Search results for "Solar Cell"
showing 10 items of 410 documents
Empowering Photovoltaics with Smart Light Management Technologies
2021
The daily Sun supplies the continents of the Earth with four times more energy than humanity consumes in a year. This enormous potential of solar energy to generate clean energy is therefore driving great efforts to replace conventional and unsustainable fossil fuel consumption that damages our climate and our environment. Solar photovoltaic (PV) is emerging as the fastest growing renewable energy technology in the world, yet its share to the electricity production currently is less than 3%. While coal and gas remain key to electricity production, the climate crisis demands a fast transition to a carbon-neutral energy system. In the year 2019, the PV industry produced solar panels with a ca…
Acid versus base peptization of mesoporous nanocrystalline TiO2 films: functional studies in dye sensitized solar cells
2005
We report an analysis of the influence of acid/base conditions employed in the synthesis of TiO2 nanoparticles upon the performance of dye sensitised photoelectrochemical solar cells fabricated from these particles. The functional properties of the TiO2 nanoparticles in these devices are investigated by potential step chronoamperometry, transient laser spectroscopy, and photovoltaic device characterisation. We find that base peptization conditions employed in the sol–gel fabrication of the TiO2 nanoparticles result in a reduction in film electron density under negative applied bias, correlated with slower interfacial recombination losses and a higher device open circuit voltage.
Sensitizer exchange dynamics in air and solvent filled semiconductor nanocavities
2010
Multiple dye binding sites and their exchange in equilibrium in air and solvent filled sensitized titanium oxide nanocavities were identified by 2DIR spectroscopy. Binding geometry and flexibility may influence electron injection efficiency of solar cells.
PV effect of fullerene/poly(3-hexylthiophene) blend sensitized by phthalocyanine having infrared absorption CT band
2008
An attempt was made to extend the photosensitivity spectral range of fullerene/poly(3-hexylthiophene) blend to NIR region by adding extra electron donor — hydroxygallium phthalocyanine (GaOHPc) with a strong and wide intermolecular charge transfer (CT) band around 830 nm. Multilayer cells of ITO/PEDOT: PSS/6 GaOHPc/P3HT: C61(CO2Et)2 have been prepared by spin coating with vacuum evaporated Al or In top electrodes. Significant photosensitivity of the cells was in 370–900 nm spectral range. However charge carrier photogeneration efficiency was 3 times higher for illumination in P3HT absorption band as compared with the GaOHPc CT band at 830 nm. But when GaOHPc was mixed in the blend forming P…
Analysis of Transition Metal Oxides based Heterojunction Solar Cells with S-shaped J-V curves
2020
The use of transition metal oxides for the selective carrier contact in the crystalline silicon solar cells technology is rising to interest for the excellent optoelectrical properties of these materials whose implementation, however, can result in lousy performing cells due to an S-shaped electrical characteristic. In this paper, we fabricated solar cells showing S-shaped J-V curve and carried out an analysis of the reasons of such behavior using a model involving the series of a standard cell equivalent circuit with a Schottky junction in order to explain these atypical performances. A good matching between the experimental measurements and the adopted theoretical model was obtained. The …
Consistent device simulation model describing perovskite solar cells in steady-state, transient, and frequency domain
2019
This document is the Accepted Manuscript version of a Published Work that appeared in final form in ACS Applied Materials & Interfaces, copyright © American Chemical Society after peer review and technical editing by the publisher. To access the final edited and published work see https://pubs.acs.org/doi/10.1021/acsami.9b04991
Bulky, Dendronized Iridium Complexes and their Photoluminescence
2019
Solution-processed blue emitters are essential for low-cost organic light-emitting diodes (OLEDs) but still face challenges due to their poor color purity, low efficiency and limited operational stability. Herein, by extending the conjugation of ultraviolet-emissive, facial tris(diphenylbenzimidazolyl)iridium (Ir) (fac-(dpbic)3Ir), we introduce two new types of solution-processed emitters, i.e. triisopropylsilylethynyl(TIPSE)-substituted fac-(dpbic)3Ir (2) and fac-(dpbic)3Ir-based polyphenylene dendrimers D1 and D2. The emissions of Ir-complex 2 and the dendrimers were successfully pushed toward a pure and sky blue color, respectively, due to the dominant 3π–π* nature of their emissive exci…
3D photonic crystal intermediate reflector for micromorph thin-film tandem solar cell
2008
The concept of 3D photonic intermediate reflectors for micromorph silicon tandem solar cells has been investigated. In thin-film silicon tandem solar cells consisting of amorphous and microcrystalline silicon with two junctions of a-Si/μc-Si, efficiency enhancements can be achieved by increasing the current density in the a-Si top cell. It is one goal to provide an optimized current matching at high current densities. For an ideal photon-management between top and bottom cell, a spectrally selective intermediate reflective layer (IRL) is necessary, which is less dependent of the angle of incidence than state-of-the-art thickness dependent massive interlayers. The design, preparation and cha…
Analytical Modeling of the Maximum Power Point with Series Resistance
2021
This paper presents new analytical expressions for the maximum power point voltage, current, and power that have an explicit dependence on the series resistance. An explicit expression that relates the series resistance to well-known solar cell parameters was also derived. The range of the validity of the model, as well as the mathematical assumptions taken to derive it are explained and discussed. To test the accuracy of the derived model, a numerical single-diode model with solar cell parameters whose values can be found in the latest installment of the solar cell efficiency tables was used. The accuracy of the derived model was found to increase with increasing bandgap and to decrease wi…
Fabrication of CZTSe/CIGS Nanowire Arrays by One-Step Electrodeposition for Solar-Cell Application
2021
The paper reports some preliminary results concerning the manufacturing process of CuZnSnSe (CZTSe) and CuInGaSe (CIGS) nanowire arrays obtained by one-step electrodeposition for p-n junction fabrication. CZTSe nanowires were obtained through electrodeposition in a polycarbonate membrane by applying a rectangular pulsed current, while their morphology was optimized by appropriately setting the potential and the electrolyte composition. The electrochemical parameters, including pH and composition of the solution, were optimized to obtain a mechanically stable array of nanowires. The samples were characterized by scanning electron microscopy, Raman spectroscopy, and energy-dispersion spectros…