Search results for "SIMULATION"

Analisi dell'effetto di scabrezze irregolari 2D e 3D sui campi di moto turbolenti.

2012

Dissipative scaling of step-pool features

2021

Abstract This paper focuses on the dissipative similarity of step-pool units at rill, flume and stream scale. This investigation is carried out using recent advances in open channel flow resistance, applications of close-range photogrammetry to rill erosion, available published data on step-pool features in flumes and streams and a new dataset of measurements in fixed bed step-pool rills. A theoretically-based equation for calculating the Darcy-Weisbach friction factor obtained by integration of a power velocity profile is presented. The scale factor Γ of this power velocity profile, which is included in the flow resistance equation, was previously calibrated (Eq. 10) for mobile bed rills w…

Is there any scaling in the cluster distribution?

1994

We apply fractal analysis methods to investigate the scaling properties in the Abell and ACO catalogs of rich galaxy clusters. We also discuss different technical aspects of the method when applied to data sets with small number of points as the cluster catalogs. Results are compared with simulations based on the Zel'dovich approximation. We limit our analysis to scales less than 100 $\hm$. The cluster distribution show a scale invariant multifractal behavior in a limited scale range. For the Abell catalog this range is 15--60$\hm$, while for the ACO sample it extends to smaller scales. Despite this difference in the extension of the scale--range where scale--invariant clustering takes plac…

Finding Possible Weakness in the Runoff Simulation Experiments to Assess Rill Erosion Changes without Non-Intermittent Surveying Capabilities

2020

The Terrestrial Photogrammetry Scanner (TEPHOS) offers the possibility to precisely monitor linear erosion features using the Structure from Motion (SfM) technique. This is a static, multi-camera array and dynamically moves the digital videoframe camera designed to obtain 3-D models of rills before and after the runoff experiments. The main goals were to (1) obtain better insight into the rills

Numerical study of the components positioning influence on the stability of a reverse shoulder prosthesis

2014

Aim of this paper is to setup a novel procedure able to analyze performances of a reverse shoulder prosthesis when different geometrical configurations are assumed. Nowadays, such a prosthesis is widely used but, because of its novelty, data in literature give poor information about performances and limits to its applicability. The activity has been divided into the following steps. At the beginning the shape of the prosthesis has been digitally acquired via a 3D scanner. Then, CAD models of all prosthetic components have been geometrically optimized in a way to obtain final entities suitable for numerical simulations. After that, CAD assemblies have been created between prosthetic componen…

Thermoelastic stress analysis by means of an infrared scanner and a two-dimensional fast Fourier transform-based lock-in technique

2008

An infrared thermographic experimental set-up has been proposed and evaluated towards the capability to measure thermoelastic-effect-induced temperature changes. A standard infrared thermocamera with a nominal noise-equivalent temperature difference (NETD) resolution of 0.12 K has been employed to measure the temperature from unidirectional glass-reinforced plastic tensile coupons under cyclic sinusoidal loads. The raster scanning mode of the camera single detector produces a time delay in acquiring the signal from two succeeding pixels on the same row, and from consecutive scanned rows. By exploiting the acquired dwell times, it was possible to produce a periodic pattern on the thermal ma…

34. Accomplishing the requirements within the new decree 159/2016: Comparative study of eddy currents induced in a human phantom moving near differen…

2018

Purpose In order to provide adequate risk-reducing procedures for MRI personnel (radiographers, anaesthetists, physicists, nurses, technicians, cleaners, etc.), different studies have been developed in the past years. Further to those, in the present work risk assessment concerned with currents induced by non-uniform static magnetic fields in MRI operators performing different tasks in proximity of the scanner has been investigated across a set of different 1.5 T MRI scanners. Methods The first step has been to empirically map the magnetic field around the different scanners and to select a proper adult human body as a heterogeneous volume conductor model. Then, upon observing the way tasks…

Transport of Mobile Particles in an Immobile Environment: Computer Simulations of Sodium Silicates

2007

Molecular dynamics (MD) simulations of various sodium silicate melts, (Na2O)x(SiO2) with x=2, 3, 20, are presented. In these systems, the mobility of sodium ions is much higher, often by orders of magnitude, than that of the silicon and oxygen atoms forming a tetrahedral network structure. We show that the high mobility of sodium is intimately related to the chemical ordering in sodium silicates. A network of percolating sodium-rich channels is formed in the static structure that serve as diffusion channels for the sodium ions. This channel network is revealed in static structure factors by a prepeak at the wavenumber q=0.95 A-1. Inelastic neutron scattering experiments of sodium silicate m…

Checkpointing Workflows for Fail-Stop Errors

2017

International audience; We consider the problem of orchestrating the exe- cution of workflow applications structured as Directed Acyclic Graphs (DAGs) on parallel computing platforms that are subject to fail-stop failures. The objective is to minimize expected overall execution time, or makespan. A solution to this problem consists of a schedule of the workflow tasks on the available processors and of a decision of which application data to checkpoint to stable storage, so as to mitigate the impact of processor failures. For general DAGs this problem is hopelessly intractable. In fact, given a solution, computing its expected makespan is still a difficult problem. To address this challenge,…

The apparent losses due to metering errors: a proactive approach to predict losses and schedule maintenance

2014

The effects of water meter age and private tanks on the apparent losses due to metering errors were evaluated by experimental and theoretical analyses. A monitoring campaign on a small district metered area (DMA) was carried out to determine the causes of apparent losses and implement a numerical model. Metering errors are affected by the flow rate passing through the meter, which is dependent on the network pressure and water level of the private tank. A node model that reproduces the effect of private tanks was coupled with EPANET and was applied to the DMA. The proposed modelling approach was used to identify where apparent losses are higher and to schedule maintenance. The model predict…