Search results for "Research-Article"
showing 10 items of 258 documents
Effect of surface treatment with sandblasting and Er,Cr:YSGG laser on bonding of stainless steel orthodontic brackets to silver amalgam
2011
Objectives: Satisfactory bonding of orthodontic attachments to amalgam is a challenge for orthodontists. The aim of this in vitro study was to compare the shear bond strength of stainless steel orthodontic brackets to silver amalgam treated with sandblasting and Er,Cr:YSGG laser. Study Design: Fifty-four amalgam discs were prepared, polished and divided into three groups: In group 1 (the control group) the premolar brackets were bonded using Panavia F resin cement without any surface treatment; in groups 2 and 3, the specimens were subjected to sandblasting and Er,Cr:YSGG laser respectively, before bracket bonding. After immersing in distilled water at 37°C for 24 hours, all the specimens w…
Bonding efficacy of an acetone/based etch-and-rinse adhesive after dentin deproteinization
2012
Objectives: to evaluate the effect of sodium hypochlorite (NaOCl) treatment on dentin bonding by means of shear bond strength (SBS) measurements when using Prime&Bond NT (PB NT) adhesive. Ultrastructure of the interfaces was examined by scanning electron microscopy (SEM). Study design: Extracted human third molars were sectioned and ground to expose flat surfaces of superficial or deep dentin. Specimens were randomly assigned to two equal groups, and bonded as follows: (1) according to the manufacturers’ directions, after 35% H3PO4 etching, (2) 5% NaOCl treated for 2 minutes, after 35% H3PO4 etching. Each sample was embedded in a Watanabe shear test assembly for a single plane lap shear. Af…
Nanostructural changes in dentine caused by endodontic irrigants
2013
Objective: To study nanostructural dentinal changes produced by endodontic irrigants. Study Design: Experimental study. Nanoindentations were performed on peritubular (PD) and intertubular dentine (ID) with an atomic force microscopy. Stiffness and adhesion force were determined before and after application of 5.25% sodium hypochlorite (NaOCl) and 17% ethylenediaminetetraacetic acid (EDTA). Normalized differences before and after treatment for stiffness and adhesion forces were calculated. A paired T-test was used to compare stiffnes and adhesion force before and after irrigants application. Results: After treatment with EDTA there was a 29.80% reduction in stiffness in ID and a 63.53% redu…
Curricula for the teaching of complete dentures in Spanish and Portuguese dental schools
2012
Objectives: Given the need to ensure that dentists are sufficiently skilled to offer the best possible care to their patients, this study aims to evaluate the teaching methods and clinical experience achieved by undergraduate dental students in Spain and Portugal as regards complete dentures. Study design: In February 2011, a questionnaire seeking information about the preclinical and clinical teaching of complete dentures was e-mailed to all Spanish and Portuguese dental schools with fully developed undergraduate degree dental programs. Results: A response rate of 82.6% was obtained. The distribution of lectures and hours spent at the laboratory and in clinical activities revealed that tea…
Immediate implants placed in fresh sockets associated to periapical infectious processes: a systematic review
2013
Objetives: The development of treated implant surfaces, added to the increase of the aesthetic requirements by the patients has led to a change in the treatment protocols as well as the development of techniques such as the onefase implants and the immediate prosthetic loading. One of the usual contraindications of the implant treatment is the presence of periapical disease associated to the tooth to be replaced. The aim of this paper is to review the published literature on immediate implant placement in extraction sockets of teeth with periapical pathology, considering the level of scientific evidence, and following the principles of medicine and evidence-based Dentistry. Material and Met…
The effect of pregnancy on orthodontic tooth movement in rats
2012
Introduction: The purpose of this study was to investigate the effect of pregnancy on orthodontic tooth movement in Wistar rats. Material and Methods: Forty eight female three-month old Wistar rats with an average weight of 250 ±25 g r were selected and randomly divided into two experimental (pregnant) and control groups (non-pregnant). Maxillary central incisors were tipped distally by insertion of springs exerting 30g force. Two, seven and fourteen days after spring insertion animals were sacrificed. Then the mesioincisal distance between maxillary incisors were measured. Subsequently, histological sections were prepared to count osteoclasts under a light microscope. The data on the exten…
Fracture resistance of roots filled with three different obturation techniques
2012
Objectives: The aim of this study was to compare in vitro root fracture resistance following root canal filling with AH 26 using lateral condensation, BeeFill, and Thermafil techniques. Study Design: Eighty extracted human mandibular premolars with similar dimensions were selected. In order to standardize the roots, measurements were taken in two separate regions of the teeth—at the cemento-enamel junction and 8 mm apically from the junction—buccolingual as well as mesiodistal for every tooth. Teeth were then randomly divided into five groups (n=16). With the exception of the non-prepared group (Group 1), instrumentation was done in all groups. In group 2, instrumentation but no filling was…
Ex vivo study of bacterial coronal leakage in indirect pulp treatment
2012
Objective: The aim of this study was to evaluate, ex vivo, bacterial coronal leakage with different antimicrobial agents applied to the dentine for indirect pulp treatment (IPT). Study Design: Sixty extracted teeth were prepared and randomly distributed into 5 groups (n=10): Group 1: no antimicrobial dentine treatment; group 2: 1% chlorhexidine (CHX)+1% thymol varnish (Cervitec®); group 3: 2 % CHX solution; group 4: 40% CHX varnish (EC40™) and group 5: Clearfil™ Protect Bond (CPB). Ten teeth served as controls. The teeth were restored using a resin-modified glass ionomer cement (GIC) and then mounted in a two-chamber device. The coronal access was exposed to Streptococcus mutans for 45 days…
Double-application of platelet-rich plasma on bone healing in rabbits
2010
Objective: Platelet-rich plasma (PRP) is considered to enhance bone formation especially at early stages of wound healing, depending on the limited and short life-span of platelets and growth factors. The aim of this study was to evaluate efficacy of double-application of PRP (DA-PRP) on bone healing in a rabbit calvarial defect model. Study design: Twenty-eight rabbits, each had two surgically prepared calvarial bone defects (10mm diameter), were included in this study and randomly divided into six groups. Defects (n=56) were treated with single-application of PRP (SA-PRP)(n=10), SA-PRP and beta-tricalciumphosphate (SA-PRP+TCP)(n=10), DA-PRP (n=8), DA-PRP and beta-tricalciumphosphate (DA-P…
In vitro enterococcus faecalis biofilm formation on five adhesive systems
2011
Objective: To determine the E. faecalis biofilm formation on the surface of five adhesive systems (AS) and its relationship with roughness. Study Design: The formation of E. faecalis biofilms was tested on the surface of four dual-cure AS: AdheSE DC, Clearfil DC Bond, Futurabond DC and Excite DSC and one light-cure antimicrobial AS, Clearfil Protect Bond, after 24 hours of incubation, using the MBEC high-throughput device. Results: E. faecalis biofilms grew on all the adhesives. The least growth of biofilm was on Excite DSC, Clearfil Protect Bond, and the control. Futurabond DC resulted in the greatest roughness and biofilm amount. There was a close relationship between the quantity of biof…