Search results for "Selenide"
showing 10 items of 100 documents
Transport properties of nitrogen doped p‐gallium selenide single crystals
1996
Nitrogen doped gallium selenide single crystals are studied through Hall effect and photoluminescence measurements in the temperature ranges from 150 to 700 K and from 30 to 45 K, respectively. The doping effect of nitrogen is established and room temperature resistivities as low as 20 Ω cm are measured. The temperature dependence of the hole concentration can be explained through a single acceptor‐single donor model, the acceptor ionization energy being 210 meV, with a very low compensation rate. The high quality of nitrogen doped GaSe single crystals is confirmed by photoluminescence spectra exhibiting only exciton related peaks. Two phonon scattering mechanisms must be considered in orde…
CIGS PV Module Characteristic Curves Under Chemical Composition and Thickness Variations
2014
This paper analyzes how the electrical characteristics of a CIGS photovoltaic module are affected by the chemical composition and by the thickness variations of the CIGS absorber. The electrical characteristics here considered are the short circuit current, the open circuit voltage, the efficiency and the power peak. The chemical composition is varied by tuning the ratio between gallium and indium. This analysis has been performed by means of the wxAMPS software, developed by the University of Illinois. The above variations have been taken into account on a PV module made of 72 cells. This analysis has been carried out employing a PV module mathematical model developed and implemented by th…
Fabrication and Photoelectrochemical Behavior of Ordered CIGS Nanowire Arrays for Application in Solar Cells
2010
In this work, we report some preliminary results concerning the fabrication of quaternary copper, indium, gallium, and selenium CIGS nanowires that were grown inside the channels of an anodic alumina membrane by one-step potentiostatic deposition at different applied potentials and room temperature. A tunable nanowire composition was achieved through a manipulation of the applied potential and electrolyte composition. X-ray diffraction analysis showed that nanowires, whose chemical composition was determined by energy-dispersive spectroscopy analysis, were amorphous. A composition of Cu0.203In0.153Ga0.131Se0.513, very close to the stoichiometric value, was obtained. These nanostructures wer…
Magnetic properties of AgLnSe2 compounds (Ln=Ho, Er, Tm and Yb)
2001
Abstract The heavy lanthanide selenides AgLnSe2 (Ln=Ho–Yb) crystallize in the orthorhombic AgErSe2 type structure (P212121). The lanthanide ions are placed in the centres of slightly distorted octahedra, whereas each of the silver ions is surrounded by four selenide ions forming a strongly distorted tetrahedron. The high field magnetization (up to 14 T) and the magnetic susceptibility were measured on the polycrystalline samples. The crystal field parameters were estimated from the field dependences of the magnetizations, assuming a rhombic distortion of LnSe6 octahedra. The magnetic susceptibilities were also calculated using the same set of the crystal field parameters. None of the compou…
Graded Carrier Concentration Absorber Profile for High Efficiency CIGS Solar Cells
2015
We demonstrate an innovative CIGS-based solar cells model with a graded doping concentration absorber profile, capable of achieving high efficiency values. In detail, we start with an in-depth discussion concerning the parametrical study of conventional CIGS solar cells structures. We have used the wxAMPS software in order to numerically simulate cell electrical behaviour. By means of simulations, we have studied the variation of relevant physical and chemical parameters-characteristic of such devices-with changing energy gap and doping density of the absorber layer. Our results show that, in uniform CIGS cell, the efficiency, the open circuit voltage, and short circuit current heavily depe…
Optical and photovoltaic properties of indium selenide thin films prepared by van der Waals epitaxy
2001
Indium selenide thin films have been grown on p-type gallium selenide single crystal substrates by van der Waals epitaxy. The use of two crucibles in the growth process has resulted in indium selenide films with physical properties closer to these of bulk indium selenide than those prepared by other techniques. The optical properties of the films have been studied by electroabsorption measurements. The band gap and its temperature dependence are very close to those of indium selenide single crystals. The width of the fundamental transition, even if larger than that of the pure single crystal material, decreases monotonously with temperature. Exciton peaks are not observed even at low temper…
Temperature dependence of refractive index and absorption coefficient of GaSe at 633 nm
1995
Abstract Measurements of the ordinary refractive index and the absorption coefficient ( E /t] to c axis ) of gallium selenide at 633 nm, in the temperature range [20,100] °C, are reported. Useful analytical approximations obtained after a least squares fitting process are provided, as well. These results are basic for any theoretical model of nonlinear and bistable optical devices based on GaSe.
One-step electrochemical synthesis and physico-chemical characterization of CdSe nanotubes
2013
Abstract Stoichiometric CdSe nanotubes (NTs) with a length of ∼700 nm have been successfully grown by one-step electrochemical technique into anodic alumina membranes. Cyclovoltammetric method has been performed using porous anodic alumina as template electrode and an electrochemical bath containing Cd 2+ ions and SeO 2 . The as-prepared NTs have been identified as face-centred-cubic CdSe by XRD, while micro-Raman analysis reveals the typical peaks of nanostructured CdSe. The stoichiometric deposition of CdSe NTs formation is suggested by EDX analysis, with an average atomic percentage of Cd:Se of ∼0.93. Photoelectrochemical measurements reveal that CdSe NTs are photoactive materials with d…
Thickness identification of atomically thin InSe nanoflakes on SiO2/Si substrates by optical contrast analysis
2015
Abstract Single layers of chalcogenide semiconductors have demonstrated to exhibit tunable properties that can be exploited for new field-effect transistors and photonic devices. Among these semiconductors, indium selenide (InSe) is attractive for applications due to its direct bandgap in the near infrared, controllable p- and n-type doping and high chemical stability. For its fundamental study and the development of practical applications, rapid and accurate identification methods of atomically thin nanosheets are essential. Here, we employ a transfer matrix approach to numerically calculate the optical contrast between thin InSe flakes and commonly used SiO2/Si substrates, which nicely re…
Upconversion Nanoparticles for Bioimaging and Regenerative Medicine.
2016
Nanomaterials are proving useful for regenerative medicine in combination with stem cell therapy. Nanoparticles can be administrated and targeted to desired tissues or organs and subsequently, be used in non-invasive real-time visualization and tracking of cells by means of different imaging techniques, they can act as therapeutic agent nanocarriers, and can also serve as scaffolds to guide the growth of new tissue. Nanoparticles can be of different chemical nature, such as gold, iron oxide, cadmium selenide, and carbon, and have the potential to be used in regenerative medicine. However, there are still many issues to be solved, such as toxicity, stability, and resident time. Upconversion …