Search results for "Sieve"

The Synthesis of Spherical Mesoporous Molecular Sieves MCM-48 with Heteroatoms Incorporated into the Silica Framework

1999

Monte Carlo calculation of dose rate distributions around 0.5 and 0.6 mm in diameter 192Ir wires

1999

Monte Carlo simulations of absolute dose rate in liquid water are presented in the form of away-along tables for 1 and 5 cm 192 Ir wires of 0.5 and 0.6 mm diameter. Simulated absolute dose rate values can be used as benchmark data to verify the calculation results of treatment planning systems or directly as input data for treatment planning. Best fit value of an attenuation coefficient suitable for use in Sievert integral-type calculations has been derived based on Monte Carlo simulation results. For the treatment planning systems that are based on the TG43 formalism we have also computed the required dosimetry parameters.

A monte carlo study of dose rate distribution around the specially asymmetric CSM3-a 137Cs source.

2001

The CSM3 137Cs type stainless-steel encapsulated source is widely used in manually afterloaded low dose rate brachytherapy. A specially asymmetric source, CSM3-a, has been designed by CIS Bio International (France) substituting the eyelet side seed with an inactive material in the CSM3 source. This modification has been done in order to allow a uniform dose level over the upper vaginal surface when this `linear' source is inserted at the top of the dome vaginal applicators. In this study the Monte Carlo GEANT3 simulation code, incorporating the source geometry in detail, was used to investigate the dosimetric characteristics of this special CSM3-a 137Cs brachytherapy source. The absolute do…

The synthesis of micrometer- and submicrometer-size spheres of ordered mesoporous oxide MCM-41

1997

Fractal photon sieve

2006

A novel focusing structure with fractal properties is presented. It is a photon sieve in which the pinholes are appropriately distributed over the zones of a fractal zone plate. The focusing properties of the fractal photon sieve are analyzed. The good performance of our proposal is demonstrated experimentally with a series of images obtained under white light illumination. It is shown that compared with a conventional photon sieve, the fractal photon sieve exhibits an extended depth of field and a reduced chromatic aberration.

Pore structural characteristics, size exclusion properties and column performance of two mesoporous amorphous silicas and their pseudomorphically tra…

2007

Highly ordered mesoporous silicas such as, mobile composition of matter, MCM-41, MCM-48, and the SBA-types of materials have helped to a large extent to understand the formation mechanisms of the pore structure of adsorbents and to improve the methods of pore structural characterization. It still remains an open question whether the high order, the regularity of the pore system, and the narrow pore size distribution of the materials will lead to a substantial benefit when these materials are employed in liquid phase separation processes. MCM-41 type 10 microm beads are synthesized following the route of pseudomorphic transformation of highly porous amorphous silicas. Highly porous silicas a…

Colloidal zeolites and zeolite membranes

2002

The synthesis of zeolite membranes and thin films using the secondary growth process is briefly described. In this process colloidal zeolite particles (sols) are prepared hydrothermally and then subsequently deposited on substrates to produce uniform layers of controlled thickness. In order to optimise this process, an understanding of the nature of the sols and an insight into the structure of the consolidated layer so formed, is required. Such studies are illustrated here with silicalite and zeolite A. The formation and growth of silicalite sols has been investigated in situ by small angle neutron scattering (SANS). SANS measurements on sols at progressively higher concentrations have pro…

The Influence of The Degree of Grinding to Obtain of Some Fermented Mashes Based on Whole Wheat and Husked Millet

2011

The purpose of this article was to study the influence of degree of milling whole wheat (was ground in 4 variants of grain) and husked millet (was finely ground) to obtain fermented mashes type Braga. There have been 4 mashes of grist of whole wheat, grist husked millet, hop pellets and water and were boiled under continuous stirring and then cooled. Their content has diluted with water and then strainer by pressed through a sieve. Each mash-filtrate has divided in two and added white sugar 7%, resulting two series of sweet mashes. One has inoculated with a mixed culture of yeast and lactic bacteria and the other only with yeast culture. After fermentation were analyzed fermented mashes (pH…

Isomerization and disproportionation of m-xylene in a zeolite with 9- and 10-membered ring pores: Molecular dynamics and catalytic studies

2006

The unique pore topology of zeolite ITQ-13 with 9-membered ring (MR) channels intersected by perpendicular 10-MR channels and larger void space with 10-MR cross-sections was studied for meta-xylene isomerization and disproportionation. Product distribution was interpreted on the basis of pore topology and compared with zeolites with 12-MR (β), 10-MR, and intersecting 12-MR cavities (NU-87), as well as 10-MR (ZSM-5) zeolites. The presence of cavities allows more space for bulky intermediates and/or products and also provides room for molecules to drive consecutive reactions toward thermodynamic equilibrium. Channels, on the other hand, allow diffusion without trapping if their free diameters…

Decalin and Tetralin as Probe Molecules for Cracking and Hydrotreating the Light Cycle Oil

2001

Abstract Cracking of tetralin and decalin was carried out over several zeolites to establish the effect of the pore topology of the catalyst on product distribution. These molecules were chosen as probe molecules, because they indicate which catalyst is the best for cracking or hydrotreating the light cycle oil (LCO) fraction, which is obtained directly from fluid catalytic cracking units. A set of zeolites with medium-sized (ZSM-5, MCM-22, ITQ-2), large (USY, Beta), and ultralarge pores (UTD-1), as well as a mesoporous MCM-41, were used as catalysts at 723 K. The results demonstrate that pore size and topology have a strong influence on diffusion, and consequently, on activity and selectiv…