Search results for "SUBSTANCES"

RAVITA Technology : new innovation for combined phosphorus and nitrogen recovery

2018

Abstract Present phosphorus (P) recovery technologies mainly contain P recovery from sludge liquor or ash. These types of technologies are suitable for large wastewater treatment plants (WWTPs) with enhanced biological phosphorus removal (EBPR), digestion and/or incineration. In Finland and other Nordic countries, strict P discharge limits require chemical precipitation, thus EBPR alone is not sufficient. Ammonium recovery from wastewater, on the other hand, is not so often discussed. However, recovery from WWTP reject waters would decrease the energy demand of ammonium synthesis by Haber-Bosh technology and the energy demand of the WWTP's biological process. Helsinki Region Environmental S…

Microstructure and rheological response of laboratory-aged SBS-modified bitumens

2019

Polymer additives are widely used to improve the performance of road bitumens including their resistance to hardening during oxidation, although their oxidative inhibitor effect has not been well documented. This study aims to investigate the effect of laboratory-simulated ageing on the microstructure, and rheological properties of Polymer Modified Bitumens (PMBs) prepared with a Styrene-Butadiene-Styrene (SBS) copolymer and sulphur as a cross-linker. The laboratory ageing was conducted through the Rolling Thin Film Oven (RTFO) and the Pressure Aging Vessel (PAV) procedures. The unaged and aged binders were characterised using the Multiple Stress Creep and Recovery (MSCR) test, Gel Permeati…

Cyclodextrins in polymer synthesis: Influence of methylated β-cyclodextrin as host on the free radical copolymerization reactivity ratios of hydropho…

2001

Methylated (β-cyclodextrin (me-β-CD) was used to complex the hydrophobic monomers n-butyl acrylate (1), n-hexyl acrylate (2) and cyclohexyl acrylate (3) yielding the corresponding water soluble host/guest complexes 1a–3a. The complexes were copolymerized in water by free radical mechanism and the reactivity ratios were determined by measuring the monomer consumption by HPLC. The following reactivity ratios were found: copolymerization of 1a and 2a: r1= 1.01 ± 0.01; r2= 1.04 ± 0.01; copolymerization of 3a and 2a: r1= 0.74; r2= 1.28; copolymerization of 3a and 1a: r1= 0.75 ± 0.04; r2= 1.13 ± 0.01. In contrast to that, the copolymerization of the uncomplexed monomers 1–3 in organic medium (DMF…

Kinetics and Mechanisms in the Anionic Polymerization of Methacrylic Esters

1987

Under appropriate conditions the anionic polymerization of methacrylates proceeds in an ideal manner leading to polymers with narrow molecular weight distributions. From the kinetics of polymerization and from the microstructure of the polymers the existence of different active species is concluded, the most important one being a peripherally solvated contact ion pair. Depending on polymerization conditions two different modes of monomer addition can occur. Homo- and copolymerization experiments show that the influence of the ester group is mainly given by electronic effects. In non- polar solvents the polymerization of tert.-butyl methacrylate (in contrast to methyl methacrylate) leads to …

Supramolecular Polymers in Aqueous Media

2016

This review discusses one-dimensional supramolecular polymers that form in aqueous media. First, naturally occurring supramolecular polymers are described, in particular, amyloid fibrils, actin filaments, and microtubules. Their structural, thermodynamic, kinetic, and nanomechanical properties are highlighted, as well as their importance for the advancement of biologically inspired supramolecular polymer materials. Second, five classes of synthetic supramolecular polymers are described: systems based on (1) hydrogen-bond motifs, (2) large π-conjugated surfaces, (3) host-guest interactions, (4) peptides, and (5) DNA. We focus on recent studies that address key challenges in the field, provid…

Reversible swelling of polyanion/polycation multilayer films in solutions of different ionic strength

1996

Immersion of consecutively adsorbed polyanion/polycation multilayer films in solutions of different ionic strength causes reversible thickness changes. Swelling of the films up to 18% was observed after soaking the films in aqueous solutions of NaCl at concentrations up to 1.0 mol/l. X-ray reflectivity clearly shows that the thickness changes are reversible within experimental error and that the films seem to get smoother after several cycles of immersion in salt solutions and in pure water. The extent of swelling depends on the internal film structure, namely on the number of polyanion/polycation interfaces in a film of a given thickness. Interestingly, the swelling levels off at salt conc…

Polymerization of Mono- and Bi-functional Diacetylene Derivatives in Monolayers at the Gas-Water Interface

1979

The spreading and polymerization behaviour of long chain acids and phospholipid analogues containing diacetylene groups is described. Especially the polymerization in monolayers is followed spectroscopically with a new device used in connection with a commercial UV spectrometer. The polymerization is topochemically controlled. Sonification of the phospholipid analogues in water results in the formation of liposomes with multilayered membranes. Polymerization of the liposomes in water forms aqueous solutions of polymer vesicles.

From Biocompatible to Biodegradable: Poly(Ethylene Glycol)s with Predetermined Breaking Points

2013

Poly(ethylene glycol) (PEG) is the gold standard polymer for biomedical applications. PEG is known for its biocompatibility and antifouling properties and is widely used for bioconjugation. However, like other synthetic polymers in the field, PEG is not biodegradable, limiting its use for parenteral formulations and protein conjugation to a molecular weight range with a specific upper limit (commonly 40–60 kDa) to avoid polyether accumulation in human tissue. For these biomedical applications, but also for other purposes such as cleavable hydrogels and templates for porous membranes, several routes for the insertion of in-chain biocleavable moieties, such as acetals or disulfides, into PEG …

Patterns of expression of trichocytic and epithelial cytokeratins in mammalian tissues

1988

Abstract Cells forming hair and nail material are characterized by the synthesis of members of a particular group of α-keratin polypeptides (trichocytic cytokeratins, “T cytokeratins”) different from epithelial cytokeratins (“E cytokeratins”). As the precursor cells to trichocytes are derived from fetal epidermal keratinocytes expressing only E cytokeratins, we have studied the patterns of expression of both T and E cytokeratins in developing human hair-and nailforming tissues of different fetal stages, by immunocyto-chemistry using antibodies specific for certain T or E cytokeratins and by two-dimensional gel electrophoresis and immunoblotting. In developing hair follicles up to the early …

1983

Poly(ethylene glycol)s grated onto suitably functionalized, crosslinked polystyrenes were introduced as a new class of multidetachably immobilized hydrophilic macromolecular supports for the synthesis of peptides. This new polymeric carrier system facilitates both the homogeneous solvation of the reaction site and the insolubilization of the substrate, which are prerequisites for an efficient multistep synthesis using polymeric supports. In these support systems, a strongly solvated hydrophilic linear chain molecule, poly(ethylene glycol) (PEG)1 , is attached to an insoluble, crosslinked polystyrene through suitable anchoring linkages. At the free chain end of this supported PEG, amino acid…