Search results for "SOLVENT"
showing 10 items of 1395 documents
A cost-effective method for estimating di(2-ethylhexyl)phthalate in coastal sediments.
2013
This study describes the development of a new method for the analysis of di(2-ethylhexyl)phthalate (DEHP) using 0.1-0.3 g of sediment sample, based on matrix solid phase dispersion (MSPD) using C18 as dispersant phase (0.4 g) and acetonitrile-water as eluting solvent (3.4 mL 1:3.25, v/v). No evaporation step is required. 3 mL of extracts were processed on-line by in-tube solid phase microextraction (IT-SPME) coupled to capillary liquid chromatography (CapLC) and diode array detector (DAD). A short analytical column Zorbax SB C18 (35×0.5 mm, 5 μm) provided suitable results. FTIR-ATR was employed for characterizing sediment samples and MSPD procedure. The total analysis time was less than 20 …
An Infrared Method, with Reduced Solvent Consumption, for the Determination of Chlorsulfuron in Pesticide Formulations
2003
A simple method has been developed for the determination of Chlorsulfuron in pesticide formulations by Fourier Transform Infrared (FTIR). Samples were diluted with CHCl3− , and the FTIR spectra of the samples and standards were obtained at a nominal resolution of 4 cm− 1 from 4000 to 900 cm− 1 with the accumulation of 25 scans. Chlorsulfuron determination was based on the measurement of peak area values from 1373 to 1363 cm− 1 which were corrected by use of a two points baseline defined from 1401 to 1302 cm− 1. The limit of detection achieved, which was of the order of 6 µg g− 1, was appropriate for the determination of Chlorsulfuron in commercially available formulations. FTIR results were…
A rapid HPLC assay for zearalenone in laboratory cultures ofFusarium graminearum
1993
A high pressure liquid chromatographic (HPLC) method to determine zearalenone in corn contaminated withFusarium graminearum is described. After extraction with methanol-water and solvent partition, samples were cleaned up by applying the extract to a disposable silica cartridge and by eluting the toxin with a mixture of hexane/dry ethyl ether (5/5). Separation was achieved by a reverse phase μBondapak C18 column followed by fluorescence detection using an excitation wavelength at 274 nm and an emission wavelength at 440 nm. Detection limit was about 5 ng. Recoveries ranging from 85.37 to 100.97%, in standard solutions range 30–0.5 µg/ml, were found.
An environmentally friendly multicommutated alternative to the reference method for anionic surfactant determination in water
2004
Abstract It has been developed a fully mechanized procedure for the spectrophotometric determination of anionic surfactants in water expressed in terms of SDS concentration. The reference method, based on the reaction of SDS with methylene blue (MB) followed by extraction in chloroform, was mechanized in order to reduce the consumption of organic solvents. The system was based on the multicommutation approach and provided a 35 times reduction of the waste production without sacrificing the figures of merit of the method in terms of sensitivity and repeatability, for a dynamic linear range from 0.2 to 1.7 mg l−1. Results obtained for washing water samples were comparable with those obtained …
A rapid and reliable size-exclusion chromatographic method for determination of kojic dipalmitate in skin-whitening cosmetic products
2007
A size-exclusion chromatographic method has been developed to determine the relatively novel skin-whitening agent called kojic dipalmitate (KDP) in skin-whitening cosmetic products. Preliminary experiments were carried out in order to select the solvent for standard and sample solution, and also for mobile phase composition. A PLGel Mixed-D (polystyrene/divinylbenzene co-polymer) column and isocratic mobile phase of pure tetrahydrofuran (at 1.5 mL min(-1) flow rate) were used. Detection was carried out by means of an UV/vis spectrometry detector set at 248 nm. A study of interferences reveals that KDP can be determined without interferences coming from cosmetic matrices. Most other cosmetic…
Matrix solid-phase dispersion extraction procedure for multiresidue pesticide analysis in oranges.
1996
A multiresidue extraction method based on matrix solid-phase dispersion (MSPD) is optimized for the extraction and gas chromatographic screening of eighteen insecticides (aldrin, carbophenothion, captafol, chlorpyriphos, chlorfenvinphos, diazinon, dicofol, alpha-endosulfan, beta-endosulfan, ethion, fenitrothion, folpet, methidathion, malathion, methyl-azinphos, methyl-parathion, phosmet, and tetradifon) from oranges. After optimization of different parameters, such as type of solid phase used and the amount of solid phase or eluent, recoveries ranged from 67 to 102% with relative standard deviations ranging from 2 to 10%. The limits of detection, calculated as 3 times the baseline noise ran…
A multicommuted flow system with solenoid micro-pumps for paraquat determination in natural waters.
2007
A flow system designed with solenoid micro-pumps is proposed for the determination of paraquat in natural waters. The procedure involves the reaction of paraquat with dehydroascorbic acid followed by spectrophotometric measurements. The proposed procedure minimizes the main drawbacks related to the standard chromatographic procedure and to flow analysis and manual methods with spectrophotometric detection based on the reaction with sodium dithionite, i.e. high solvent consumption and waste generation and low sampling rate for chromatography and high instability of the reagent in the spectrophotometric procedures. A home-made 10-cm optical-path flow cell was employed for improving sensitivit…
Determination of organophosphorus pesticides in honeybees after solid-phase microextraction.
2001
A method based on solid-phase microextraction (SPME) followed by gas chromatography with nitrogen-phosphorus detection was developed for the purpose of determining 18 organophosphorus pesticide residues in honeybee samples (Apis mellifera). The extraction capacities of polyacrylate and poly(dimethylsiloxane) fibers were compared. The main factors affecting the SPME process, such as the absorption time profile, salt, and temperature, were optimized. The method involved honeybee sample homogenization, elution with an acetone:water solution (1:1) and dilution in water prior to fiber extraction. Moreover, the matrix effect on the extraction was evaluated. In samples spiked at the 0.2 mg kg(-1) …
Development of a new method for the separation of vanadium species and chloride interference removal using modified silica capillaries-DIN-ICP-MS
2004
Abstract A new on-line method for the separation of vanadium (IV) and vanadium (V) as well as for the removal of ClO+ mass spectral interference on vanadium determination by quadrupole-ICP-MS has been developed. The sample introduction system consists of a modified fused silica capillary coupled to a direct injection nebuliser (DIN), between the solvent delivery system and the ICP. Fused silica capillaries were treated with different anion and cation exchanger reagents and were tested for the retention of Cl− and the separation of vanadium ions at μg l−1 levels. A suitable strong anion exchanger functional group (3-aminopropyltrimethoxy silane) was selected. Chlorine anions were retained in…
Determination of N -nitrosamines in cosmetic products by vortex-assisted reversed-phase dispersive liquid-liquid microextraction and liquid chromatog…
2018
A new analytical method for the simultaneous determination of trace levels of seven prohibited N-nitrosamines (N-nitrosodimethylamine, N-nitrosoethylmethylamine, N-nitrosopyrrolidine, N-nitrosodiethylamine, N-nitrosopiperidine, N-nitrosomorpholine, and N-nitrosodiethanolamine) in cosmetic products has been developed. The method is based on vortex-assisted reversed-phase dispersive liquid-liquid microextraction, which allows the extraction of highly polar compounds, followed by liquid chromatography with mass spectrometry. The variables involved in the extraction process were studied to obtain the highest enrichment factor. Under the selected conditions, 75 μL of water as extraction solvent …