Search results for "SPREADER"
showing 6 items of 6 documents
‘Too interconnected to fail’ financial network of US CDS market: Topological fragility and systemic risk
2012
A small segment of credit default swaps (CDS) on residential mortgage backed securities (RMBS) stand implicated in the 2007 financial crisis. The dominance of a few big players in the chains of insurance and reinsurance for CDS credit risk mitigation for banks' assets has led to the idea of too interconnected to fail (TITF) resulting, as in the case of AIG, of a tax payer bailout. We provide an empirical reconstruction of the US CDS network based on the FDIC Call Reports for off balance sheet bank data for the 4th quarter in 2007 and 2008. The propagation of financial contagion in networks with dense clustering which reflects high concentration or localization of exposures between few parti…
Local Effects of Longitudinal Heat Conduction in Plate Heat Exchangers
2007
Abstract In a plate heat exchanger, heat transfer from the hot to the cold fluid is a multi-dimensional conjugate problem, in which longitudinal heat conduction (LHC) along the dividing walls often plays some role and can not be neglected. Large-scale , or end-to-end, LHC is always detrimental to the exchanger’s effectiveness. On the contrary, if significant non-uniformities exist in the distribution of either convective heat transfer coefficient, small-scale , or local, LHC may actually enhance the exchanger’s performance by improving the thermal coupling between high heat transfer spots located on the opposite sides of the dividing wall.
The inclination effect on the performance of water-filled heat pipes
1991
Abstract Heat pipes have been used in wide ranges of applications today including solar engineering. During this research study, the inclination dependent performance of water filled heat pipes was investigated both theoretically and experimentally for solar energy applications. The results showed that the performance of water-filled heat pipes are strongly dependent on the inclination and the heat source temperatures. As a general result, the heat transfer capability of water filled heat pipes is reduced dramatically below a 45° tilt angle.
Development of a High Irradiance LED Configuration for Small Field of View Motion Estimation of Fertilizer Particles
2015
International audience; Better characterization of the fertilizer spreading process, especially the fertilizer pattern distribution on the ground, requires an accurate measurement of individual particle properties and dynamics. Both 2D and 3D high speed imaging techniques have been developed for this purpose. To maximize the accuracy of the predictions, a specific illumination level is required. This paper describes the development of a high irradiance LED system for high speed motion estimation of fertilizer particles. A spectral sensitivity factor was used to select the optimal LED in relation to the used camera from a range of commercially available high power LEDs. A multiple objective …
High Speed Stereovision Setup for Position and Motion Estimation of Fertilizer Particles Leaving a Centrifugal Spreader
2014
EA SPE GEAPSI; International audience; A 3D imaging technique using a high speed binocular stereovision system was developed in combination with corresponding image processing algorithms for accurate determination of the parameters of particles leaving the spinning disks of centrifugal fertilizer spreaders. Validation of the stereo-matching algorithm using a virtual 3D stereovision simulator indicated an error of less than 2 pixels for 90% of the particles. The setup was validated using the cylindrical spread pattern of an experimental spreader. A 2D correlation coefficient of 90% and a Relative Error of 27% was found between the experimental results and the (simulated) spread pattern obtai…
A 3-D simulation with virtual stereo rig for centrifugal fertilizer spreading
2012
International audience; Stereovision can be used to characterize of the fertilizer centrifugal spreading process and to control the spreading fertilizer distribution pattern on the ground reference. Fertilizer grains, however, resemble each other and the grain images contain little information on texture. Therefore, the accuracy of stereo matching algorithms in literature cannot be used as a reference for stereo images of fertilizer grains. In order to evaluate stereo matching algorithms applied to images of grains a generator of synthetic stereo particle images is presented in this paper. The particle stereo image generator consists of two main parts: the particle 3D position generator and…