Search results for "SEQUENCING BATCH REACTOR"
showing 8 items of 28 documents
Aerobic granular sludge: State of the art, applications, and new perspectives.
2018
The aerobic granular sludge (AGS) process has attracted significant interest over the last decade and is one of the most promising wastewater treatment technologies. AGS offers several advantages over conventional activated sludge (CAS) including excellent settling, and higher volumetric loading capacity. Because of porosity, concentration gradients develop and stratified aerobic, anoxic, and anaerobic layers develop throughout granule depth. This is the reason for simultaneous nutrient removal in a single tank. Aerobic granulation is influenced by many parameters including wastewater characteristics and operating conditions. Among these, the anaerobic upflow feeding strategy and a properly…
Effect of pH on biological phosphorus uptake.
2006
An anaerobic aerobic laboratory scale sequencing batch reactor (SBR) was operated to study the effect of pH on enhanced biological phosphorus removal. Seven steady states were achieved under different operating conditions. In all of them, a slight variation in the pH value was observed during anaerobic phase. However, pH rose significantly during aerobic phase. The increase observed was due to phosphorus uptake and carbon dioxide stripping. When pH was higher than 8.2-8.25 the phosphorus uptake rate clearly decreased. The capability of Activated Sludge Model No. 2d (ASM2d) and Biological Nutrient Removal Model No. 1 (BNRM1) to simulate experimental results was evaluated. Both models success…
Process understanding of a wastewater batch reactor with block-wise PLS
2007
In this work a systematic methodology ‘block-wise PLS’ has been applied to thoroughly analyse data from a sequencing batch reactor (SBR) operated for biological phosphorus removal from wastewater. The aim of this study was to diagnose process variables (collected by the inexpensive and low-maintenance sensors installed in the SBR) likely related to the main key indicator of process performance: the phosphorus removal efficiency (PRE), determined off-line in the quality control laboratory. In this way, it is intended to aid the process operators in the detection of abnormal values of these critical variables which would indicate undesirable process performance, so that, they could act on the…
Using Unfold-PCA for batch-to-batch start-up process understanding and steady-state identification in a sequencing batch reactor
2007
In chemical and biochemical processes, steady-state models are widely used for process assessment, control and optimisation. In these models, parameter adjustment requires data collected under nearly steady-state conditions. Several approaches have been developed for steady-state identification (SSID) in continuous processes, but no attempt has been made to adapt them to the singularities of batch processes. The main aim of this paper is to propose an automated method based on batch-wise unfolding of the three-way batch process data followed by a principal component analysis (Unfold-PCA) in combination with the methodology of Brown and Rhinehart 2 for SSID. A second goal of this paper is to…
Effect of the applied organic load rate on biodegradable polymer production by mixed microbial cultures in a Sequencing Batch Reactor
2006
This article studies the operation of a new process for the production of biopolymers (polyhydroxyalkanoates, PHAs) at different applied organic load rates (OLRs). The process is based on the aerobic enrichment of activated sludge to obtain mixed cultures able to store PHAs at high rates and yields. A mixture of acetic, lactic, and propionic acids at different concentrations (in the range 8.5-31.25 gCOD/L) was fed every 2 h in a sequencing batch reactor (SBR). The resulting applied OLR was in the range 8.5-31.25 gCOD/L/day. Even though, as expected, the increase in the OLR caused an increase in biomass concentration (up to about 8.7 g COD/L), it also caused a relevant decrease of maximal po…
Detection and prevention of enhanced biological phosphorus removal deterioration caused by Zoogloea overabundance.
2008
A sequencing batch reactor was operated in the conventional anaerobic-aerobic mode for enhanced biological phosphorus removal using acetate as the sole substrate. Despite the nutrients concentrations in the influent being high enough to satisfy the biological requirements, Zoogloea ramigera managed to grow in the system until it had negative effects on the process performance. The excess of exocellular polymeric material produced by this microorganism contributed to a viscous bulking phenomenon and caused important settling problems. The examination of the sludge under the microscope was a valuable tool to diagnose the cause of the imbalance in the process. The strategy adopted to avoid the…
Removal of bis (2-ethylhexyl) phthalate from reject water in a nitrogen-removing sequencing batch reactor.
2003
Reject water from sewage sludge processing may contain high concentrations of nutrients and organic pollutants and cause internal pollution load at a sewage treatment plant (STP) if circulated to the headworks of an STP. In the present study removal of nitrogen and bis (2-ethylhexyl) phthalate (DEHP) from reject water was studied in two sequencing batch reactors (SBRs) with different aerobic/anoxic periods during a 6-h total cycle period. Ammonia-nitrogen (NH(4)-N) was almost totally removed in both reactors, apparently by nitrification throughout the run, while denitrification declined with decreasing SCOD in the influent resulting in an increase in the effluent nitrate-nitrogen (NO(3)-N) …
Effect of long-term salinity increase on nitritation and denitritation kinetics in activated sludge and granular sludge reactors
2017
The aim of this work was to investigate the effects of moderate and drastic long-termincrease of salinity.Particularly, the study was aimed at assessing the shock effecton nitritationand denitritation kineticsof halophilic biomass inboth forms:flocculent activated sludge and granular sludge.