Search results for "Roof"

Modular, customisable, accomodation-friendly antenna system for satellite avionics: Development, prototyping and validation

2014

In the frame of ESA program AO/1- 6737/11/NL/MH, an innovative X-band antenna system for satellite avionics has been studied, demonstrated and validated at Proof of Concept Model level. The innovative contribution of such an antenna system relies on modularity, customizability and accommodation friendliness. The antenna concept is based on a Plug and Play architecture, where the basic module is a 2.7 cm-cube with a mass of 53 gr, which can be clustered in array configuration. A catalogue of predefined and ready-to-use clusters could be developed with the possibility of adapting the antenna systems to various platform types by tuning just a few control parameters. Different levels of customi…

Building green covering for a sustainable use of energy

2013

Nowadays the growth of the cities increased built and paved areas, energy use and heat generation. The phenomenon of urban warming, called urban heat island, influences negatively outdoor comfort conditions, pollutants concentration, energy demand for air conditioning, as well as increases environmental impact due to the demand of energy generation. A sustainable technology for improving the energy efficiency of buildings is the use of green roofs and walls in order to reduce the energy consumption for conditioning in summer and improve the thermal insulation in winter. The use of green roofs and walls can contribute to mitigate the phenomenon of heat island, the emissions of greenhouse gas…

Proof of Concept of an Irradiance Estimation System for Reconfigurable Photovoltaic Arrays

2015

In order to reduce the mismatch effect caused by non-uniform shadows in PV arrays, reconfigurable interconnections approaches have been recently proposed in the literature. These systems usually require the knowledge of the solar radiation affecting every solar module. The aim of this work is to evaluate the effectiveness of three irradiance estimation approaches in order to define which can be well suited for reconfigurable PV arrays. It is presented a real-time solar irradiance estimation device (IrradEst), implementing the three different estimation methods. The proposed system is based on mathematical models of PV modules enabling to estimate irradiation values by sensing a combination …

Manufacturing tolerances effects on PV array energy production

2014

This paper investigates the tolerance effects of commercial photovoltaic modules in terms of electrical energy reduction of photovoltaic plants. Several commercial modules, having the same rated power, present different power tolerance values. A wide tolerance is an indicator of possible defects or differences in the production process and is responsible of remarkable reductions in the electricity production of photovoltaic plants. In this paper, thanks to the development of a suitable simulation tool, several simulations have been carried out, considering different tolerance and shading conditions for the PV array. Simulation results quantify the peak power value of the different plant con…

Six-years-long effects of the Italian policies for photovoltaics on the grid parity of grid-connected photovoltaic systems installed in urban contexts

2017

Abstract The purpose of this study is investigating the grid parity (GP) time and the levelized cost of energy (LCOE) of grid-connected photovoltaic (PV) systems installed in densely urbanized contexts. The analysis, which was elaborated for three Italian cities, considered the effects of the promoting policies enacted by the Italian government from June 2010 to May 2016. An appropriate methodology was applied with the aim of realistically defining the energy produced by PV systems installed on buildings with different roof types and number of floors. The calculus of the disbursements considered the operating, maintenance and insurance costs and the wear of PV panels and inverters. The resu…

Long term energy efficiency study on different wall envelopes in Latvian climate conditions

2017

Abstract Five test stands have been built in Riga, Latvia equipped with sensors (temperature, solar radiation, humidity, etc.) to measure energy efficiency and thermal comfort conditions. Roof and floor constructions are made the same. For the walls building envelopes differ and typical materials used in Latvia (aerated concrete, ceramic building blocks, wooden log and plywood frame with rock wool insulation) are compared. Only rock wool is used for insulation to provide moisture transport through the construction. For study to be comparative thermal transmittance of all five test stands have been calculated equal (U=0.15…0.16 W/(m 2 ∙K)). The aim of research is to compare the integral calc…

The cost of green roofs disposal in a life cycle perspective: covering the gap.

2012

Abstract This study is aimed at providing a contribution in overcoming the current gap, especially in Life Cycle Costing (LCC) and Benefit – Cost (BCA) analyses, due to the lack concerning the green roof disposal costs. Therefore, we have applied to an actual extensive green roof the LCC methodology suggested by D. G. Woodward (that appears like one of the most formalized and generalizable), but we have extended the analysis to the disposal phase. This will allow a complete and proper application of the LCC methodology in order of achieving an economic accounting of this component through its life cycle. In this way, it is possible to achieve the complete evaluation of the “green roof” perf…

A simple and accurate model of photovoltaic modules for power system design

2014

Embedding “substrate” in environmental assessment of green roofs life cycle: evidences from an application to the whole chain in a Mediterranean site

2012

Abstract A classical LCA methodology is here applied to green roofs including in this analysis also the whole life cycle of the substrate, that represented a lack of previous LCA studies on green roofs. This inclusion will allow a complete and proper application of the LCA methodology to achieve an environmental accounting of the “green roof” performance. We have here chosen to approach the problem by analysing a specific substrate, that is used within an actual extensive green roof. Afterwards, we have applied the LCA methodology to the whole actual extensive green roof whose substrate under analysis is part of. In this manner, we achieved an environmental accounting of the “green roof” pe…

Review on photovoltaic based active generator

2015

An active generator has the capacity to support frequency control and instantaneous power balance. The grid operator adjusts the power dispatch of generators according to power demand fluctuations. Photovoltaic (PV) based active generators can be used as load following generators in the same manner as other power dispatch generators. This new type of distribution system, based on active generator(s), needs new innovative management and operation strategies for increasing the penetration of intermittent renewable energy systems. The considered PV based active generator has three units, i.e., PV array, battery storage and super capacitor. In this review paper, the management and operation app…