Search results for "Residual stresse"
showing 3 items of 23 documents
ERROR AND UNCERTAINTY ANALYSIS OF THE RESIDUAL STRESSES COMPUTED BY USING THE HOLE DRILLING METHOD
2011
The hole-drilling method is one of the most used techniques for the experimental analysis of the residual stresses in mechanical components. For both through-thickness uniform and non-uniform residual stresses, its practical application is standardised by the ASTM E837-08. For uniform residual stresses, to which the present work deals with, the use of the method in accordance with the ASTM limitations, leads to results with a bias of about 10%. Unfortunately, although some experimental parameters can be frequently out of the corresponding standard limitation, the user does not have appropriate procedures to correct the obtained results which, in accordance with the ASTM standard, have to be…
On the mechanisms involved in the tensile strength of a dissimilar Ti6Al4V/316L laser welded assembly
2021
International audience; The aim of the present work is to analyze the thermomechanical behavior of dissimilar laser seams by means of FE modeling. The case of a Ti6Al4V/316L assembly with vanadium insert was considered. Effective mechanical properties of the main materials and cords were first estimated from NHT measurements. Modeling of the double pass laser welding process was performed first by considering shrinking of the two weld seams during manufacturing, to get the residual stress state in the welded assembly. Modeling of the tensile test was performed in a second step to study the assembly behavior during loading. In these modeling results, the mesh was the cross-section of the mic…
Use of Hybrid Methods (Hole-Drilling and Ring-Core) for the Analysis of the RS on Welded Joints
2022
The hybrid methods (HMs) for the residual stress (RS) analysis, such as the well-known hole-drilling method (HDM) and the ring-core method (RCM), have been widely developed since 80’. They are mechanical methods based on the partial relaxation of the RSs that occur when a proper geometry variation of the analysed component is introduced by drilling a hole (HDM) or a proper annular groove (RCM). The RS computation is performed by measuring the strains relaxed on surface and then by combine properly such measured strains with the influence coefficients previously computed accurately by using a numerical codes that consider the geometry of the particular component to be examined. In such a man…