupled to c…
2011
Abstract The performance of a monolithic C 18 column (150 mm × 0.2 mm i.d.) for multiresidue organic pollutants analysis by in-tube solid-phase microextraction (IT-SPME)-capillary liquid chromatography has been studied, and the results have been compared with those obtained using a particulate C 18 column (150 mm × 0.5 mm i.d., 5 μm). Chromatographic separation has been carried out under isocratic elution conditions, and for detection and identification of the analytes a UV-diode array detector has been employed. Several compounds of different chemical structure and hydrophobicity have been used as model compounds: simazine, atrazine and terbutylazine (triazines), chlorfenvinphos and chlorp…
Improving analysis of apolar organic compounds by the use of a capillary titania-based column: Application to the direct determination of faecal ster…
2010
This article reports a new procedure for the direct determination of faecal sterols coprostanol and cholesterol in wastewater samples as tracers of human sewage contamination. The method combines in-tube solid-phase microextraction (IT-SPME) for analyte enrichment and capillary liquid chromatography (LC) for separation with diode array detection for identification and quantification. A titania-based polymeric capillary column and a conventional octadecyl silica (ODS) capillary column were evaluated and compared for their ability to separate the analytes. The titania-based column allowed the separation of the analytes in much shorter chromatographic times and with better chromatographic prof…
A sequential-injection system for spectrophotometric determination of p -aminobenzoic acid in sunscreens.
2002
A sequential injection method is proposed for spectrophotometric determination of p-aminobenzoic acid (PABA) in cosmetic formulations. The method is based on diazotization of the analyte, coupling with 8-hydroxyquinoline, and the subsequent formation of a colored product. The experimental conditions used (coupling reagent, sandwich arrangement, volumes aspirated, propulsion flow rate, reaction coil length) were studied. Response of the sequential injection method were linearly dependent on concentrations up to 25 micro g mL(-1) and the detection limit was 2 micro g mL(-1). Throughput was 51 measurements per hour and a complete cycle, including three measurement per sample and a washing step…
Determination of fungicide residues in fruits and vegetables by liquid chromatography–atmospheric pressure chemical ionization mass spectrometry
2002
Abstract A liquid chromatography (LC) method for the quantitative determination of five fungicide residues (dichloran, flutriafol, o -phenylphenol, prochloraz and tolclofos methyl) in oranges, lemons, bananas, peppers, chards and onions is described. The residues were extracted by matrix solid-phase dispersion (MSPD) using C 8 . Quantitative analysis was performed by isocratic LC coupled to quadrupole mass spectrometer using atmospheric pressure chemical ionization in the negative ionization mode. The limit of quantification was 0.01 mg kg −1 for flutriafol, o -phenylphenol and dichloran, and 0.1 mg kg −1 for prochloraz and tolclofos methyl. The MSPD method is also suitable for LC–UV analys…
Multiple-stage mass spectrometric analysis of six pesticides in oranges by liquid chromatography–atmospheric pressure chemical ionization–ion trap ma…
2004
Abstract Six pesticides were determined by liquid chromatography (LC) with positive ion (PI) atmospheric pressure chemical ionization quadrupole ion-trap tandem mass spectrometry (APCI–MS–MS). Ion fragmentation was studied by MS, MS 2 and MS 3 . Fragmentation of the pesticides produced ions formed by various losses from the side-chains and through heterocyclic ring opening, but without any common fragmentation pathway. Multiple reaction monitoring (MRM) of MS, MS 2 and MS 3 was used to identify and quantify the pesticides. The samples were extracted with ethyl acetate and dried over anhydrous sodium sulfate. Comparison of the three MS modes showed that MS 3 is slightly less sensitive but mu…