Search results for "Sensor"
showing 10 items of 4594 documents
A frequency-output fiber optic voltage sensor with temperature compensation for power systems
2003
Abstract We present a frequency-output fiber optic voltage sensor for power systems with temperature compensated response. The sensor employs PZT-type ceramic tubes, which are interrogated by a length of single-mode fiber coiled onto the tubes and a Mach–Zehnder interferometer. The combination of piezoelectric tubes with properties exhibiting opposite behavior to temperature changes is successfully exploited to passively compensate the temperature sensitivity of the sensor. The prototype reported here exhibits a resolution of 13 mV rms and the deviations of the sensor’s response due to temperature changes are within 1% over the temperature range between −30 and 70 °C. The device presented h…
Passive compensation of the thermal drift of magnetostriction based Q-switched fiber lasers
2009
Abstract The authors propose and demonstrate a method to compensate the thermal drift of magnetostriction based Q-switched fiber lasers, which is caused by the eddy currents induced in the Terfenol-D magnetostrictive actuators. The consequent wavelength detuning between the fiber gratings of the laser is passively compensated by the use of Monel 400 as thermal actuator of the non-modulated grating. A highly stable pulsed signal is achieved in the range of 1 Hz–5 kHz, with a wavelength detuning between gratings maintained below 10 pm. Furthermore, an optimization of the use of the pump power is proposed, utilizing part of it for simultaneously pumping a fiber optic based amplification stage.
Novel in-line fiber-optic filters and polarisers
2005
Novel in-line devices, based on a tapered fiber whose uniform waist has been metal-coated, are reported. The resonant excitation of a surface plasma mode of the metal film allows for the design of wavelength filters and polarisers
Photonic-crystal fiber-based pressure sensor for dual environment monitoring.
2014
In this paper the development of a side-hole photonic-crystal fiber (SH-PCF) pressure sensor for dual environment monitoring is reported. SH-PCF properties (phase and group birefringence, sensitivity to pressure variations) are measured and compared to simulated data. In order to probe two environments, two sections of the SH-PCF with different lengths are spliced and set in a Solc filter-like configuration. This setup allows obtaining the individual responses of the first and second fiber independently, which is useful for a space-multiplexed measurement. As the employed fiber is sensitive to pressure variations, we report the use of this configuration for dual environment pressure sensing.
<title>Optical pressure sensor based on the side-emitting optical fiber</title>
2003
Two prototype models of pressure sensors using side-scattering optic fiber as the sensitive element have been designed and experimentally assessed. The study showed that the use of 600-micron silica core side-scattering fiber resulted in 5 to 6 times higher sensitivity compared to the oridinary PCS fibers.
Development of optical WGM resonators for biosensors
2017
Whispering Gallery Mode (WGM) resonators are very sensitive to nanoparticles attaching to the surface. We simulate this process using COMSOL Wave Optics module. Our spherical WGM resonators are produced by melting a tip of an optical fiber and we measure optical Q factors in the 105 range. Molecular oxygen lines of the air in the 760 nm region are used as reference markers when looking for the shifts of the WGM resonance lines. We demonstrate WGM microresonator surface coating with a layer of ZnO nanorods as well as with polystyrene microspheres. Coatings produce increased contact surface. Additional layer of antigens/antibodies will be coated to make high-specificity biosensors.
Experiments with a fiber-based optical dipole trap for cold Cs-Atoms
2011
Pulling a standard optical fiber to a diameter of less than the wavelength of the guided light causes the light field to project slightly over the fiber boundaries in form of an evanescent wave. The latter can be used for light-matter-interactions in the vicinity of the surface of the fiber and therefore allows to perform quantum optic experiments.
Raman based distributed fiber optic temperature sensors for structural health monitoring in radiation environment
2015
Raman distributed temperature sensor (RDTS) measurements were performed during γ-radiation on three different classes of standard multimode fibers (pure, Ge-doped and F-doped). The sensor response is affected by the radiation induced attenuation phenomena leading to errors in the temperature measurements. The amplitude of this error strongly depends on the fiber type and the irradiation conditions. These results are promising in view of the integration of these RDTS into the deep geological repository for radioactive waste.
<title>Optical fiber loop sensors</title>
2003
Article presents prepared and tested constructions of loop hybrid fiber optical sensors with light amplitude modulation used for measuring loads and temperature.
Infrared monitoring of underground CO2 storage using chalcogenide glass fibers
2009
International audience; An optical-fiber-based system suitable for monitoring the presence of carbon dioxide, so-called "greenhouse gas", is investigated. Since each pollutant gas shows a characteristic optical absorption spectrum in the mid-infrared (mid-IR), it is possible to detect selectively and quantitatively the presence of gases in a given environment by analysing mid-IR spectra. The main infrared signature of carbon dioxide gas is a double absorption peak located at 4.2 μm. Chalcogenide optical fibers, which can transmit light in the 1-6 μm range, are well-adapted for CO2 analysis. In this wavelength range, they show attenuation losses that compare favourably with other types of fi…